Question
Expert Solution
This question has been solved!
Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.
Step by stepSolved in 4 steps with 4 images
Knowledge Booster
Similar questions
- Answer correlty in terms of kg ..........>>>arrow_forwardrough surfice Smooth Swace feed 2.50m he 3.00m E; Ei + WNc m A 34.2 kg block slides with a velocity of 10.22 m/s to the right on a frictionless surface (as shown in the figure above). The block slides up a slope to a height of 3.00 m and then slides across a 2.50 m long rough surface with a coefficient of kinetic friction equal to 0.325. The block continues to travel to the right and bumps into a massless spring with a spring constant (k) equal to 2320 N/m. a) How much does the spring get compressed by the block with respect to its equilibrium length? Please answer with a positive number in units of metres, with 3 sig figs. Start with conservation of energy: Er = Ei + WNC , and show all steps. b) What is the potential energy stored by the spring when the mass comes to a stop? Please show the symbolic equation and then “plug in the numbers" to give a numerical answer in units of joules with 3 sig figs. c) What happens to the potential energy stored in the spring after the block stops…arrow_forwardQ9a. For the beam below, the point loads and distances are as follows: F1 = 11. 25 kN, F2 = 11.25 kN and F3 = 4.50 kN L1 = 2.25 m, L2 = 4.50 m, L3 = 4.50 m and L4 = 2.25 m Determine the reaction RA. Give your answer in kilonewtons (kN) to two decimal places. F1 F2 F3 B L2 L3 L4 L1 D. RB RAarrow_forward
- A block of mass m = 1.34 kg (Block 1) at rest at Point A on an arc of smooth circular surface of radius L = 30 m. Another block of mass M = 3.22 kg (Block 2) is at the bottom of the arc as shown in Fig.6. The line between the center of the arc and Point A and the line between the center of the arc and Point B make an angle 0 = 35 deg. If Block 1 is released and slides on the arc and hits Block 2, Block 1 stops at Point B and Block 2 starts to move along the arc. What is the velocity of Block B right after the collision in m/s. Keep three significant figures for the answer. g= 9.80 m/s. There is no friction.arrow_forwarda. Calculate the force (in N) needed to bring a 950 kg car to rest from a speed of 80.0 km/h in a distance of 110 m (a fairly typical distance for a non-panic stop). b. Suppose instead the car hits a concrete abutment at full speed and is brought to a stop in 2.00 m. Calculate the force exerted on the car and compare it with the force found in part (a). force in (b)/force in (a)=arrow_forward1. Boxing gloves are padded to lessen the force of a blow. The glove and face compress 7.50 cm during a blow in which the 7.00-kg arm and glove are brought to rest from an initial speed of 10.0 m/s. Think & Prepare 1. Make note of what's given and what's unknown. Relate known quantities to symbols. 2. Draw a labeled sketch if possible. 3. Identify the physics principle and approach. Write down relevant equations symbolically. Simplify if possible. 4. Insert numerical quantities to solve for unknowns. 5. Does the answer make sense? (a) Calculate the change in kinetic energy of the glove and arm. Enter to 3 significant figures AKE= Note: AKE = KE final-KE initial (b) Where does this energy go? J into doing work against the force exerted by the face against the glove into doing work against gravity into the potential energy of the face O into the potential energy of the glove and arm (c) Calculate the force exerted on the boxing glove by the opponent's face. Consider the relative…arrow_forward
- rough surfice Smath swace leeeeed 2.50m he 3.00m E; Ei + WNc A 34.2 kg block slides with a velocity of 10.22 m/s to the right on a frictionless surface (as shown in the figure above). The block slides up a slope to a height of 3.00 m and then slides across a 2.50 m long rough surface with a coefficient of kinetic friction equal to 0.325. The block continues to travel to the right and bumps into a massless spring with a spring constant (k) equal to 2320 N/m. a) How much does the spring get compressed by the block with respect to its equilibrium length? Please answer with a positive number in units of metres, with 3 sig figs. Start with conservation of energy: E, = E; + WNC , and show all steps. b) What is the potential energy stored by the spring when the mass comes to a stop? Please show the symbolic equation and then "plug in the numbers" to give a numerical answer in units of joules with 3 sig figs. c) What happens to the potential energy stored in the spring after the block stops…arrow_forwardPls help ASAP. Pls show all work, steps and calculations please.arrow_forward
arrow_back_ios
arrow_forward_ios