Answered: Calculate the stress in Mpa at the top…

Calculate the stress in Mpa at the top and bottom experienced by the beam shown in the fixed end if the initial prestress force is 800 kN with 15% losses.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

3) The overhanging beam supports the loads as shown in the figure. Determine the maximum shear stress in the beam 60 kN/m 20 kN/m 0.1m 0.3m B .C 3m 2m 2m D 0.25m
For the beam with the given section and subjected to the loading shown below, determine the maximum axial stress. 10 kN 3 kN/m 100 mm 200 mm 15 m 1.5 m 2.2 m
A simply supported rectangular beam of length 6.45m has a width of 437.5 and an effective depth of 692.5. The beam is to be reinforced using 12 ?? bars. The beam supports service dead loads of 31 kN/m and 39.5kN/m., respectively. 1. Calculate the ultimate moment capacity of the beam. 2. Calculate the height of the equivalent stress block. 3. Determine the number of bars required for this beam
Determine the bending stress (in Pa) at the top of the beam at point C for the beam shown belowif P = 1531 N, T = 4945 Nm, a = 0.87 m, b = 1.05 m, c = 0.77 m, w = 32 mm, and h = 77 mm .
6.3 Design the beam below using the operating stresses method If the uniformly spread load is n= 10 20 km section width b = 300mm, permissible stresses 140MPa, c=10MPa = ignore the weight of the beam. W-20 kN/m 4m
Determine the maximum compressive stress in the beam which is subjected to the 20-kN/m uniformly distributed load over half of its length. A 20 kN/m 2 m 2 m B so 60° 180 mm 120 mm 160 mm 200 mn
For the beam and loading shown, determine the maximum normal stress due to bending on a transverse section at C.
A large uniform plate containing a rivet hole is subjected to uniform uniaxial tension of 50MPa. Where its diameter is 2 cm and width 5cm. Find maximum stress in the plate.
The prestress T-beam section has a simple span of 6 m. The tendons is subjected to initial stress of 900 MPa with an area of 800 mm. Assuming a loss of stress of 18%. no tension will be acting at the bottom and maximum stress of 9.5 MPa at the top should not exceed. a) Determine the stress at the bottom due to the final prestressing force alone. b) Determine the safe moment that the beam could carry based on the allowable stresses. (kN- m) c) Determine the sate uniform live load that the beam could carry if the unit weight of concrete 24 kN/m°. (N/m) d) Determine the stress at the top due to the final prestressing force alone. (MPa)
10 kN PROBLEM 5.16 3 kN/m 100 mm For the beam and loading shown, determine the maximum normal 200 mm stress due to bending on a transverse section at C. 1.5 m 1.5 m 22 m
25 mm 0.5 m 200 mm 100 mm 100 kN -1.5m 25 mm 150 mm 25 mm 100 kN 0.5 m PROBLEM 4.10 Two vertical forces are applied to a beam of the cross section shown. Determine the maximum tensile and compressive stresses in portion BC of the beam.