Calculate the rate of heat conduction out of the human body, assuming that the core internal temperature is 37°C, the, the skin temperature is 35°C, thickness of the tissues between averages 1 cm, and the surface area is 1.6 m². Assume thermal conductivity of the tissue is 0.2 W/m/K) ○ A. 46.0 W O B. 96.4 W ○ C. 64 W ○ D. It cannot be calculated as the type of dress worn is unknown. ○ E. -90 W

Calculate the rate of heat conduction out of the human body, assuming that the core internal temperature is 37°C, the, the skin temperature is 35°C, thickness of the tissues between averages 1 cm, and the surface area is 1.6 m². Assume thermal conductivity of the tissue is 0.2 W/m/K) ○ A. 46.0 W O B. 96.4 W ○ C. 64 W ○ D. It cannot be calculated as the type of dress worn is unknown. ○ E. -90 W

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter14: Heat And Heat Transfer Methods

Section: Chapter Questions

Problem 32PE: Calculate the rate of heat conduction out of the human body, assuming that the core internal...

See similar textbooks

Similar questions

(a) If the partial pressure of water vapor is 8.05 torr, what is the dew point? (760 torr = I atm 101, 325 Pa) (b) On a warn day when the air temperature is 35 and the dew point is 25 , what are the partial of the water in the air and the relative humidity?
For the human body, what is the rate of heat transfer by conduction through the body's tissue with the following conditions: the tissue thickness is 3.00 cm, the difference in temperature is 2.00 , and the skin area is 1.50 m2. How does this compare with the average heat transfer rate to the body resulting from an energy intake of about 2400 kcal per day? (No exercise is included.)
The thermal conductivities of human tissues vary greatly. Fat and skin have conductivities of about 0.20 W/m K and 0.020 W/m K, respectively, while other tissues inside the body have conductivities of about 0.50 W/m K. Assume that between the core region of the body and the skin sin face lies a skin layer of 1.0 mm, fat layer of 0.50 cm, and 3.2 cm of other tissues. (a) Find the R-factor for each of these layers, and the equivalent R-factor for all layers taken together, retaining two digits. (b) Find the rate of energy loss when the core temperature is 37C and the exterior temperature is 0C. Assume that both a protective layer of clothing and an insulating layer of unmoving air a absent, and a body area of 2.0 m2.
A construction worker uses a steel tape to measure the length of an aluminum support column. If the measured length is 18.700 m when the temperature is 21.2C, what is the measured length when the temperature rises to 29.4C? Note: Dont neglect the expansion of the tape.
(a) Find the density in SI units of air at a pressure of 1.00 atm and a temperature of 20 , assuming that air is 78% N2, 21% O2, and 1% Ar, (b) Find the density of the atmosphere on Venus, assuming that it's 96% CO2 and 4% N2, with a temperature of 737 K and a pressure of 92.0 atm.
What is me Fahrenheit temperature of a person with at 39.0°C fever?
(a) The number of kilocalories in food is determined by calorimetry techniques in which the food is burned and the amount of heat transfer is measured. How many kilocalories per gram ale there in a 5.00-g peanut if the energy from burning it is transferred to 0. 500 kg of water held in a 0.100-kg aluminum cup, causing a 54.9- temperature increase? Assume the process takes place in an ideal calorimeter, in other words a perfectly insulated container. (b) Compare your answer to the following labeling information found on a package of dry roasted peanuts: a sewing of 33 g contains 200 calories. Comment on whether the values are consistent.
In 1986, a gargantuan iceberg broke away from the Ross Ice Shelf in Antarctica. It was approximately a rectangle 160 km long, 40.0 km wide, and 250 m thick. (a) What is the mass of this iceberg, given that the density of ice is 917kg/m3 ? (b) How much heat transfer (in joules) is needed to melt it? (c) How many years would it take sunlight alone to melt ice this thick, if the ice absorbs an average of 100W/m2, 12.00 h per day?
An astronaut performing an extra-vehicular activity (space walk) shaded from the Sun is wearing a spacesuit that can be approximated as perfectly white ( e=0 ) except for a 5 cm × 8 cm patch in the form of the astronaut's national flag. The patch has emissivity 0.300. The spacesuit under the patch is 0.500 cm thick, with a thermal conductivity k 0.0600 W/m , and its inner surface is at a temperature of 20.0 . What is the temperature of the patch, and what is the rate of heat loss through it? Assume the patch is so thin that its outer surface is at the same temperature as the outer surface of the spacesuit under it. Also assume the temperature of outer space is 0 K. You will get an equation that is very hand to solve in closed form, so can solve it numerically with a graphing calculator, with software, or even by trial and error with a calculator.
Compare the rate of heat conduction through a 13.0-cm-thick wall that has an area of 10.0 m2 and a thermal conductivity that of glass wool with the rate of heat conduction through a 0.750-cm-thick window that has an area of 2.00 m2, assuming the same temperature difference across each.
One easy way to reduce heating (and cooling) costs is to add extra insulation in the attic of a house. Suppose a single-story cubical house already had 15 cm of fiberglass insulation in the attic and in all the exterior surfaces. If you added an extra 8.0 cm of fiberglass to the attic, by what percentage would the heating cost of the house drop? Take the house to have dimensions 10 m by 15 m by 3.0 m. Ignore air infiltration and heat loss through windows and doors, and assume that the interior is uniformly at one temperature and the exterior is uniformly at another.
An aluminum rod 0.500 m in length and with a cross sectional area of 2.50 cm2 is inserted into a thermally insulated vessel containing liquid helium at 4.20 K. The rod is initially at 3(H) K. (a) If one-halt of the rod is inserted into the helium, how many liters of helium boil off by the time the inserted half cools to 4.20 K? Assume the upper half does not yet cool, (b) If the circular surface of the upper end of the rod is maintained at 300 K. what is the approximate boil-off rate of liquid helium in liters per second after the lower half has reached 4.20 K? (Aluminum has thermal conductivity of 3 100 YV/m K at 4.20 K; ignore its temperature variation. The density of liquid helium is 125 kg/m3.)