Answered: Calculate the percentage efficiency of…

Calculate the percentage efficiency of a solar PV module whose length is 136 cm and width is 106 cm and produces 233 W maximum power when exposed to 1115 W/m2 solar irradiance?

Chemistry In Focus

7th Edition

ISBN:9781337399692

Author:Tro, Nivaldo J.

Publisher:Tro, Nivaldo J.

Chapter10: Energy For Tomorrow: Solar And Other Renewable Energy Sources

Section: Chapter Questions

Problem 10.1YT

See similar textbooks

Related questions

Q: 2884 2960 1435 670 3386 1090 4D00 3000 2000 15 DO 1000 SDO NAVENUMB ERI - TRANSMITTANCEI 21

A: The question is based on the concept of IR spectroscopy. We have to determine possible functional…

Q: The Bjerrum length (IB) is a comparative measure of electrostatic and thermal energy. Select all…

Q: Given: Open water source Net radiation = 300 W/m2 Air temperature = 25 °C Density of water = 997…

Q: A dead body was found within a closed room of a house where the temperature was a constant 70° F. At…

A: GIVEN Room temperature (ta)=70oF Initial core temperature(t0) = 98.60 F

Q: 1. A compound has a molar absorptivity of 3.031 x 103 L cm-1 mol1. If a 15.00 mm-length cell is used…

A: We know that A = 2 - log(%T) and A = € × C × l

Q: 4. If a monolayer of N2 molecules is 0.03075 mole per one gram of activated carbon, and the surface…

Q: Write down three possible applications of the analytical ultracentrifuge

A: Analytical ultracentrifugation (AUC) is a versatile and powerful method for the quantitative…

Q: II. a. Given that V= J/A-s and 1 Kwh = 3.6 x10€ J, what does it cost to operate a window-type air…

A: Answers are explained below.

Q: Given the following balanced reactions: P205 + 9H20 → 2PO43 + 6H30* 2PO43- + 6Ag* → 2Ag3PO4(s) Ag* +…

A: Balancing a chemical equation is necessary so as to abide by the law of conservation of mass and to…

Q: Code: COFFEE. A single-core cable has a conductor diameter of 13.5 mm and insulation thickness of…

A: Given :- ρ = 7.5 × 108 megaohm-cm = 7.5 × 106 megaohm-m length = 1/4 km = 250 m conductor diameter…

Q: p percent transmittance:

Q: Does the amount of radiation (cpm) increase or decrease as the thickness of the shielding increases…

A: Given information, The distance between the source and the sensor stays the same

Q: The paints and varnishes that used on fishing boats can be degraded by solar radiation through…

Q: The main components of a stand-alone solar PV system are O a. PV panel, inverter, battery, charge…

A: A detached or Stand Alone PV System is comprised of various individual photovoltaic modules (or…

Q: (4) The normal melting point of gold is 1064.5 °C and its boiling point is 2660 °C. (a) Convert…

A: Hey, since there are multiple questions posted, we will answer first question. If you want any…

Q: Consider the balanced reaction 8 A + 7 B -> 3 C + 9 D. if 3.084 moles of A( MW=38.11) are…

A: Given 8A + 7B → 3C + 9D Number of mole of A = 3.084 mole Number of mole of D = ?

Q: AvapH dT T(Vg – Vi) AvapH _ AvapH _ AvapH TV, dP - P RT2 RT T P Rewrite this equation after…

A: The equation given is,

Q: Calculate the value of Kc 2ClO3- + 12H+ +10e-←→Cl2 + 6H2O: E= +1.52 volt S2O82-+ 2e-←→ 2SO42-:…

Q: 125 120 115 110 105 100 95 30 4000 3500 3000 2500 2000 1500 1000 %Transmittance 3853.91 3838.77…

A: The question is based on the concept of IR Spectroscopy. we have to assign peaks to different bonds.

Q: Calculate the current density if the drift velocity equals 8 x 10 m/s, conductivity of 72 megaS per…

Q: 1. A certain type of PVC tubing costs $1.79 per foot. What length of tubing can you buy with $50.12?

Q: Enter your answer in the provided box. For similar light intensity, compact fluorescent bulbs use…

A: Dollars that will be saved = $28.125

Q: What is the ideal pressure reading (in psia) for a dead weight tester if a 0.25-lb mass is placed in…

Q: List and describe all advantages of XRF and NAA techniques

A: Advantages of X-RAY FLUORESCENCE An X-ray fluorescence (XRF) spectrometer is an x-ray metallic,…

Q: S.P. Is an 18 month old child who weighs 20 pounds. He has atrial fibrillation and is being treated…

A: Since the total dose of digoxin is 0.006 mg/Kg/day And the child is receiving the dose two times in…

Q: 1500 1003 <-2965 2014 8 1130 1452 1379 727 % TRANSMITTANCE 9 3283 1327 10 1108 1047 9821

A: IR mainly used to determine the functional group that are present in a molecule

Q: The total rate at which power is used by humans worldwideis approximately 15 TW (terawatts). The…

Q: 20) An x-ray machine operating at 80 kVp for 100 mAs with 1 mm Al added filtration produces an…

A: It is given that the X-ray mechine operating at 80 kVp for 100 mAs with 1 mm Al added filtration.…

Q: Explain the effects of excess amount of anticoagulant in PVC result.

A: Answer - Anticoagulant - Anticoagulants, commonly known as blood thinners, are chemical substances…

Q: The concentration of Na in plant materials are determined by flame atomic emission. The material to…

A: Step 1. Plot Emission vs Concertation graph Plot Emission (Y-axis) vs Concertation (X-axis) graph…

Q: The main losses of the energy conversion of solar cells are: 1. The reflection at the front surface…

A: Solar cell is an electrical device which converts the light energy into electrical energy. The…

Q: In a town (before 1950) where high amounts of PVC products were manufactured, many people in the…

A: The Environmental Protection office (EPA) is an autonomous leader organization of the United States…

Q: Rencia- Fall19- PALENCIA Activities and Due Dates> HW 15 Hint Che Resources 985/2200 core: of 22>…

A: Given,250 ml of 0.4 M of sucrose.

Q: A steel ball of density 12.45 g/mL and 2 mm diameter requires 30 sec to fall a distance of 1 meter…

Q: 3p E 3s AV AV AV 2p 2s 1s The lowest E levels are already filled in for you.

Q: Does frequency factor vary with time

A: Frequency factor is also known as pre-exponential factor. Which is very important part of Arrhenius…

Q: Consider solid and liquid samples of equal mass and heat capacity If microwaves are fired at both…

Q: The atomic hydrogen exists in space at an estimated concentration of one particle per cubic meter.…

Q: What are slow-burning characteristics?

A: Three important characteristics:- 1. Low-temperature. 2. Flameless form of combustion. 3. Sustained…

Q: The molar absorptivity for aqueous solutions of phenol at 211 nm is 6.17 x 103 L cm' mol-'.…

Q: Items 1 to 5: What is the log10 MW of the following bands? 1. Band 2 А. 0.943 B. 0.963 C. 0.973 D.…

A: 1) log10 MW of band 2 Correct option is C log (9.40) = 0.973 2) log10 MW of band 4 Correct…

Q: What information can be obtained from UV-vis Spectra and how this can be applied in COSMETIC SCIENCE

A: In UV- Vis spectroscopy we plot the curve Concentration Vs wavelength. A perticular compound shows…

Q: 5. How do you calculate the Numerical aperture of an Optic fiber? Find the numerical aperture '0' of…

Q: A corpse discovered in the desert at 5:00 PM was found to have larvae from the blow fly species…

Q: An exposure risk assessment considers the MSDS hazard conditions of: a.physical state b. chemical…

A: MSDS stands for material safety data sheet. There are various things mentioned in this sheet.

Q: What is the frequency of the xray with a wavelength of 1.0 x 10 to the negative 10th poer

A: We know that, the relation between frequency and wavelength can be expressed as,…

Q: Name the disadvantages and advantages of MSPE.

A: The first use of magnetic solid-phase extraction (MSPE) in analytical chemistry was published in…

Question

Calculate the percentage efficiency of a solar PV module whose length is 136 cm and width is 106 cm and produces 233 W maximum power when exposed to 1115 W/m² solar irradiance?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

The total power used by humans worldwide is approximately 15 TW (terawatts). Sunlight striking Earth provides 1.336 kW per square meter (assuming no clouds). The surface area of Earth is approximately 197,000,000 square miles. How much of Earth's surface would we need to cover with solar energy collectors to power the planet for use by all humans? Assume that the solar energy collectors can only convert 10 % of the available sunlight into useful power.
Which renewable energy sources may be considered as manifestations of solar energy in different forms? Note that all correct answers, and no O Solar Ocean wave Wind Biomass Geothermal Hydro O O O
A solar car has a roof dimensions of 113cm x 104cm for solar cells . Calculate the electrical power available, assuming total energy loss of 84% and a constant light intensity of 1045 W/ m². Answer:
How can solar cells be described by at least one of the Green Chemistry principles?
Why do the perovskite solar cells be sensitive to heat, air and moisture and how do this affect its efficiency?
Home Work Compare between Photovoltaic solar panels and CSP systems in term of cost.
The total rate at which power is used by humans worldwideis approximately 15 TW (terawatts). The solar flux averagedover the sunlit half of Earth is 680 W/m2 (assumingno clouds). The area of Earth’s disc as seen from the Sun is1.28 x 1014 m2. The surface area of Earth is approximately197,000,000 square miles. How much of Earth’s surfacewould we need to cover with solar energy collectors to powerthe planet for use by all humans? Assume that the solar energycollectors can convert only 10% of the available sunlightinto useful power.
Paints and vanishes for use on exteriors of buildings must be protected from the effects of solar radiation which accelerate their degradation (photolyiss and photochemical reactions). Given that: M=500 g/mol; Emax=15,000 L/mol/cm for lambdamax=350nm. What must be the concentration (expresses in g/L) of a UV additive M such that 90% of the radiation is absorbed by a coating of thickness 0.3mm? thank u so much.
Explain why hydroelectric power and wind power are indirect forms of solar energy.
List and describe all advantages of XRF and NAA techniques
(b) How does application of microwave in chemical reactions make it 'greener'?
* Module 1: You have been linked to a version of you where you have hotdogs for fingers, fearing that Jobu Topaki is coming for your life you need to get back, and in order to get back you need to supply a specific amount of electricity to your pinky toe with a battery from a barbie playhouse. However the conversions are different here, supplied with the knowledge from Alphaverse Waymond figure out how much energy is needed to supply 12 eV to your pinky toe. How much haays is needed? (1eV=1.6x10^-19 J; 1 J = 5 aken; 1 aken = 30 haays) O2.88 x 10^-16 haays O 1.125 x 10^22 haays O 4.5 x 10^20 haays 5.0 x 1017 haays