Calculate the electric and magnetic fields produced by the radiation coming from 200W bulb at a distance of 5m. Assume that the efficiency of the bulb is 5 % and it is a point source.

Q: Find Vout

A: In this case, the output voltage of the following circuit is to be determined:

Q: A long wire with a length of 1 = 500 m and cross-section area A = 1 mm² has a resistance of 14 2. i)…

A:

Q: (+1) Vs 6Ω 3Ω 2Ω ww |.

A: Given data, Vs=5 V, Is=10 A Circuit diagram is given as,

Q: Short answer: Wavelength division multiplexing.

A: Wavelength Division Multiplexing:  Wavelength division multiplexing  is a technique of multiplexing…

Q: FIND THE TOTAL VOLTAGE OF THE CCT. 32 AMER IA 32 2.R 4/2 Le 2.2 22

A:

Q: Ex For the circuit shown below; if the input voltage is a sinusoidal wave, sinusoidal wave, find the…

A:

Q: oriented A circular loop of radius 0.0400 m is 35.0 degrees to a 0.152 T magnetic field. What is the…

A: Given data, Radius of loop r=0.0400 m Angle θ=350 Magnetic field B=0.152 T

Q: A coil of inductance 0.20H and resistance 60 ohm is connected in parallel with a 20μF capacitor…

A:

Q: Find the current in the circuit. www 20 Ω 120V I 40 92

A: Given circuit:

Q: image

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Find z-transform of the following signals. (1) x(n) = u(n) (2) x(n) = 8(n) (1) 2 (3) x(n) = u(-n)

A:

Q: How to measure voltage across a resistor? A In series with the element B) In parallel with the…

A:

Q: balanced 3-phase delta-connected load consumes a total power of 100 kW at a pf of 0.6 lag, the line…

A: Given, Load is 3 phase delta connected so, VL=Vph VL=1000V PT=100kW cosϕ=0.6 lag

Q: d-Has 10 molecuies/a x Q5: A) Derive Poisson's and Laplace's equations. B) Two infinite line…

A:

Q: A dc motor has a back emf of 110 V and an armature current of 90 A when running at 1500 rpm. Find…

A: Given: Back emf = 110V Armature Current = 90A speed = 1500rpm. The torque can be calculated by using…

Q: Delta modulation uses bits per sample. a) One b) Two c) Four d) Eight

A: The correct option along with the explanation is provided in the following section.

Q: Delta modulation uses a) One b) Two c) Four d) Eight bits per sample.

A:

Q: What is the value of Req? Req- bo 1Q 62 ,202 652 ww

A: Given circuit,

Q: a. The transfer function of a certain discrete time system is given by the expression below: H(z) =…

A:

Q: The single-phase transformer in the following figure has a voltage on the Zl load of 120 Vrms. If…

A:

Q: A 50 kVA, 500 V, single phase alternator gives 700 V on open circuit at the field current of 15 A.…

A:

Q: solve this

A: We have to find the Laplace transform of e-atcosωtLcosωt=ss2+ω2We will use the complex shift…

Q: Problem 3 The synchronous speed of a 60 Hz, three-phase induction motor is 900 rpm. What is the…

A: Given data, Three phase induction motor has f1=60 HzNs1=900 rpmf2=50 Hz

Q: 1. A galvanometer has a current sensitivity of 1uA/mm and a critical damping resistance of 1 k.…

A: Given data, Current sensitivity SI=1 μA/mm Critical damping resistance Rcd=1 kΩ

Q: LVDT produces an rms output voltage of 5.0 V for displacement of 3.5 mm. Calculate the sensitivity…

A: We have been given an LVDT transducer which produces the, Output Voltage = 5.0 V Displacement = 3.5…

Q: Determine current in 5ohm resistor by any one method. 10 V D A 8V i₁ www 202 12 V B 2002 202 www 592…

A: Given parameters: A circuit contains Outer Branch AC, Voltage source-12 V, Resistor-5 ohm Inner…

Q: (e) A 2 H inductor is known to have current i(t) (in Amperes) as given in the figure. Assuming this…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: In the circuit below, what is the value of the current I3? F 0 0.40 A 0 0.52 A 0 0.19 A ○ 1.2 A 252…

A:

Q: Determine the number of turns of the primary and the secondary windings of a 60 Hz, 240/120 V ideal…

A:

Q: 1. Consider a half-wave rectifier circuit of Fig 5 with a resistive load of 25 Nand a 60 Hz ac…

A:

Q: FIND THE LAPLACE TRANSFORM A.) f(t) =e^-2t  u(t) B. f(t) = e^3t u(t) C f(t) = 2 s(t)

A:

Q: A 380 V 50 Hz Y-connected synchronous motor has four poles. At full load, its eficiency is 94%.The…

A:

Q: The speed of a 100 MW alternator drops by 4% from no load to full load. (a) Find the speed…

A: We have an alternator with, Rating = 100 MW Speed drops from no load to full load = 4%   From this…

Q: You must design a circuit for a light emitting diode. The circuit must be powered by a 3.3V power…

A:

Q: Q.6 a) Name and explain the process to join any electrical component on strip board. b) List the…

A: 6. (a) Soldering is the technique used to connect any electrical component to a strip of circuit…

Q: 3 FIND THE TOTAL CURRENT OF THE CIT lov + зл цена Se ле 3г. 22

A:

Q: 9. An electrical series circuit with resistance, inductive and capacitive reactance is shown below.…

A: Given:

Q: 5.3 Compute V, in the circuit in Fig. E5.3 using superposition. www 3 ΚΩ Figure E5.3 12v (+) 4 ΚΩ 2…

A:

Q: a) A unity feedback system is given as in Figure Q4 a). Determine: Damping ratio i. ii. iii. The…

A: Note: We can only answer up to 3 subparts at a time, kindly repost your question for the solution of…

Q: From the y-parameters satisfying I=YV, four components are denoted by y12 = y21 = 0 ms, y11 = 2 mS,…

A: The total z parameter of the network can be obtained by converting the y parameter network into z…

Q: a current element J.dv is measured in terms of Select one: O a. A/m² O b. A.m O c. A.m² O d. A/m

A: Given data, Current element J.dV

Q: In the circuit show in Figure 3, at the temperature of room increase what happen to the resistance…

A: Given: Circuit

Q: *Find Vo in the network below.

A: The voltage across the resistor can be calculated by using the current through the mesh and that…

Q: a. Using Figure determine the minimum irradiance required to fire the device at room temperature…

A:

Q: The input of an AC circuit having power factor of 0.8 lagging is 40 kVA. The power drawn by the…

A: Given  S = 40 KVA PF = 0.8 LAG

Q: I need help with (d) . Thanks 1. Consider a half-wave rectifier circuit with a resistive load of 25…

A:

Q: Calculate the value of stored energy in an inductor if the value of inductance is 10 mH and 2 mA of…

A:

Q: A coil of inductance 0.20H and resistance 60[1] is connected in parallel with a 20μF capacitor…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Ex For the circuit shown below; if the input voltage is a sinusoidal wave, sinusoidal wave, find the…

A:

Q: 4. (a). (b). Operational amplifiers (op-amps) are used in integrated circuits for signal…

A: Given a circuit of an operational amplifier as shown below. Find State characteristic of the ideal…

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.