Calculate the absolute pressure (in psia) in the natural gas pipeline. Assume that the effect of air column in pressure is negligible and local atmospheric pressure is 5.9psia. Two decimal points Air 2 in (Natural Gas 14 in 22 in 6 in -Mercury SG = 13.6 Water

Calculate the absolute pressure (in psia) in the natural gas pipeline. Assume that the effect of air column in pressure is negligible and local atmospheric pressure is 5.9psia. Two decimal points Air 2 in (Natural Gas 14 in 22 in 6 in -Mercury SG = 13.6 Water

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter10: Force And Force-related Variables In Engineering

Section: Chapter Questions

Problem 26P: SAE 30 oil is contained in a cylinder with inside diameter of 1 in. and length of 1 ft. What is the...

See similar textbooks

Related questions

Q: A 12-m high cylindrical tank to be filled with oil having unit weight of 9.4 kN/m will be built on s...

Q: Compute the peak hour factor if the hourly volume of traffic is 1978 veh/hour and the highest 15-min...

A: Given data, Hourly volume of traffic = 1978 veh/hr Peak 15 min volume = 780 vehicle To find out th...

Q: 4. If the load P on the bean causes the end C to be displaced 10 mm downward, determine the normal s...

Q: L. 125 МPа 62.5 MPa- 62.5 MPa 125 MPa

Q: Determine the smallest moment of inertia I required for the beam shown, so that its maximum deflecti...

Q: Calculate the extra widening required for a single lane major district highway having horizontal rad...

A: 9e

Q: A rigid bar AB is hinged at A and is supported by a rod CD at C. The rod is pin connected at D, as s...

Q: The maximum allowable speed of a car that could travel a circular curve is 87 kph. If the impact fac...

Q: Calculate the extra widening required for a single lane major district highway having horizontal rad...

A: Given data, Design speed = 60 kmph Horizontal radius = 225 Vehicle wheel base = 7 m To find out the...

Q: dy 6. yz = 1, when x = 0, y = 4 + %3D dx

Q: Explain why chimneys are often designed in a truncated cone (large diameter bottom and small

A: Reason why chimneys are often designed in truncated cone shape:

Q: to identify a highway mode transportation-related problem. And, what possible

Q: AW 460x177 column section pin connected at both ends has a length of 8m. Using NSCP 2015 (LRFD) spec...

A: Answer Given data W 460 x 177 Length of column = 8 m Fy = 380 Mpa A = 22600 mm2 rmin = 68.2 mm Liv...

Q: A rigid pavement is to be used to carry a wheel load of 54.04 kN. Enough dowels will be used across ...

A: Load(W)=54.04kN Strength of concrete (f)=1.52MPa

Q: Two cylindrical rods, one of steel and the other of brass, are joined at C and restrained by rigid s...

Q: A 12m beam will be subjected to the following loads: Uniform dead load due to self weight - 25.8 kN/...

Q: The dry density of a sand with porosity of 0.387 is 1600 kg/m3. a. Calculate the void ratio of the s...

Q: Given the following data below, Compute for the stress , strain and modulus of stiffness of each sam...

Q: The probability of T=100 year to occur within the next 50 years is?

Q: distributed load, Ao, is applied at the ground surface, what is the settlement of the clay layer cau...

Q: The copper pipe shown in the figure has an outside diameter of 4.000 in. and a wall thickness of 0.3...

A: For the given copper pipe,

Q: A retaining wall with a vertical smooth back is 8 m high. It supports a cohesionless soil (y = 19 kN...

Q: How many years will be required for a given sum of money to be 5 times the principal amount, if it i...

A: The return given by the bank on the amount deposited in the bank is called the interest amount. The ...

Q: If an angle is measured with a standard deviation of ±3", then the most probable error is seconds. (...

Q: Solve with Force Method and find T2

Q: -Air 8 in Water 20 cm (2) 10 cm Q4) FIND Q in L/WEEK

Q: Find the area of the region between the curves y = x^3, y = -x, and y = 1. Round off to two decimal ...

Q: The velocity of the particle that travels along a straight line is v = (12 – 3t?)m/s, where t is in ...

Q: A rigid bar AB is hinged at A and is supported by a rod CD at C. The rod is pin connected at D, as s...

Q: Ryan and Mitch can run around a circular mile track in 6 and 10 minutes respectively. If they start ...

Q: Estimate the primary consolidation settlement of the clay.

Q: Use the force method (method of consistent distortions) to find the value of the redundant force ind...

A: We have to determine the value of redundant NDB as per the given data in the question and using the ...

Q: nd Block B has ar having a horizonta Block A and acceler

Q: Hinge it お 2L 3. (One redundant)

Q: Eight rainguage stations are installed in a catchment and they recorded rainfalls of certain magnitu...

Q: or each item. Show your solutions. Given , L= 400mm W= 2 LE APPLIED DEFLECTION STRAIN LOAD (N) STRES...

A: Sample No Applied Load Deflection Stress N/mm2 Strain Modulus of elasticity 1 3500 25 0.025 0....

Q: Problem 3 Determine the required slope of the channel bed and sides(s,) if the flow is steady and un...

Q: Block A and Block B has a mass of 25 kg and 15 kg, respectively. Both are attached to a chord having...

Q: Determine the load-carrying capacity of the 2 PL 5/16 x 3 tension member shown based on limit states...

Q: The number of accidents for 5 years recorded in a certain intersection is 5883. If the average daily...

Q: = 0.0003x². If the constant m, e the x-component of the the total force (KN).

Q: Determine the mass (kg) of the heaviest cylinder that can be supported without exceeding a stress of...

Q: compute the braking distance (in meters). if a vehicle is moving down at a speed of 83 kph along an ...

A: Slope(n) = -2% u=0.33 V=83kph

Q: Compute the maximum combined loads USING THE RECOMMENDED ASD EXPRESSIONS FROM THE AISC. (KEY ANSWER:...

A: Given data : D= 9000 lb L= 5000 lb Lr= 2500 lb E= ±6500 lb

Q: The probability of T=50 year to occur within the next 30 years is?

A: To find out the probability of flood Occurance for next 30 years. Where, T = 50 year Return period ...

Q: Weter flows up a tapered pipe (tigure). A differential mercury manometer is attached to the pipe at ...

Q: The dry density of a sand with porosity of 0.387 is 1600 kg/m3. a. Calculate the void ratio of the s...

A: Dry Density of soil = 1600kg/m3 porosity = 0.387 Porosity = ( Volume of voids )/(Total volume of ...

Q: 10 kN /m A 2 m 4 m Determine the horizontal and vertical component of raction at the pins A,B.C

Q: Suppose that a certain radioactive substance has a halflife of 34 years. If there are presently 7006...

A: Radioactive substances are atoms that decay naturally. They can give off alpha particles, beta parti...

Q: An ascending grade of 4.88% meets a descending grade of -5.27% which serves as tangents for a parabo...

Concept explainers

Pressure and Stress

Question

Calculate the absolute pressure (in psia) in the natural gas pipeline. Assume that the effect of air column in
pressure is negligible and local atmospheric pressure is 5.9psia. Two decimal points
Air
2 in
(Natural
Gas
14 in
22 in
6 in
-Mercury
SG = 13.6
-Water

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

SAE 30 oil is contained in a cylinder with inside diameter of 1 in. and length of 1 ft. What is the pressure required to decrease the volume of the oil by 2%?
1. The reading of an automobile fuel gage is proportional to the gage pressure at the bottom of the tank. The tank is A deep and is contaminated with B of water. The specific volume of gasoline is 0.00147076 m /kg and that of air is 0.0008313 m³/kg. Unit weight of water is 9790 N/m3 a. Determine the gage reading when the tank is full of gasoline b. How many cm of air remains at the top when the gage indicates full if the tank is A deep and is contaminated with B of water. c. Determine the pressure at the interface of the gasoline and water when the gage indicates full A = First name in inches Vent B = A/10 in inches Air h A Gasoline Pgage Water B
Solve the given problem using the equation of Combined gas law.1. Helium gas has a volume of 250 mL at 273Kat 1.0 atm. What will be the final pressure ( P2 ) if the volumeis reduced to 100 mL at 318K?2. The volume of a gas at 270C and 700.0 mmHg is 600mL.What is the final volume ( V2 ) of the gas at -200Cand 500.0 mmHg?
Heavy fuel oil flows through 3 kilometers of cast iron pipe having a diameter of 250 mm. The volumetric flow rate is 40 liters/second. Assume that the kinematic viscosity, v, of the fuel oil is 0.12x103 m²/sec. Determine the head loss in the pipe. (1 m³= 1000 liters)
AAAAAAAAAAAAAAAAAAAA 2 Pa oil with density 706kgf/" and viscosity 4-7×10 7³9 flows out of storage tank below: Determine the minimum diameter that results in a flow rate of 18 litres per minute. Provide answer in cm H = 1.4m L = 7m
A closed pressurized tank shown below is filled with oil and mercury. Mercury is confined inan internal reservoir inside the closed tank, the height of mercury is 450mm. An openmanometer is placed on the bottom left part of the tank with liquid “X” as its gage liquid , thedeflection from the gage liquid shows 800mm. Determine the following:a) Height of the oil from point A up to point c if height A to C is 5 times the height of y.b) Pressure at point B in kPa. c) Pressure at point C in psi.
Oil flows thru a 50 mm diameter pipe having a head loss of 12 m. The length of the pipe is 120 m. long. If the oil has a Reynold's Number equal to 1600; a. compute the velocity of the oil flowing in the pipe. (unit of the answer is in m/s) b. what is the equivalent viscosity in stokes? (unit of the answer is in stokes)
Example 6.32. Water at the rate of 30 litres/sec. is flowing through a 0.2 m. I.D. pipe. A venturimeter of throat diameter 0.1 m is fitted in the pipeline. A differential manometer in the pipeline has an indicator liquid M and the manometer reading is 1.16 m. What is the relative density of the manometer liquid M? Venturi co-efficient = 0.96; Density of water = 998 kg/m'.
Question 1 5 Marks The air-oil-water system shown below is at 21°C. Gauge A reads 11 kPa and gauge B reads 14 kPa less than Gauge C. (a) Calculate the density of the oil. (3 marks) (b) What is the reading of Gauge C? (2 marks) air oil water 1 m 0.65 m 0.65 m 1 m Ø A Ø B
3 Consider a horizontal 4-ft-diameter galvanized-iron pipe simulating the Alaska Pipeline. The oil flow is 70 million U.S. gallons per day, at a density of 910 kg/m and viscosity of 0.01 kg/m-s. Each pump along the line raises the oil pressure to 8 MPa, which then drops, due to head loss, to 400 kPa at the entrance to the next pump. Estimate (a) the appropriate distance between pumping stations; and (b) the power required if the pumps are 88% efficient.
1. The compressed air tank has a volume of 0.4 m. The temperature is 25°C and the atmospheric pressure is 101.35 kPa. When the tank is filled with air at a gage pressure of 262.74 kPa, determine the density of the air and the weight of air in the tank. Hint: Ideal gas law should be used. R-28 m/s?K
oving to another question will save this réspUI 45 Liquid 1 SG y Liquid 2 SG2 Both the top of the tank and the end of the slanted tube are open to the atmosphere. If L = 3.03 m., x = 85 cm., y = 66 cm., SG1 = 0.9, SG2 = 1.87, what is the angle of tilt (in degrees) of the tube? Round off to two decimal places. A Moving to another question will save this response.