Calculate mass contained in red light of wavelength 7×10 'm which hits an electron at rest the energy contained in the light wave is completely lost to the electron. Calculate the- velocity and the de Broglie wavelength of electron.

Calculate mass contained in red light of wavelength 7×10 'm which hits an electron at rest the energy contained in the light wave is completely lost to the electron. Calculate the- velocity and the de Broglie wavelength of electron.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: One of the Bohr's hypotheses explain that: (............... is emitted from the atom when the…

A: Bohr's hypothesis is the important hypothesis related to the transition of the electron. In this…

Q: . Consider a longitudinal Pockels cell made of ADA (ammonium dihydrogen arsenate) with ordinary…

Q: b) The spacing between successive (100) planes in NaCl is 2.82 Å. X-ray incident upon the surface of…

Q: X-rays of wavelength λ= 0.200 nm are scattered from a block of material. The scattered x-rays are…

A: According to the given information, we have a wavelength…

Q: A cavity has the dimensions of 12cmx12cmx12cm. We would like to do a microwave experiment where the…

A: Answer: 5 cm

Q: For a glass equilateral prism, with a base length of 50 mm. If you shine a beam of light through it…

A: As per our company guidelines we are supposed to answer only first 3 sub-parts. Kindly repost other…

Q: The band gap in silicon is 1.12 eV. Calculate the maximum wavelength of electromagnetic radiation…

A: Given data: *The band gap of the silicon is E=1.12 eV. *The speed of the electromagnetic wave is…

Q: Calculate the frequency of wavelength of electromagnetic radiation: 503 nm (wavelength of maximum…

A: Given: The wavelength of the maximum solar radiation is λ=503 nm.

Q: Determine the intercepts for the following crystal planes: (610), (203) and (121)

A: Crystal planes are made up of crystal lattice structures. These lattices are three-dimensional…

Q: What changes we must make in experimental arrangement in order to find maximum K.E of…

A: What changes must be made in experimental arrangement in order to find maximum K.E of photoelectrons…

Q: The speed of light is 186,000 miles per second and the sun, on average is 93 million miles from the…

A: The speed of light is, S=186000 mi/s The distance between the earth and the sun is, D=93×106 mi

Q: The following diagram (Attached) is band diagram of a CIS/CdS solar cell. Looking at the band…

Q: Explain the principle of work of an x-ray tube.

A: X-ray tube The x-ray tube works as a specific energy converter. It collects electrical energy and…

Q: A butane torch is a tool in which butane is burned to create a flame. A detector, located at 2meters…

A: Givenλ=500 nm=500x10-9mR=2 mφ=N/At=3.37x1025

Q: Explain the Beam radiation and diffusive radiation with necessary diagram.

A: Solution (1): The beam radiation and the diffuse radiation are the components of solar radiation.…

Q: A light of a given wavelength is shining through a double slit plate with slits of width a and slit…

A: The plot on the screen will be the combination of both single slit and double slot as they both will…

Q: if central bright fringe due to interference for wavelength 5890A a is shifted to the position of…

A: The introduction of a transparent sheet having more refractive index than air creates optical path…

Q: Calculate the energy of a photon of electromagnetic radiation at the wavelengths: 0.052 nm…

A: Given Wavelength = 0.052 nm To find The energy of a photon of electromagnetic radiation

Q: Explain the tremendous amount of energy associated with the strong bonds within the nucleus of the…

A: The atomic energy available in a nucleus is termed as nuclear energy. This energy is released when…

Q: Illustrated in figure 1 below is the path of a ray entering a m unknown index of refraction.…

A: Given Data→ From the figure, we can see Angle of incidence i=30° Angle of refraction r=24°

Q: Calculate the frequency of wavelength of electromagnetic radiation: 632.8 nm (wavelength of red…

A: Given: The wavelength of the electromagnetic radiation is λ=632.8 nm.

Q: Consider a system of nonrelativistic electrons in a white dwarf star at a temperature of 10^9 K.…

A: Write the formula for the density of a non-relativistic electron in a degenerate system.…

Q: What is the wavelength of a photon that has three times as much energy as that of a photon whose…

A: Given data wavelength = 779 nm

Q: An atom in a state with l = 1 emits a photon with wavelength 600.000 nm as it decays to a state with…

A: The energy of a 600 nm photon is E=hcλ=4.14×10-153×108600×10-9=2.07 eV With field, 2T there will be…

Q: The dependency between electron density and fermi energy (E) for a 2-D free electron gas is,

A: We know that, the expression of Fermi energy EF=h2KF22m here, EF is the Fermi energy m is the mass…

Q: The energy E of the electron in a hydrogen atom can be calculated from the Bohr formula: E-- In this…

A: The Rydberg's equation for the calculation of the wavelength during electron transition 1 / λ = RH…

Q: Q4: White light is incident on a soap film at -14 an angle sin : and the reflected light is observed…

A: Given:- By the constructive interference the film thickness is:

Q: (a) Calculate the mass and linear absorption coefficients of air for Cr Ka radiation.Assume that air…

A: Calculate the mass absorption coefficient of air. μair=xN2μN2+xO2μO2 Here, μair is the mass…

Q: when an electron and a photon of the same kinetic energy encounter a potential barrier of the same…

A: Expression for transmission probability is given as: T(L,E)=16EUO(1-EUO)e-2βLHere L is the barrier…

Q: Draw and explain how the “photoelectric effect” is used in a solar panel to power up electrical…

A: The photoelectric effect occurs when electrons are ejected from the surface of solid material when…

Q: (b) Figure 2 below shows the Fe K-edge XANES for iron metal and iron oxides. (Note that the label…

A: Introduction: Here XANES stands for X ray absorption near edge structure and by using X ray we find…

Q: A typical person can detect light with a minimum intensity of 4.0 x10-11 W/m2. For light of this…

A: Given, Intensity, I=4×10-11 W/m2 Wavelength, λ=550 nm=550×10-9 m The diameter of the pupil, d=9…

Q: Calculate the energy of a photon of electromagnetic radiation at the wavelengths: 632.8 nm…

A: Given data: The wavelength of radiation, λ = 632.8 nm. According to Planck's equation, the energy…

Q: A typical energy of electrons in a modern transition electron microscope is 300 keV. Calculate the…

A: Electron microscopes use electrons to illuminate a sample. In Transmission Electron Microscopy…

Q: What is the angular span of the m=1 bright region for visible white light coming through a…

Concept explainers

Mechanisms of heat transfer

Heat transfer is an essential discipline in thermal engineering that deals with the transfer, conversion, usability, and creation of heat or thermal energy. Transfer of heat occurs through various mechanisms like conduction, convection, radiation, and change of phases. All these mechanisms have distinct characteristics, but these mechanisms can simultaneously occur in an identical system.

Question

Narqul
Calculate mass contained in red light of wavelength 7×10
bi, 'm which hits an electron at rest the energy contained in the
light wave is completely lost to the electron. Calculate the
velocity and the de Broglie wavelength of electron.
Solution

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

At what speed must a proton travel in order to have the same de Broglie wavelength as an electron moving at 5 x 106 m/s?
(a) how much time is needed to measure the kinetic energy of an electron whose speed is 10 metre per second with an uncertainty of and no more than 0.1 percent. How far will the electron have travel in this period of time. (b) make the same calculation for a one gram insect whose speed is the same what do the set of figure indicate?
in an FCC crystal Cu (111)[110] is a favorite system true or false explain
What thickness of aluminum is required to reduce 200Kev gamma rays to 10% of its original value? Note that the thickness of half the value at energy Kev 200 in aluminum is 2.14 cm
when an electron and a photon of the same kinetic energy encounter a potential barrier of the same height and width, which one of
8. An electron has a rest mass of 9.11x10^(-28) g. What is the energy contained in the electron provided it is accelerated to the speed of light in kJ? Express the answer in 4 significant figures.
Determine the expected diffraction angle for the first order reflection from the 113 set of planes for FCC platinum when monochromatic radiation of wavelenght 0.1542 nm is used
The dependency between electron density and fermi energy (E) for a 2-D free electron gas is,
2. A certain ruby laser emits 1J pulses of light whose wavelength is 694nm. What is the minimum Cr3* ions in the ruby? 1. In a laser unit laser beam of wavelength 6328Aº is emitted. How many photons are released per unit sec if the output power is 1mW
Why do quantum effects only happen on the atomic scale?
Explain the following, related to physical insight to internal energy (iv) Internal energy (v) spin energy (vi) sensible energy.
Q1 In a parallel plate diode, the anode is at 230 V with respect to the cathode which is 4.5 mm away from it. An electron is emitted from cathode with an initial velocity of 3 x 106 m/s towards the anode. Calculate; (i) the arrival velocity of the electron at anode. (ii) time of transit. (iii) the velocity and distance travelled by the electron after 6 x 10-10 s.