C Q.1) A-Frame is shown in the given figure. Floor reaction at A and vertical pin reaction at D are respectively. Note: the reaction force at A and E have only single vertical force. 4 cm 5 cm 60° 45° 3. (A) 757 N and 1142 N (B) 612 N and 1013 N (C) 757 N and 1241 N (D) 612 N and 1142 N (E) No one of above write your answer 12 cm 9 cm 180

C Q.1) A-Frame is shown in the given figure. Floor reaction at A and vertical pin reaction at D are respectively. Note: the reaction force at A and E have only single vertical force. 4 cm 5 cm 60° 45° 3. (A) 757 N and 1142 N (B) 612 N and 1013 N (C) 757 N and 1241 N (D) 612 N and 1142 N (E) No one of above write your answer 12 cm 9 cm 180

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Problem 3: 4 kips/ft Determine the following: a. The reaction at support A, R = b. The reaction at support B, R= 15 ft- 20 kips 5 ft 3 kips/ft -15 ft- 20 ft- B 15 ft ?
A IS AT THE FIXED SUPPORT point B is 6 meters from left support, point C is 9 meters from left support . D AT THE END
Determine the reactions of the given beam. Use force method
Q1) The force system shown in (FIG. Q1A) consists of the couple C and four forces. If the resultant of this system is a 750 N.m counterclockwise couple, determine P,Q and C 100 N
Answer Keys: By = 49,111.11 N Vcmax = -9277.78 N +Mcmax = 54,222.22 N-m
Please answer a to e.
Statics Of Rigid Bodies Determine the horizontal and vertical components of reaction on the members at the pin A and the normal reaction at the roller B in the figure shown.
Please solve with step by step solutions with diagrams for part b
Solve for all reactions at A and B
Determine the reaction at support B for the simple beam shown. a. 600N O b. 450N O c. 750N O d. 300N 3 m 400 N/m -3 m- B
Please answer the ff in neat & complete solution Influence Lines Problem: Construct the influence lines for the support reactions, and then use them to obtain the influence lines of bending moments and shear forces at point B for a statically determinate beam shown below. Use the equilibrium equation.
] (frame) Determine the moment at the fixed support A for the frame shown in Fig.9. El is constant, using force -method. assume the reaction at A is the redundant. Assume E :70, 000 MPa, I= 1.3 * 10 mm 30 kN/m B 3m 8m 4m