c) A pumping plant forces water through a 600 mm diameter main, the friction head being 27 m. In order to reduce the power consumption, it is proposed to lay another main of appropriate diameter along the side of the existing one, so that the two pipes may work in parallel for the entire length and reduce the friction head to 9·6 m only. Find the diameter of the new main if with the exception of diameter, it is similar to the existing one in every aspect.

Q: From a deep well, water is being pump through a 250mm pipe, 400m long into an elevated tank. If the…

A: Given, D = 250 mm or 0.25 m L = 400 m  f = 0.02

Q: Water from a reservoir is pumped all over a hill through a pipe 1 m in diameter. A pressure of 20…

A:

Q: A 150-mm diameter penstock supplies water to a turbine under a constant head of 30 meters. Calculate…

A:

Q: A straight 30 cm pipeline 4.80 km long is laid between two reservoirs having surfaces at Elev 100 m…

A: Consider the following diagram for the given condition: The numbers 1, 2, and 3 are the three…

Q: Two reservoirs, A and B, are connected together by the two pipes with a pump between them. Assuming…

A:

Q: Water flows from an upper reservoir to a lower one while passing a turbine as shown. 1. Compute the…

A:

Q: A pool has a diameter of 393", and a water height of 3.67 m above ground. This is to be emptied by…

A:

Q: A new 45 cm CI pipe, 600 m long carries 260 L/s of water from an upper reservoir A, and flows into…

A:

Q: Two reservoirs A and B having elevations 250 m and 150 m, respectively are connected by a 250mm…

A: This question is related to the Fluid Mechanics and hydraulic Engineering.

Q: A conical tank is full of water. It has a diameter of 10 cm. Find the work done in N.m in pumping…

A: Diameter of conical tank=10 cm Depth=20 cm Work done =?

Q: The water surface in reservoir X is 6 m higher than that in reservoir Y. A 150 mm diameter pipe 270…

A: Bernoulli's equation generally defines the total mechanical energy of the flowing fluid comprising…

Q: A pump draws water from a 20 cm diam suction pipe and discharges through a 15 cm diam pipe in which…

A: Pump efficiency is generally the ratio of water power output from the pump to the shaft power input…

Q: Water is pumped between two reservoirs at 0.25 m3/s through 700m of 250mm diameter pipe and several…

A:

Q: Water from a reservoir is pumped over a hill through a pipe 90 cm in diameter, and a pressure of 200…

A:

Q: Water must flow over a distance of 2 800 m from a large catchment dam to a turbine. The water level…

A: L=2800m D=200mm P=300kW

Q: Two reservoirs ( Elev. 38.7m and Elev. 90.6m ) are connected by two pipelines 1-2 and 2-3 with a…

A:

Q: Water (γwater = 9810 N/m3) drains from the reservoir higher to the bottom, both with constant…

A:

Q: A local water distribution center receives its supply from a reservoir 15km away. For water to reach…

A: Initial head supply = 84 atm = 84 x 10.33 = 867.72 mm Final head delivered = 7.9m Head loss = 0.76 m…

Q: Water flows from Reservoir A (Elev 125 m.) to a turbine (Elev 67 m.) then discharges into tailtrace…

A:

Q: A new 45 cm CI pipe, 600 m long carries 260 L/s of water from an upper reservoir A, and flows into…

A:

Q: Reservoirs A and B have elevations 250 m and 100 m, respectively, and are connected by a pipe having…

A: Q=140L/s To find power generated by turbine

Q: Q2: Water is flow by a rate = (V(0.3( still stable due to using a pump as shown in figure below. A…

A: Discharge is the main quantity in any sector that is used to transfer fluid from one place to…

Q: A pumping plant forces water through a 600 mm diameter main, the friction head being 27 m. In order…

A: Diameter of the pipe = d = 600mm   Head loss in the pipe = Hf = 27m   After laying of another pipe…

Q: Question Water at 15°C is to be discharged from a reservoir at a rate of 18 L/s using two horizontal…

A: As per our guidelines we are supposed to answer only one question. Kindly repost other questions as…

Q: he turbine of a hydrostatic plant is driven by a falling head of water from a source 30 m high up…

A: The velocity of an object is the rate of change of its position with respect to time and also…

Q: Water is pumped at the rate of 20 m3/s from the reservoir located at elevation 100 m and out through…

A: Given data: Flow rate Q = 20 m3 /s  Reservoir 1 height = 100 m Reservoir 2  height = 140 m Pump is…

Q: A pump is used to raised water to a reservoir through 1000 m. long of 20 cm diameter with Cw of…

A:

Q: Current Attempt in Progress A pump draws water througha 12-cm diameter pipe and discharges it at the…

A:

Q: Two reservoirs A and B having elevations 250 m and 100 m, respectively are connected  by a 250-mm…

A: Head loss is potential energy that is converted to kinetic energy. they are due to the frictional…

Q: Water flows from reservoir A to a turbine and then discharges into tailrace B, as shown in the…

A: To Determine The horsepower being generated by the turbine.

Q: A motor-driven centrifugal pump delivers 15°C water at the rate of 10 m³/min from a reservoir,…

A: T = Temperature of water = 15°CQ = Rate of flow = 10 m3/min = 1060 = 0.1667 m3/secL = Length of pipe…

Q: 1. (a) Explain the specific speed of a pump. (3 marks) (b) Water is delivered from a truck (shown in…

A: Specific Speed is a dimensionless number which represents the performance of a pump fora  given…

Q: The parallel galvanized-iron pipe system delivers water with a total flow rate of 0.036 m3/s. If the…

A: To find discharge in pipe 1 and 2

Q: 90.Water is pumped from the reservoir with a surface elevation of 200 m across the valley to another…

A: Given data  Length of pipe Diameter of pipe Pressure at halfway Elevations

Q: Three reservoirs A, B, and C are connected respectively with pipes 1, 2, and 3 joining at a common…

A:

Q: Two identical pumps connected in series using a pipe 3.5 cm diameter with water flowing at velocity…

A: Given data: G1=0.1 bar=0.1×105 N/m2G2=0.6 bar=0.6×105 N/m2V (velocity of flow) = 2.5 m/sD = 3.5 cm

Q: (b) Water is delivered from a truck (shown in Figure 1b) to a maximum 18m height above the hydrant.…

A: Using Bernoullis theorem the head imparted by the truck to water can be calculated. Then using the…

Q: 2. Water is pumped from a lower reservoir using a 75 kW pump. If the height of water at the higher…

A:

Q: 1. A 40-cm straight pipe is used to carry water at 20°C from one reservoir to another reservoir that…

A: Assume friction factor as 0.015so,Apply Bernoullis theorem…

Q: Water (v = 1.02 x 10“ m²/s) flows from reservoir 1 to reservoir 2 using two steel pipes (ɛ = 0.25…

A: Given, Pump power = 25 kW Flow rate = 2 m3/hr = 0.00055 m3/s  D1 = 2 in or 50mm or 0.05 m D2 = 0.5…

Q: A pump is used to raised water to a reservoir through 800 m. long of 20 cm diameter with Cw of…

A:

Q: Water from a reservoir is pumped over a hill through a pipe 90 cm in diameter, and a pressure of 200…

A: Given: The diameter of the pipe is 90 cm. The pressure is 200 KPa. The height of the summit is 90 m.…

Q: A 600 mm diameter pipe 900 m. long connected in series to a 40 cm diameter pipe, 625 m long is to…

A: Compute for the discharge. Determine the power available in the jet of the nozzle. What will be the…

Q: What is the head that must be supplied by the pump to the water to pump 0.4 m³/s from the lower to…

A:

Q: ... Elevation 90m 150mm diameter 100mm diameter Elevation 10m P A pump draws water from reservoir A…

A:

Q: A water discharge 8 m³/s is to flow through this horizontal pipe, which is 1 m in diameter. If the…

A: Given: Discharge, Q=8 m3/s Diameter of the pipe, d=1 m Head loss, hL=7V22g

Q: water from reservoir is pumped over a hill through a pipe 90cm in diameter and a pressure of 200kpa…

A: Given: The diameter of the pipe is 90 cm. The pressure is 200 kPa. The height of the summit is 90 m.…

Q: m2/s? If the velocity of water is 8 m/s and the pressure is 140 kPa on the discharge side of a pump,…

A: head at discharge end   hd=pρg+v22gd=140×1031000×9.81+822×9.81d=17.53 m head  at suction end…

Q: Water is pumped from the reservoir with a surface elevation of 200 m across the valley to another…

A: Given that:                       Surface elevation of reservoir = 200mSurface elevation of other…

Q: A new 45 cm CI pipe, 600 m long carries 260 L/s of water from an upper reservoir A, and flows into…

A:

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.