Brigde was designed for ten years , and during the first four years was designed to carry 10 millions cars and one hundred thousand lorries ,at second four years was designid to cary 15 millions cars and two hunderd cars and during last two years was disigned to cary Smillions cars and one hunderd cars. Each car has fatique life of 10° cycles and each lorry of 10° cycles . Determine the brigde fatique life

Q: Q2:An open belt 100 mm wide connects two pulleys mounted on parallel shafts with their centers 2.4 m…

A: Belt: A belt is a looped strip that is essentially used to connect two or more shafts together in…

Q: For the tank shown in the figure, compute the pressure at points B, C, D, and E in kPa. Neglect the…

A: Draw the given diagram. At point A, the pressure is atmospheric pressure which is 0 gauge pressure.…

Q: A casting weighing 300 lbs is to be lifted by means of an overhead crane. The casting is lifted 10…

A:

Q: Water is pumped from a 200-ft-deep well into a 100-ft-high storage tank. Determine the power, in kW,…

A: Given data:water flow rate=200 gal/min =0.012618 m3/sThe depth of the deep well =200 ft =60.96 mThe…

Q: 3. A heat engine operating between a geothermal steam source at 205°C and a riv- er at 18°C achieves…

A:

Q: The swept area of a wind turbine is 485 m´. The diameter of the rotor is Select one: a. 617.02 cm b.…

A: Given Data A=485 m2

Q: Find the work done if a force of 2 N displace crate of box by 2 m

A: Given data : Force=F Displacement=d   To find : Work done

Q: Q₂- A missile runs freely without of fuel in the location as shown in figure. calculate:- 1-…

A:

Q: How much work is done by the gravitational force when a250 kg pile driver falls 2.80m?

A: Given :  mass of pile driver , m = 250 kg height of fall , h = 2.8 m   To find ;  work done by the…

Q: i) the force that must be applied to the small piston. ii) the distance that the small piston has to…

A:

Q: isplacement 22500T, KM 8.20 m and KG: 4.8m.

A: GIVEN displacement = 22500T

Q: Find the value of work done if force 2 N displace crate by 1 m

A: Given data : Force applied is denoted by=F Displacement is denoted by=d   To find : Work done

Q: An automobile of weight 2250 kg move on incline plane of angle 2.3° with constant velocity (12.5…

A: given m = 2250 kg θ= 2.3° v = 12.5 m/s velocity to find power (p) solution = resistive force…

Q: A 15hp motor is used to drive an air compressor. The mechanical and compressor efficiency are 65% &…

A: Power inputShaft power=15 hp=11.2 kW T1=30oC=303 K P2P1=6 ηm=65% ηC=70%

Q: A flight conveyor of dimensions 3 and 2 ft are moving at a speed of 87 fpm. The conveyor handles…

A:

Q: A water jet consumes "3X50"W for 126 hours a week. What is the energy consumed (kWh) for a one-year…

A: Given data: Energy consumption for a week = 3 x 50 W = 150 W/week

Q: A hydraulic car list has an actual mechanical advantage of 50. The mechanic using it applies a force…

A: Work: W=force×displacement Given: Displacement = 1.5 m Mechanical advantage = 50 Total force = M.A.…

Q: A flat belt connects pulley A, which drives a machine tool, to pulley B, which is attached to the…

A:

Q: A biomass digester receives 23 kJ of energy in the form of heat. There is a mechanical mixer that…

A:

Q: Consider a device similar to that used by Joule to measure the net work between two states as…

A: The mass of the weight is m=4 kg. The height of fall of the mass is h=0.8 m.

Q: If the piston mass is 20 kg and the car mass with its base is 400 kg, what will the minimum pressure…

A: we need to calculate minimum pressure required to lift the car

Q: or the tank shown in the figure, compute the pressure at points B, C, D, and E kPa. Neglect the unit…

A: To find pressure at point B,C,D,E

Q: 5. A ventilation system has two branches: one branch requires to have SP of – 5.3" w.g. and Q of 4.8…

A: given data static pressure(SP) SP1 = 5.3 w.gSP2 = 6.1 w.gdischarge(Q)Q1 = 4.8 scfmQ2 = 5.2 scfm

Q: A 10 ft by 15 ft rectangular cistern (storage tank for rainwater) has its top 30 ft below ground…

A: Calculus is frequently used to determine the amount of labour required to empty a tank of the…

Q: Convert between energy units.  2.88x10^4 J to Cal

A: Given: The energy is E=2.88×104 J. The unit conversion factor to convert Joule into Calorie is, 1…

Q: 29a. Up hill climb. A workman pushes a 111-lb load of dirt up an incline (ramp) whose slant length…

A: Solution: Given Data: W=111 lbL=2.67 mH=1.27 mη=74.4%   To Find: (a) The resistance force. (b) The…

Q: 2. Motor unit A is used to elevate the 300.kg , cylinder at a constant rate of 4 m/S. If the power…

A: Given data as per the question Mass of motor =300 kg Velocity =2 m/s Power input =2.2 kw

Q: A flywheel revolving 400r/min slows down with a deceleration of 4rad/s2.

A:

Q: An engine has an input of 90 horsepower and uses 8% of its input power to overcome friction and…

A: Input power = 90 HPLosses = 8% = 0.08To find available horsepower at output

Q: 5. 6. DETAILS SCALCET9 6.4.017. A 10 ft chain weighs 65 lb and hangs from a ceiling. Find the work…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: 4. An electric motor is used to drive the shaft of a small water pump. During a performance test,…

A:

Q: A hydraulic cylinder is used to lift a load of 750 lbf a distance of 4 ft in 3 seconds. Compute the…

A:

Q: 18. What is the power output of the boy to do this? A 100 N boy lifts a 30 N package up at a…

A: Given

Q: Work and Energy 8. A body weighing 3500lbs (force) fall 1 ft and strikes a 2000lbs per inch spring.…

A:

Q: The rate of water supply to a hydraulic crane is 90 liters per minute at a steady pressure of 70…

A:

Q: haft trar Is, then t

A: given:power P=1000kwω=100rad/s

Q: 9. Boat will be lifted then put into sea. 30 tons. STALA will lift 200 kg boat, 4 will be used as…

A:

Q: Convert the values provided below in terms of specified units.

A: Given

Basic Terminology in Mechanics

The area of science and mathematics concerned the motion of the objects, the relation between the force matter, and motion if specified. Forces exerted over the objects result in displacements or changes in the position of an object concerning its environment. This branch of physics keeps its roots in Ancient Greece in the form of the scripts of Aristotle and Archimedes.