Bomb calorimetry was performed to determine the calorific value for a sample of edible oil. The following data were obtained and recorded: mass of the oil sample heat capacity of the calorimeter volume of water in the calorimeter initial temperature final temperature = 1.50 g = 1.3 kj/«C = 950 ml = 25.5 °C = 31.4 °C Compute for the calorific value of the sample in Cal/g.

Q: How can microsegregation be removed?

A: Microsegregation -How it is removed

Q: Q2

A: The heating rate is dependent on a given source of heat, the properties of fluid that is to be heate...

Q: A liquid reactant solution is pumped through a pre-heater before entering a reaction vessel. The sol...

A: a) and b) The liquid reactant at a temperature of 25oC is pre-heated before it enters the reactor.  ...

Q: Using data provided in Table 1, determine the activation energy for formation of product A? Use grap...

A: Given data: T (C) K (1/S) 28 0.021 35 0.029 39 0.047 42 0.051 46 0.066 48 0.079 R...

Q: A car with an engine volume of 1.5 L burned 100 L of gasoline on a 1000 km road traveled at an avera...

A: In a car engine, gasoline reacts with oxygen to give carbon dioxide and water. Rate of a reaction is...

Q: 2. Humans are, in reality, open systems, and the major mechanism for heat loss is through evaporatio...

A: Given-Evaporation of water requires 40.8 kJ/mol of water. Find Mass of water evaporated to maintain ...

Q: The heat of combustion of undecane is - 7430.9 kJ/mol. Use this value to find the heat of formation ...

A:

Q: In the film adjacent to the wall where a liquid is flowing is where most of the resistance to mass t...

A: Considering the film adjacent to the wall, where the liquid film is flowing. Assuming simultaneous h...

Q: 4. A coal analyzing 65.4% C, 5.3% H, 0.6% S, 1.1% N, 18.5% O, and 9.1% ash is burned so that all com...

A: According to question given Find d)% Excess air

Q: 6 kmol of ethylene / s reacts with 60% excess air according to the reaction: C2H4 + 3O2 -> 2CO2 + 2...

A: for given reaction , we have to find the % excess air supplied in the reactor.                      ...

Q: Rich cow's milk (4536 kg/hr, cp = 3.85 kJ/kgK ) at 4.4°C is heated in HE to 54.4°C by hot water. How...

A:

Q: When evacuated or empty, a gas density bulb weighs 29.3215 g. First, CO2 gas was used to fill the bu...

A: The gas in both cases is assumed to follow the ideal gas law. The weight of the gas can be determine...

Q: 1. Determine F12 and F21 for the following configuration using the reciprocity theorem and other bas...

A: a) long duct: The view factor F12 represents the fraction of energy released by 1 and falling on 2. ...

Q: Determine the liquidus temperature, solidus temperature, and freezing range for the following Mg0-Fe...

A:

Q: 1. Complete this table for H;O: T, °C P, kPa u, kJ/kg Phase description 400 1450 220 Saturated vapor...

A:

Q: 4. A 0.72 g of a fuel containing 80% carbon when burnt in a bomb calorimeter, increased the temperat...

A: 4. Given Fuel mass=0.72g Temperature of water changes from T1=27.3℃ to T2=29.1℃ Water weight=250g W...

Q: Pure ethylene (C2H4) and oxygen are fed to a process for the manufacture of ethylene oxide (C2H«O): ...

A: Given that :

Q: 7. The gravimetric analysis of a sample coal is: 75% C, 12% H2, 3% O2, and the rest ash. Calculate t...

A: Given details : in weight percent for 1 kg of coal sample, C=0.75 kg H2=0.12 kg O2=0.03 kg Ash=0.1 k...

Q: CH-13 Ammonia is produced by the following reaction N2+3 H2= 2 NH3 In a commercial process for ammon...

A: Amonia is produced by the reaction as given below. N2+3H2→2NH3 The feed to reactor contains 1 Kmol/s...

Q: Experiment: Aluminum and Mercury What would happen when you have a piece of aluminum and a drop of ...

A: Metals, in general, do not react with each other since they cannot share electrons, and moreover, th...

Q: Calculate the degrees of freedom P1 = ?? kg/h ??% A ??% B F1 = 100 kg/h 20% A ??% B P2 = 0.1F1 ??% C...

A: The Degree of freedom analysis for the material balance example given is as follows: DOF = number of...

Q: Calculate the heat of RXN using the listed heats of formation. NOTE: Fluorine gas = 0 kJ/mol CH4(g) ...

A:

Q: 1. Fluidization of tea particles equipment is shown in Figure 1. The important of pressure drop acro...

A: Given: Shown below is fluidized bed:  

Q: 12. The second order system with the transfer function 4/(s2 + 2s + 4) has a damping ratio of (а) 2....

A: This question is based on process dynamics and control. Let us see what data have been given: Transf...

Q: For the gas phase decomposition of isobutyl bromide, (CH3),CHCH,Br(CH3),C=CH, + HBr the rate constan...

A: Given: Slope is -2.54×104 K y-intercept is 30.1 Activation energy ?

Q: Equation 1 is for finding the force on an object outside atmosphere. F= 144.2 y+ 3.14 (1) Where F is...

A: Any unit is defined into only three dimensions. The dimension are mass, length, time. This dimension...

Q: N2H. (1) + O2 (g) → N2 (g) + 2H¿O (1) AH = ? 2 NH3 + 3 N20 → 4 N2 + 3 H2O N20 + 3 H2 → N2H« + H2O 2 ...

A: Given that  N2H4   +O2  → N2  + 2H2OEnthalpy are given for every reaction we have to calculate the e...

Q: A 25.5-L glass vessel is to contain 1.42 g moles of nitrogen. The vessel can withstand a pressure of...

A: Assume Nitrogen gas (Given)- Ideal gas Volume=25.5L moles=1.42 g mole P=29000+101325 Pa = 130325 Pa

Q: 1. For each of the questions below, please give the best response based on our discussions in class....

A:  Solution: Q.1   (a) The azeotrope is a composition at which the vapor and liquid composition remain...

Q: How many grams of aluminium ,with a dislocation density of 1010 cm/cm3,are required to give a total ...

A:

Q: to kg /s kg /min 140

A: The unit conversion for a quantity is to present the identical quantity in two different measurement...

Q: 3. For this problem, please refer to the figure below for the Methanel (IYdoni Acid (2) system at 94...

A:

Q: 10.4. A lethal agent (KCN) was added to the fermentation medium in the presence of aeration using di...

A:

Q: In an effort to make cheap NO gas, ammonia gas is reacted with 20 % excess O2 (20 % excess in the fe...

A: Given that: 20 % excess O24NH3  +5O2  → 4NO +6H2O Fresh NH3 feed = 100 kmol/hr

Q: The enthalpy of the following acid-base neutralization reaction is -58 kJ/mol: HCI(aq) + NAOH(aq) → ...

A: Dear Subscriber! There are four independent questions posted here. As per our authoring guidelines, ...

Q: Air at 300 kPa and an average of 450 K is being heated as it flows through a rectangular conduit of ...

A: The rate of heat transfer for unit area is called as heat flux normal to the direction heat flowing....

Q: (4) At a reaction temperature of 1000 K, when Cg = 1 mol/L, which one of the two products (i.e., D v...

A: In the given problem it has been seen that the graphs are given and the rate equations are given

Q: 6. Liquid fuel weighing 0.98 g and contains 90.1% C, 8% H with the following results in bomb calorim...

A:

Q: In order to concentrate 4536 kg/h of an NaOH solution containing 10 wt% to 20 wt% solution, a single...

A: Given: The mass flow rate of feed stream mF = 4536 kg/h composition of the feed is xf = 0.1 or 10 wt...

Q: Make a comparison between thermoplastics and thermosetting polymers(a) on the basis of mechanical ch...

A: A resin that is solid at room temperature but becomes plastic and soft upon heating is a thermoplast...

Q: 5. On burning 0.83 g of a solid fuel in a bomb calorimeter, the temperature of 3500g of water increa...

A: The solid fuel is burned in the bumb calorimeter, as a result, temperature of the water increases. m...

Q: (b) Fick's Law for molecular diffusion is given as dCa JA = -DAB dz where Ja is a molar flux, DAB is...

A: Given:  Fick's law for molecular diffusion: JA=-DABdCAdzJA=Molar fluxDAB=Molecular diffusivitydCAdz=...

Q: An evaporator-crystallizer-filter process is used to obtain solid potassium sulfate from an aqueous ...

A: Given, Temperature of product=23oC from the given table, from interpolation 30-2030-23=11.5-1011.5-x...

Q: 7- 3.111- Water flows through the branching pipe shown in Fig. P3.111. If viscous effects are neglig...

A: Given details , water flows through the branching pipe as shown in given figure. if viscous effects ...

Q: What is qH2O?   -146.4 J   +3661 J   -3661 J   +146.4 J

A:

Q: A number of casting alloys have very high lead contents;however ,the pb content in wrought alloys is...

A: The cast alloy are made be melting in a furnace and then by allowing to cool in a mold but the wroug...

Q: If the heats of combustion of methanol and carbon monoxide at 18 °C are -173.7 kcal/mol and -67.6 kc...

A:

Q: Write for unfinned tu bular HEX, take touling into account A; =T D; L A。=ヤD。L IT i Do

A: Given:   Ai=πDiLAo=πDoL

Q: Question7: Calculate the ratio of the two heating times (for a single board versus when they are sta...

A: Given: Surface temperature to be maintained is 70°C Thermal diffusivity of the wood is 9×10-8m2/s   ...

Q: x'+y - is a homogeneous function of degree. x- y F(x,y)=-

A: for finding homogenity, we substitute x,y with λx ,  λy => F(λx ,  λy) = λx2 + (λy)2λx - λy F(λx,...