Boiler Pump m5 Feedwater heater Turbine A steam power plant operates with a boiler output of 20 kg/s steam at 2 MPa and 600°C. The condenser operates at 50°C, dumping energy into a river that has an average temperature of 20°C. There is one open feedwater heater with extraction from the turbine at 600 kPa, and its exit is saturated liquid. 6 y m5 Pump p1 W, (1-y) ms Condenser (1-y) ms a) Draw and label the Ts Diagram. b) Tabulate values for: h, to h c) Find the mass flow rate of the extraction flow from the turbine to the feedwater heater (kg/s). RIVER WATER IN LIQUID (1) STEAM (7) RIVER WATER OUT

Boiler Pump m5 Feedwater heater Turbine A steam power plant operates with a boiler output of 20 kg/s steam at 2 MPa and 600°C. The condenser operates at 50°C, dumping energy into a river that has an average temperature of 20°C. There is one open feedwater heater with extraction from the turbine at 600 kPa, and its exit is saturated liquid. 6 y m5 Pump p1 W, (1-y) ms Condenser (1-y) ms a) Draw and label the Ts Diagram. b) Tabulate values for: h, to h c) Find the mass flow rate of the extraction flow from the turbine to the feedwater heater (kg/s). RIVER WATER IN LIQUID (1) STEAM (7) RIVER WATER OUT

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

I need the answer as soon as possible
n industrial plant generates its own power thru heat transfer and mechanical work, from heat energy generator and turbo generator set. A bagasse fired 60 tonner water tube boiler generating 335 psi. And 330°C superheated steam. Condensates at 90°C feedwater absorbing heat at the deaerator and preheater by as much as 3 592 446 KJ/hr that supplies the steam drum at a rate of 10% higher than the steam generated. Tons steam per ton cane is 2. Superheated steam at a velocity of 25 m/sec is supplied to an impulse turbine that drives a generator producing electrical energy. Exhausted heat energy at a velocity of 20 m/sec, before undergoing heat condensations is at 800 KJ/kg.Determine the following:The Boiler Thermal Efficiency
A steam power plant operates between a boiler pressure of 48 bar and a condenser pressure of 0.04 bar Calculate for these limits the cycle efficiency for a Camot cycle using wet steam NB Answer in decimal and not percentage to 4 decimal places.
Specify the C.O.P. of the cycle vapor compression refrigeration simple R-134a. Temperature evaporation is -10 °C and the temperature of the condenser is 30 °C. (COP is found using enthalpy)
1. A reheat steam cycle has 13,580 kPa of throttle pressure at the turbine inlet and a 37.50308414 atm reheat pressure, the throttle and reheat temperature of the steam is 1302 R, condenser pressure is 4.3 kPa. Determine the difference between the simple Rankine cycle efficiency and the reheat Rankine cycle efficiency, in percent.
In an ideal regenerative cycle, the steam expands in the turbine from 1100 psia and 1100 F to 80 psia, where m lb of steam is extracted for feedwater heating (open heater). The remainder continues expansion to a condenser pressure of 1 psia, 200 F. The throttle flow is 100lb/sec. The brake engine efficiency is 80% and generator efficiency is 84% Compute: a. Ideal combined heat rate, Btu/kW-hr
Write legibly, provide manual step by step solution, and diagram for below given problem. A supercritical power generates steam at 25 Mpa and 560. The condenser pressure is 7 kpa. Determine the exit quality of steam if it expands through a turbine in this power plant. a. 45.66% c. 56.66%b. 68.45% d. 74.26%
Plz help me determine the rankine cycle Or can someone do the rankine cycle on this and how this works
DRAW DIAGRAM In a SIMPLERankine cycle, the steam throttled condition is 8 MPa and 480°C. The steam is then reheated to 2 MPa and 460 °C. If turbine exhaust is 60 °C, determine the following:a. Heat Addedb. Turbine Workc. Heat Rejectedd. Pump Worke. Net Workf. Efficiency
In an ideal Rankine cycle, steam is generated at 4.1 MPa and 480 deg. C. The condenser is at 32 deg. C. Determine: a. The cycle thermal efficiency b. For the engine with the same end states, the thermal efficiency and steam rate
In the Ideal regenerative Rankine cycle, the condensate from condenser is heated by a. steam extracted from turbine O b. fumace O c. boiler d. reheater
Steam at 10 MPaa, 550 degrees celsius enters an ideal engine that has one stage of regenerative cycle; condenser pressure is 10kPaa and extraction of steam is at 1 MPa. Compute the following 8. Engine efficiency 9. Fraction of steam extracted from the turbine