Bay City and Vernonville are 128 miles apart. A car leaves Bay City traveling towards Vernonville, and another car leaves Vernonville at the same time, traveling towards Bay City. The car leaving Bay City averages 10 miles per hour more than the other, and they meet after 1 hour and 36 minutes. What are the average speeds of the cars? The car leaving Bay City averages what mph? The car leaving Vernonville averages what mph?

Q: (a) What is the current in a 5.60-Ω resistor connected to a battery that has a 0.200-Ω internal resi...

A:

Q: A coil of Nichrome wire is 26.0 m long. The wire has a diameter of 0.450 mm and is at 20.0°C. (a) If...

A: Here, we calculate the given as follow;

Q: If two equally charged particles are situated at the same distance away from the y axis (one at +x a...

A:

Q: 1. Which of the following statements about two particles undergoing perfectly plastic direct central...

A: In perfectly pastic collision particles do not regain their shapes and stick together with each othe...

Q: The diagrams show three circuits with identical batteries, identical inductors, and identical resist...

A: Let each resistance is R . Let voltage of each battery is V .

Q: Calculate the currents I1, I2 and I3 in the three branches of the circuit shown below. 30 2 E2 = 40 ...

A:

Q: (a) Choosing the bottom of the slide as the reference configuration, what is the system's potential ...

A:

Q: A bowling ballI, whose radius R is 11cm and whose mass is 7.2Kg, roll from rest down a plank whose l...

A:

Q: A 26 g bullet traveling 201 m/s penetrates a 2.0 kg block of wood and emerges going 172 m/s. If the ...

A: According to momentum conservation Momentum before collision= momentum after collision Pi=Pf.. In th...

Q: The surface temperature of the Sun is about 6000K. For this question, assume it is exactly   6000K. ...

A:

Q: On average, an eye blink lasts about 100 ms. How far does a fighter jet travel during a pilot's blin...

A: Given data:  Time (t) = 100 ms = 0.100 s Average velocity (v) = 3300 km/h Required: Distance (d) 

Q: A 73 kg athlete runs up a flight of stairs in 5 s. His net upward displacement is 7 m. What average ...

A: Write the given values with the suitable variables. m=73 kgt=5 sd=7 m Here, m is the mass, t is the ...

Q: A 3nC charge is situated at x=0 and another, of -9nC, at x=-4. Which of the charges experiences a gr...

A: Given: The charge at x = 0 is 3 nC. The charge at x = -4 is -9 nC.

Q: shaft of bone 1.2 m long. If the strain is 1.3x (10) ^(-4) when the leg supports his weight, by how ...

A: The amount of length led shortened is   =strain ×length    =1.3×10^(-4)×(1.2m)=1.56×10^(-4) m

Q: Question 3 15 points Save Answer NOTE: Round off answer to the nearest whole number. Include the uni...

A:

Q: In the figure, which resistor has the largest value of the electric current? RI R2 WW Ra Ra All the ...

A:

Q: A stone is thrown straight upward with a speed of 20 m/s. It is caught on its way down at a point 5....

A: Given value--- initial speed = 20 m/s. height = 5m. We have to find--- time ?

Q: Q2-a) Two parallel plates, AB, are insulated by vacuum, with a distance of 5 cm between them. An acc...

A: Given Distance between plates d = 5 cm =5 × 10-2 m =0.05 m Potential difference V = 500 Volt Electri...

Q: In isolated system, the total amount of energy is . * constant O high O low zero O 100 % O O O O

A: An isolated system is a thermodynamic system that cannot transfer or exchange energy or matter betwe...

Q: Directions: Analyze the given problems below. Write your complete solution. 1. A parallel plate capa...

A:

Q: 3. A vessel of volume 2000 cm° contains 0:1 mol of oxygen and 0-2 mol of carbon dioxide. If the temp...

A:

Q: 4. (Ch. 14 conditions with pressure 101 kN/m² and density 1.20 kg/m³. Exercise 27 in Wolfson) Find t...

A: Pressure = 101 kNm2density of air (ρ) = 1.20 kgm3  

Q: A space station is rotated at a constant angular speed 'w' in order to produce artificial gravity (c...

A:

Q: A positive static charge +10q is placed off-center inside a conducting shell of a certain thickness....

A:

Q: What are some science ideas??

A:

Q: A 0.25-hp motor is used to lift a load at the rate of 5.0 cm/s. How great a load can it raise at thi...

A: Given: The power is 0.25 hp. The constant speed of the motor is 5 cm/s.  

Q: From a point on the ground at a distance 15 m from the foot of a vertical wall, a ball is thrown at ...

A: Given Data:- Distance of the initial point from where the ball was thrown from the wall is d1=15 m T...

Q: 1. (Ch. 13 - Example of variation 36 in Wolfson) A mass-spring system is oscillatingwith frequencyf=...

A:

Q: An electric field given by É = 5.7-1-4.5(y + 5.3)- pierces a Gaussian cube of edge length 3.3 m and ...

A:

Q: Let Q denote charge, V denote potential difference, and U denote stored energy. Of these quantities,...

A: For parallel connection both capacitors terminals are connected to same potentials.

Q: 9. Which among the following is the correct expression for an electric field? E = F/C E = FQ E = F/Q...

A: Part (9): Introduction:The electric field is defined as the electrostatic force per unit charge, it ...

Q: A car of mass 600 kg is moving at 15 m/s. Calculate is momentum.

A:

Q: Your friend bought a magnetic field sensor and convinced you to help him measure the magnetic field ...

A: to solve this problem we see that maximum maximum electric field E0 and maximum magnetic field B0 ar...

Q: At a comer of a 30 mm x 40 mm rectangle is placed a charge of -40µC and at the two adjacent comers a...

A: Potential due any point charge is V = KQ/R R is the distance from charge to the point  Q = charge  W...

Q: 1. all the individual current (I1 to I6) 2. all the individual voltages (V1 to v6) 3. Evaluate usin...

A: The resistances R3 and R4 are in parallel so their equivalent resistance will be R' = R3R4/(R3 + R4)...

Q: A light source simultaneously emits light of two wavelengths, 460 nm and 654 nm, respectively. The s...

A:

Q: An infinitely plate has a surface charge density of 23.34 pC/m2. What is the magnitude of the electr...

A:

Q: A 3.0N resistor is connected to a non-ideal source with internal resistance r = 1.0N and EMF e = 16 ...

A: Given value--- resistance R = 3 ohm. internal resistance = 1 ohm. EMF = 16 V. Voltage drop across 3...

Q: Answer below questions for a heat pump that puts in 80 J of heat into the hot reservoir per cycle an...

A: Given data, Heat given to the hot reservoir (QH)=80 J Coefficient of performance (n)=4

Q: A thin spherical conducting shellI (radius R) is filled up with a dielectric. What is the electric f...

A:

Q: The electric potential, relative to infinity, of a certain charge dis- tribution with a total charge...

A:

Q: A Tyrannosaurus named Rex was having a birthday. He was standing on one end of a cart that rolled wi...

A:

Q: Two very long solid cylindrical conductors of radius s run parallel with each other (on the same pla...

A:

Q: R, 3.) If Vs = 9 V, R1 = 3000 Q, R2 = 10000 Q, and R3 = 5000 Q, what is: a.) IT R2 b.) l1, I2, and I...

A:

Q: 2. Calculate the power delivered to each resistor in the circuit shown below. 2.00 2 3.00 2 1.00 2 1...

A:

Q: A bowling ball, whose radius R is 11cm and whose mass is 7.2Kg, roll from rest down a plank whose le...

A: mass = m= 7.2 kg radius = r = 11 cm = 0.11 m length = l = 2.1 m moment of inertia = I = 25MR2

Q: Find the new length (in m) of an 13.45 m copper pipe that is heated from -19.1˚C to 57.6˚C [round yo...

A: Given  Initial length, Lo = 13.45 m  Initial temperature, To = -19.1 °C  Final temperature, T = 57.6...

Q: A stone is thrown straight upward with a speed of 25 m/s. It is caught on its way down at a point 5 ...

A: The vertical displacement of stone is   y=y_0+v_0t-(1/2)gt^2  5=25t-(1/2)(9.80)t^2 5=25t-4.90t^2 On ...

Q: A rectangular sheet with length 5.00 m and width 3.00 m is immersed in a uniform electric field with...

A:

Q: A manufacturing company is testing which material to enclose its packages with when dropping package...

A: Impulse is change in momentum. So it can be found out by difference in final and initial momentum.

Scalars and Vectors

Scalars and Vectors are the classification of physical quantities that are used to denote various terms in physics.