Base your answers to the following questions on the topographic map below. Points A,B,C,D, and X represent the locations on the map. Elevations are measured in feet. Lake Fish Creek Rock M ountain 800 X• 1500 C 1000 Lake 9005 6 mles 900

Q: How many feet from the origin (STA 10+00) is STA 221+20.00?

A: Given: The STA is an abbreviation of the station and is 100 ft.

Q: Determine how far is the centroid of the given cross section above the base. + 4.50" 2-50" 4: 50"…

A:

Q: What do you understand by mean sea level?

A: The datum for measuring elevation and altitude is known as the Mean Sea Level (MSL).

Q: For true difference in elevations between two points 'A' and 'B', the level must be set up * At any…

A: A level is used to know the difference in elevation between two points A and B

Q: How stadia interval factor is determined?

A: The Stadia interval: The Stadia interval is defined as the ratio between the focal distance between…

Q: Compute the latitude for the following line: N 05⁰-40'-57" W 268.74' + 26.6095 O-267.4194 O-26.6095…

A:

Q: The areas of cut of two irregular sections 60m apart are 32m2 and 68m2 respectively. The base width…

A: given data : A1=32 m2A2=68 m2d=60 m

Q: Figure 8 60 KN 2.6m 30 KM 40 KN 30 KN

A:

Q: Compute for the area of the cross section, considering b is 6.4 meters: 6.24 9.44 + 4.40 + 2.90 +…

A:

Q: What is the interior angle of CP#1? Answer in the format ddd-mm-ss without any Instrument is @ CP#1…

A: If BS is CP#6 and, FS is CP#2 And angle is taken from right then this angle must be exterior angle…

Q: Q1. Draw the plan and components of the given line diagram. Assume necessary any suitable data. W,…

A:

Q: The elevation of the point is the vertical distance a. above or below the level line b. measured…

A: To define the elevation of the point in vertical distance.

Q: Arrange the following description in the form of profile level notes complete to elevation. A level…

A: The benchmark elevation is given as 12.135m.

Q: 10

A:

Q: What is Go? And where did that 0.29 come from?

A: This question is related to the Fluid Mechanics from Civil Engineering. This is combined problem…

Q: Draw the plan and elevation of the given line diagram. W W.C V KITCHEN D, 2100×1200 3600x2800 BATH V…

A:

Q: What is the length of side "a" to the correct number of significant figures?

A: Given:- To find:- Length of side "a" Concept:- The rule of sines is a mathematical formula used in…

Q: What are the adjustments that are used for making the line of sight perpendicular to the horizontal…

A: The adjustments that are used for making the line of sight perpendicular to the horizontal axis:

Q: Find the perimeter of the triangle with sides 302m and 507m long and the included angle is 73°33

A: To find perimeter of triangle

Q: from a point A 20m above the ground, the angle of elevation of the top of the tower is 29.33…

A:

Q: Explain how to layout compound curve . * Provide astep by step explanatib n-

A: To explain about compound curve

Q: the grade of the back tangent? What is the

A:

Q: Find the areal scale for the following 3cm+09km

A: Given: Map distancex=3 cm Ground distanceX=9 km To find: Areal scale

Q: What is the stadia interval factor?

A: The Stadia is a technique for quick distance measurement using a telescope and a graduating rod. The…

Q: What are inaccessible points?

A: Points which cannot be viewed via ranging rods or other instruments directly from a point of…

Q: Where did you get -0.0673d^2?

A:

Q: How to draw v shaped valley

A: To draw a V-shaped valley, you will need data about the terrain and elevation of the area,…

Q: Write down the methods for determining differences in elevation.

A: There are various methods for determining differences in elevation or levelling- A) Direct…

Q: B Look to the Contour map above Solid line is the ground surface level Dashed line is Water table…

A: Contour lines are drawn on contour maps which represents the elevation or depression at any…

Q: 10. What will be the correction for three level sections, if the areas of 3 different sides, which…

A: h= 121.31 h' =45.87 w=145.76 w'= 45.67 w1 = 176.65 w1' =  72.43   to find  correction

Q: Plz tell me which side is the width , length and depth of this 3D block ...!

A: To identify the parameters of the given 3D block. Let us consider the cross-sectional area and…

Q: The following are offsets measured from a random line to a curved boundary: 9.6m, 8.2m, 12.5m, 7.1m,…

A: h=10m To find area using Simpson's one-third rule

Q: Q3. Draw projections of the following two points A & B on the same XY line. Keep a gap of 50 mm…

A: drawing projection is depend on the quadrant is given in the problem . their is 4 quadrants in the…

Q: Does the image below depict a Cut or a Fill from the construction stake to the back of curb?

A: This question is from Surveying.

Q: Compute the sideslope of the cross section. (Format: X:X) 6.45 4.5 1+ 020 +2.3 +1.5 +1.0 6.0 6.9 1 +…

A:

Q: In the map of contour lines below, which two points are the same height? a) I-I OB) IV-V OC) I-I OD)…

A: Given- A contour map-

Q: , the rod reading is 1.159m, 120m from the beginning of the line rod reading is 1.434m, and finally…

A:

Q: How did you get 36 in "(3 x 66 x 36)" and the 70.5 in "(29 x 3 x 70.5)"?

A: Data Given: t = 3 mmb = 165 mmc = 29 mmd = 72 mm Asked: How did you get 36 in "(3 x 66 x 36)" and…