B)A gas is flowing at a velocity 0.02 m/s through a column packed with spheres of 4mm in diameter and porosity 0.25. The hight of packing 1.5m . The gas density 1.2 kg/m' and viscocity 1.25x10 Pa. Calculate the pressure drop across the packing using Ergun equation

Q: lumped parameter model

A: Thermal Conductivity is rate of heat transferred by thermal conduction across a material for unit cr...

Q: 9.58. An ultimate analysis of a coal is a series of operations that yields the percentages by mass o...

A: Given data: Dulong formula is given to calculate the higher heating value of ocal. Ultimate analysis...

Q: The following data were collected for the reaction, A --> products time, min [A], M 0.3 0.091 1 0.07...

A: given  data: time, t (min) [A] 0.3 0.091 1 0.077 2 0.032 3 0.021 4 0.015 5 0.012 6 ...

Q: 8.68. A mixture that contains 46 wt% acetone (CH;COCH3), 27% acetic acid (CH;COOH), and 27% acetic a...

A: Note: Since we are entitled to answer only 3 sub-parts, we’ll answer the first 3. Please resubmit ot...

Q: For a Swift high-throughput cyclone with a body diameter of 0,5 m, calculate the pressure drop expec...

A: Cyclone separator is equipment which uses centrifugal force technique to remove the dust particles f...

Q: Classify each substance as a pure substance or a mixture. If it is a pure substance, classify it as ...

A: Matter is basically classified into two types – pure matter and mixture. Now, pure matter has a furt...

Q: 7.15. Values of the specific internal energy of bromine at three conditions are listed here. State T...

A: Note: Since we are entitled to answer only 3 sub-parts, we’ll answer the first 3. Please resubmit ot...

Q: A bomb calorimeter has a heat capacity of 2.47 kJ/°C. When a 0.105g of ethylene ( C„H¾) is burned in...

A: Note: We are authorized to answer one question at a time, since you have not mentioned which questio...

Q: 2. The experimental observations for the determination of enthalpy of vaporization of water is prese...

A: The data table given for the vapor pressure and temperature of the water is given as:   Vapor pr...

Q: 3.9. For liquid water the isothermal compressibility is given by: K = V(P+b) where c and b are funct...

A: Given: Isothermal compressibility is given by k=cV(P+b)...1) b, c are functions of temperature  1 kg...

Q: What are recuperators in afterburner ?

A: A burner is a device that uses gaseous fuel such as natural gas, propane, acetylene along with an ox...

Q: Calculate the final temperature of the exhaust formed when 1.00 Ibm/min of methane at 70 oF is combu...

A: Steady-state enthalpy condition is for a closed system. The balance will be the heat flow of the sys...

Q: 3.138 A sample of 10.0 g of sodium reacts with oxygen toform 13.83 g of sodium oxide (Na2O) and sodi...

A: Given: Mass of sodium that reacts with oxygen is MNa = 10 g The mass of product formed is MP = MNa2O...

Q: Suppose you had a piece of aluminum electrode that weigh 20.52 grams and piece of silver electrode t...

A: This is a question from electrochemistry. Data given : Amount of Aluminum taken = 20.52 g Amount of ...

Q: Explain how can we write equilibrium-constant expressions forhomogeneous reactions?

A: Equilibrium constant is the ratio of rate constant of forward reaction and the backward reaction.

Q: Expert Q&A Done 9:32 1 Search LTE Moodle A closed system contains a liquid mixture of 27.8 mole % n-...

A: Given: n-Pentane (x1) is 0.278  Isopentane (x2) is 0.722 Total pressure is 485.3 mm Hg Bubble point ...

Q: The specific gravity of water is 1.0000 at 4.0°C. A stream of water at 4°C has a mass flow rate of 2...

A: Given: The specific gravity of water is given as 1 at 4.0°C. Therefore, its density is 1000 kg/m3. A...

Q: What is End-of-Period Convent ion?

A: The definition of the end-of-period convention is to be mentioned.

Q: ENGINEERING ECONOMY - draw a cash flow diagram How much money should a bank be willing to loan a r...

A: Real estate developer repay the loan by selling lakefront lot at $100,000 after 5 yrs from now. Thus...

Q: sterchy $ate

A: Throttling process is making to  flow the  fluid  through a partly closed valve. High-pressure fluid...

Q: Assume that in the operation of the engine in the previous problem, the air supply is reduced below ...

A: Hi and thanks for the question. Since you have posted a question with multiple subparts, we will ans...

Q: What is the difference between cool-side ESP and hot-side ESP?

A: The difference between the cool-side ESP and the hot-side ESP is to be mentioned.

Q: If the equilibrium constant for the reaction of acetic acid and ethanol to form ethyl acetate is 4.0...

A: The equilibrium concentration of ethyl acetate is to be determined.

Q: Hydrocarbon mixtures are used as fuels. (a) How many grams of CO2(g) are produced by the combustion ...

A: a)If Mixture mass =200 g ( 25.0% CH4 +75.0% C3H8 ) Find- CO2(g) produced  b)If mass of mixture=252g ...

Q: Suggest a reason why the relaxation times of 13C nucleiare typically much longer than those of 1 H n...

A: The reason for the longer relaxation time of 13C nuclei than 1 H nuclei is to be mentioned. 

Q: 8.35. A gas containing water vapor has a dry-basis composition of 7.5 mole% CO, 11.5% CO2, 0.5% 02, ...

A: Given: Dry basis composition: mole % 7.5  % CO 11.5% CO2 0.5  % O2 80.5 %N2  Gas leaves catalyst reg...

Q: 10.19. A chemical reaction with stoichiometry A → products is said to follow an nh-order rate law if...

A: For a first-order reaction, the value of n=1. The rate law, therefore, becomes, -rA=kCA. In a batch ...

Q: A drug capsule consist of a 0.50-cm diameter spherical bead containing a uniform initial concentrati...

A: Given: - Drug capsule Initial concentration C=50mg/cm3                                   Diffusion ...

Q: 4.93. Liquid methanol is fed to a space heater at a rate of 12.0 L/h and burned with excess air. The...

A: Methanol is mostly used in combustion as a fuel. Dry basis means the solids dry weight is divided on...

Q: A water/ethanol mixture (ethanol is 40% wt) with density of 931 kg/m³ is flowing inside a 2" ID Pipe...

A:

Q: What is the bubble point of a liquid mixture at a given pressure? What is the dew point of a vapor m...

A: The bubble point of a liquid mixture and dew point of a vapor mixture at a given pressure is to be d...

Q: 3) What volume of CO2 forms from 5.25 g of CACO3 at 103 kPa & 25°C? CO2 + CO2 СаСОз Cao +

A: To find the volume of CO2 formed from the given reaction at 103 kPa and 25o C

Q: The piston-cylinder below shows a gaseous reaction mixture before and after a reaction that takes pl...

A: Given data: Temperature of gaseous mixture before the reaction = 199 0C Temperature of gaseous mixtu...

Q: Why is the SRK equation of state called a cubic equation of state?

A: It is to be mentioned why the SRK equation is called the cubic equation of state.

Q: is it function or property?

A: To state whether the given situations represent a function or a property Introduction In science, a ...

Q: Consider 0.5 Ibm of juice flowing through an 8-in.-diameter pipe with a velocity of 4.94 ft/s. NOTE ...

A: Given:  Mass of juice is 0.5 Ibm Pipe diameter is 8 inch (0.667 ft) Velocity is 4.94 ft/s    

Q: What is the thermo-chemical process that converts biomass, into a combustible gas (mainly CO, H2, CH...

A:

Q: By definition, what are Cv and C p?

A: The definition of Cp and Cv are to be mentioned.

Q: Which of the following is one of the raw materials used for biodiesel production?

A: This question is based on biodiesel production. We have three options and we will analyze the option...

Q: What is Damkohler number?

A: In chemical reaction engineering and mass transfer applications, while analyzing the steady-state ch...

Q: A student performed an experiment to determine the ratio of H;O to CuSO, in a sample of hydrated cop...

A: Given: Formula obtained experimentally is CuSO4·4.5H2O True formula is CuSO4.5H2O Error for differen...

Q: A cylindrical tank of diameter 0.8 meter is completely filled with water and its topsurface is open ...

A: Given data: Diameter of tank = 0.8 m Diameter of hole = 15 mm Value of acceleration due to gravity =...

Q: Methane is burned with 25% excess air in a continuous adiabatic reactor. The methane enters the reac...

A: Adiabatic reactor is an insulated vessel with minimum heat transfer. The temperature change can be o...

Q: An orifice meter is used to measure the rate of flow of fluids in pipes. The flow rate is related to...

A: This is a question from unit transformation. The key step to solve these questions is that unit of t...

Q: Classify each pure substance as an element or a compound.(a) aluminum(b) sulfur(c) methane(d) aceton...

A:  Element is  made of only one  type of atoms. compound is made of  two or more different types of el...

Q: 1. The ff. equation is proposed to calculate the pressure drop (Ap) across a length of pipe (L) due ...

A:

Q: Nitrogen has a normal boiling pointof 77.3 Kanda melting point (at 1 atm) of 63.1 K. Its critical te...

A: A phase diagram represents the physical states of a substance under various temperature and pressure...

Q: What is Organic Soil ? Where it is found  ?

A: The definition of organic soil is to be mentioned along with the location where it is found.

Q: Carnot refrigerator A has a 16% higher coefficient of performance than Carnot refrigerator B. The te...

A: Let the efficiency of refrigerator A be ηA. Efficiency of refrigerator B be ηB. Hot reservoir temper...

Q: Dinitrogen tetroxide decomposes to nitrogen dioxide: N;0.(g) – 2 NO:(3) AH = 55.3 kJ At 298 K, a rea...

A: Given: At T = 298 K, the amount of N2O4 (g) initially is 0.1 atm,                                   ...