B

Determine the bending moment of point D. The supports at A and B are journal bearings. Supply the answer in kilonewton-meters. 2 kN/m C D -600 mm- 450 mm- 300 mm

Loading status is in the beam shown below; Determine which of the I and II sections should be preferred for beam safety, taking into account only the normal stresses to occur?

Determine the maximum deflection of the axle. Assume that the bearings resist only vertical loads. The thrust on the axle is resisted at C. The axle has a diameter of 1.11 in. and is made of A-36 steel. Neglect the effect of axial load on deflection.

SOLVE BY HAND LEGIBLE DETERMINE THE FINAL REACTIONS IN THE FOLLOWING BY THE SLOPE DEFLECTION METHOD. A -8 m 20 kN/m 60 kN + E B 8 m се El = constant D +4m+4m| E=70 GPa = 800 (106) mm4

The rod is supported by smooth journal bearings at A and B that only exert vertical reactions on the shaft. Part A Determine its smallest diameter d if the allowable bending stress is oallow = 130 MPa (Figure 1) Express your answer with the appropriate units. HA ? d = Value Units Figure < 1 of 1 Submit Request Answer 12 kN/m Provide Feedback 3 m 1.5 m

Determine the slope at A and the maximum deflection of the beam. EI is constant.

Determine the vertical deflection at joint C. (E=73GPa) using any method

Determine the deflection of end A if E = 200 GPa and I = 65 x 10^6 mm^4

Using Castigliano's method, determine the deflection at point B for the beam shown below. M A a P B a C