Solve b part only in 20 min and take a thumb up plz a) Determine the shape factor for a beam which has the cross-section given in Figure Q2(a). Assumethat the material may be idealised as elastic-perfectly plastic and take the yield moment My = 6 kNmand the yield stress of the material oy = 320 MPa.4.5 cm9 cm7 сm1 cmFigure Q2 (a)b) A uniform I-section cantilever beam, built-in at one end and roller supported at the other, with ashape factor of 1.4, yield stress of 240 MPa and carrying a uniformly distributed load of 16 kN.mis shown in Figure Q2(b).Using a factor of safety against plastic collapse of 3, determine the requiredminimum elastic section modulus.3 m16 kN.mFigure Q2 (b)

Answered: Image /qna-images/answer/707b7f43-fc73-42d2-a9ba-493edb7c910d.jpg

b) A uniform I-section cantilever beam, built-in at one end and roller supported at the other, with a shape factor of 1.4, yield stress of 240 MPa and carrying a uniformly distributed load of 16 kN.m is shown in Figure Q2(b).Using a factor of safety against plastic collapse of 3, determine the required minimum elastic section modulus. 3 m 16 kN.m

b) A uniform I-section cantilever beam, built-in at one end and roller supported at the other, with a shape factor of 1.4, yield stress of 240 MPa and carrying a uniformly distributed load of 16 kN.m is shown in Figure Q2(b).Using a factor of safety against plastic collapse of 3, determine the required minimum elastic section modulus. 3 m 16 kN.m

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A gear drive A has a diameter of 2 inches and gear drive B has a diameter of 6 inches. Calculate the speed in RPM of the larger gear if the smaller gear is rotating at a speed of 150 RPM.
A spur gear has a pitch diameter, Pd of 3. Calculate its Addendum.
Compute and choose the nearest value of minimum number of teeth to be cut on the pinion in order to avoid interference with the help of following data: Pressure angle: 14.5o Pitch circle diameter of gear = 1500 mm Pitch circle diameter of pinion = 150 mm a. 30 b. 54 c. 18 d. 46
A spur gear has a pitch diameter 3. Calculate its clearance.
Please don't give stupid answer read the question carefully. Clarify whether the answer is 2/3 or 3/2.
Quest-5 b, The distance between two parallel shafts connected by Oldham's coupling is 25 mm. The driving shaft revolves at 240 rpm. What is the maximum velocity of sliding?
The maximum sliding velocity of the teeth of two gear wheels in mesh is 0.32 m/s. The wheels are of module 5 mm and have 32 and 44 teeth respectively. The addendum for each wheel is 1.2 times the module and the pressure angle is 20°. Calculate: 2.1. The number of teeth in contact. 2.2. The angular speed of each wheel.
Two shafts, each carrying a four-stepped pulley, are to be connected by a crossed belt. The driving shaft is to turn 150 rpm while the driven shafts is to turn 50, 150, 250 and 600 rpm. The smallest step of the driver is 10 in. in diameter. Find the diameters of all steps. Please Show a clear and detailed solution (with illustration). Thank you!
B3
Solve fast
A spur gear has a pitch diameter 3. Calculate its dedendum.