Axial loads are Bronze Aluminum Steel applied to the compound rod that is composed of an aluminum segment rigidly connected between steel and bronze segments. If P = 75 kN, determine the following: a. Stress in the bronze segment. b. Stress in the aluminum segment. c. Stress in the steel segment. A=400 mm² A=600 mm² A=300 mm² 2P 3P 4P -3 m - - 5 m - 4 m -

Please show written work

Shipra Manufacturing Company is thinking about development of a strong charge producing measure by adding one-ton limit during heaters. Each clump (one ton) of charge should go through 30 minutes of heater time, including stack and dump tasks. In any case, the heater potential use factor is just 80% because of stream limitations in different pieces of the framework. Required yield for the new design is to be 16 tons for each shift (8 hours). Plant (framework) proficiency is assessed at 50% of limit. (a) Determine the quantity of heaters required. (b) Estimate the percent of time the heaters will be inactive.

Describe the following: a)    Internal sensible heat load with exampleb)    Internal latent heat load with examplec)    Combined Internal sensible and latent heat load with example

please help

Compare each strength gain and relate its significance on Strength and Economy. The design strengths are: a.) 290.7 kNm (using 4-25mm dia. Tension bars) b.) 378.7 kNm (using 6-25mm dia. Tension bars) c.) 385.97 kNm (using 9-25mm dia. Tension bars)

a design study where high toughness and a high level of damping are required, what kind of a aterial in this design? Q3. There is Can be