At what temperature will silver have a resistivity that is two times the resistivity of iron at room temperature?

Problem 5: A nichrome rod of length LN 58 cm is connected in series (end to end) to a carbon rod of length Lc 8 cm. Both rods have cross-sectional areas of A 55 mm2. At T0 20° C the restístivity of nichrome is ρΝ-1.50 x 10-6 Ω-m and the resistivity of carbon is pc 3.50 x 10-5 Q-m. The temperature coefficient of nichrome is positive with value a-0.4 x 10-3 °C-1. The temperature coefficient of carbon is negative with a value ac--0.5 x 10-3 °c1. The nonlinear dependence of the resistivity on temperature T can be written as ρ ea(T-To) .odu @ theexpertta.com - tracking id: 2N74-2F-82-4A-BAAB-13167. In accordance with Expert TA's Terms of Service. copying this information to any solutions sharing website is strictly forbidden. Doing so may result in termination of your Expert TA Account. A Part (a) Write an expression for the total resistance of the nichrome-carbon combination as a function of temperature in terms of quantities given in the introduction. Simplify your answer as much as…

A copper wire has a square cross section 2.3mm on a side. The wire is 4m long and carries a current of 3.6 A. The density of the free electrons is n = 8.5 * 1029 m-3. The resistivity of Copper is 1.7 * 10-8 ohmmeter. What is the current density and the electric field inside the wire?

Shown below is a copper wire with the following characteristics: Diameter: 1.45 mm.00145m 1.45 × 10-8 m Number density of electrons: 8.47 x 1028 electrons/m³. Conductivity: 5.96 x 107 S/m a. Calculate the drift velocity (magnitude and direction) of the electrons in the wire when a current of 5.00 A is running through it. b. What direction is the current moving? c. Remembering that current density is a vector, calculate the magnitude and direction of the current density of this wire. d. Calculate the resistivity of the wire. e. Calculate the resistance of this wire if it were 10.0 m in length.

The resistance of a copper wire is 20 Q. If a voltage of 10 V is applied across the wire, determine the current flowing through the wire and the power dissipated by the wire.

Iron has a resistivity of 9.71×108 m at 20°C. What will the resistivity of Lead when then temperature is increased to 135°C. (Take a as 6.51×10³)

If the resistivity of copper is less than that of gold at room temperature, which of the following statements must be true? a) Gold has a higher resistance than copper. b) The sample of gold is thinner than a sample of copper. c) There is more current flowing in the gold than in the copper. d) Electrons in gold are more likely to be scattered than electrons in copper at room temperature when they are accelerated by the same electric field.

The resistivity of pure germanium = 600 x 10-³ Nm. Calculate the resistance of a cylinder of pure germanium with a radius of 1.5 mm and a length 7.0 mm. Note the units of millimeters. R= How long would a cylinder of this radius need to be in order for the resistance of pure germanium to be equal to 2250 ohms? L= mm

A new material is found to be superconducting below 77 K. How much resistance will a 75 mm long sample of this material have if it is at a temperature of 69.3 K while connected to a 6.4 V AC-power supply? R =       How much thermal energy will it generate?Thermal energy generated =

A tungsten wire is used to determine the melting point of indium. The resistance of the tungsten wire is 2.221  at 20.0°C and increases to 4.307  as the indium starts to melt. αtungsten = 4.50 x 10−3 (°C)−1. What is the melting temperature of indium in °C?