Answered: At what depth below the surface of the…

Name: At what depth below the surface of the oil, relative density 0.84 will
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: At what depth below the surface of the oil, relative density 0.84 will produce a pressure of 120 kN/m2. -Depth of oil in meters= -Depth of water is this equivalent to =

Engineering

Mechanical Engineering

At what depth below the surface of the oil, relative density 0.84 will produce a pressure of 120 kN/m2. -Depth of oil in meters= -Depth of water is this equivalent to =

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

a u-tube manometer filled with water,density 62.2 lbm/ft3, shows a height difference of 10in. the right branch is tilted to make an angle of 30 degrees with the horizontal, what should the length of the column of water in the tilted tube to have the same pressure with the u-tube manometer? which is the answer? a. 8.66 in b. 25.4 cm c. 23.329 cm d. 22.0 in
Question 5 pls. Complete soln and units
What would be the reading of a barometer in inches of mercury corresponding to an atmospheric pressure of 14.2 psia? A barometer reads 745 mm of mercury. Calculate the barometric pressure reading in kPa(abs).
Calculate the pressure at depth 2 m using P = ρgh. p= (pressure) 19.855 kPa p= (density of the liquid) 1000 kg/m3 g= (gravity) 9.8 m/s2 h (height below the free surface of the liquid) 2m
Determine the absolute pressure at A in kPa. Oil, SG = 0.84. a = 21 cm., b = 39 cm., c = 49 cm.. Use Patm = 101.338 kPa. Round off to two decimal places.
Q2: A cubical tank has sides of 3.75m which contains three immiscible liquids at same depths. A water upto a height of 1.25m above the base, An immiscible liquid of specific gravity 0.9 is filled in between both liquids upto 1.25m height, the upper remaining part is filled with oil of specific gravity 0.85. Calculate (1) The value of pressures at the top, at the interface points and at bottom on one side of the tank (ii) The position of center of pressure for one side of the tank. (iii) What suggestions would you give to your client on the basis of obtained results? (iv) Pressure distribution Diagram
At what depth below the surface of the oil, relative density 0.89 will produce a pressure of 120 kN/m2. What depth of water is this equivalent to? Depth of oil in meters Depth of water is this equivalent to Question 2
At what depth below the surface of the oil, relative density 0.86 will produce a pressure of 130 kN/mWhat depth of water is this equivalent to? Depth of oil in meters Depth of water is this equivalent to
question below
The surface tesnion of waterr in contact with air at 20deg C is given at 0.0716 N/m. The pressure inside a droplet of water is to be 0.0147 N/cm^2 greater than the outside pressure, calculate the diameter in mm of the droplet of water. a.2.43 b.4.62 c.3.60 d.1.94
if the pressure at a point in the ocean is 60 kpa, what is the pressure 27 meters below this point? (sg = 1.03)
Find the height of the portion of a cubic block that extends below the water surface (h) , the specific gravities of block and seawater are given to be SG = 0.778 and 1.025, respectively. h1 = 13.1cm