At t<0 switches Si and S4 are "ON." At t=to, S1 is switched "OFF. S4 remains closed. Find current "i" 李D, 李D, 2H 202 40V A B * D,

Q: turn loads fully ON or fully OFF. a. Analog circuits b. Contactors c. Digital circuits d. Mechanical…

A: In this question we need to choose a correct option

Q: It is the Insulator used when the Transmission Lines' path need to take a turn on a sharp corner or…

A: Choose the correct option Which insulator is used to change path of transmission line or dead end.…

Q: ock diagram of Arduino car Detector and explain operating

A: The Digital OUT of the first IR Sensor is connected to Pin 11 of Arduino and the Digital OUT of the…

Q: draw a typical stop/start system with memory operating a 2P2T ice cube relay. Include a red light to…

A: To draw start stop system

Q: Differentiate between MCB and kit kat fuse

A: MCB : MCB stands for miniature circuit breaker it is a electrical device in such way that it…

Q: Q1-A LED had been connected to the output 12, write the codes of programing arduino UNO that the led…

A: There are two functions is used to turn ON/Off the LED. void setup(); This is used for the setup of…

Q: What is the advantage and disadvantages Static and Dynamic characteristic of measuring instruments.…

A: Step-1-&gt;Static and dynamic characteristics are two important aspects of measuring instruments.…

Q: The navigation and system data message is transmitted through the: a.50 Hz modulation b.The C/A…

A: Transmission of the navigation and the system data is done by using the specific method.

Q: Crosstalk, shielding and grounding

A: According to question: Crosstalk: It is one of problem seen in communication system which occurs…

Q: Write an Arduino based code to take input from two switches, if switch one is pressed than glow full…

A: The input is taken from two switches  On pressing switch one, the full spectrum on RGB Led.  On…

Q: Evaporator in absorption cooling system changes into vapors at low pressure? O i. Refrigerant O ii.…

A: Purpose of Evaporator in absorption cooling system

Q: two-point control system, the controller sends a/an ______________ open or closed a signal to the…

A: Two point control systems are an control system which are ON OFF system This systems are usually…

Q: Crystal radio receiver Please explain how this circuit works

A: NOTE- According to the policy, we can answer only one question, please post other question as…

Q: etch the electronic symbol (schematic) for the following components/ devices. Briefly describe the…

A:

Q: How many states will there be in a 4-bit ripple counter?

A: In an n-bit counter, the total number of states = 2n.

Q: What is the advantage of using twisted pair wiring? Coaxial cable? Fiber optic?

A:

Q: 5- Design and sketch a MOD-8 ripple-counter with manual reset push button.

A: The MOD-8 ripple-counter can be obtained from the MOD-16 counter. To design the MOD-8 up counter,…

Q: A set of normally closed timed open contacts will open after the time period delay.  True  False

A: Identify True or False: A set of normally closed timed open contacts will open after the time…

Q: Draw the cross sectional view (Diagram) of flat plate solar collector and name all the parts?…

A: Solar collector is used to store sun's heat energy and then convert the energy into another energy…

Q: Q2)  The certain operational amplifier has the following data sheet specifications: IOS= 0.80 µA and…

A:

Q: How does Signaling System Number 7 (SS7) work? Explain fully.

A: Signaling System Number 7 (SS7) : The Signaling System 7 (SS7) is indeed an international…

Q: What are the digits that may be used with the Octal System?

A:

Q: is it possible you can work in multi-sim?

A: Given, We need to implement it in multisim.

Q: Block diagram of Arduino car speed Detector ana explains operating

A: consider the given question;

Q: What is the name and function of this symbol?

A:

Q: Explain the conditions and operation of Synchronous machine parallel operation with diagram

A: Operation of synchronous machine

Q: Minimum of one half page typed with 12 font, single spacing. Make sure your name is on the paper.…

A: Solution   Electromagnetic testing (ET), especially eddy current testing, is commonly used to…

Q: Identify and Explain with neat sketch of the 1. Pin Type Insulator 2. Suspension Type 3. Strain…

A: Pin type insulator: This type of the insulators the most early grown overhead insulator, yet are…

Q: What is the modus operandi motion control lamp Please not handwriting

A: the modus operandi motion control lamp

Q: is a Fragile type temperature sensor

A: Resistance thermometers employing metallic conductors for temperature measurement are called…

Q: Chose the Q/ For the type E chopper to be operated in the fourth quadrant? A. only switch is…

A: type E  chopper : a four quadrant chopper is a chopper which can operated in all the four quadrants…

Q: X) Answer the following questions  (a)What is a clock signal? (b)Differentiate between positive…

A: a) Clock signal refer to a type of signal that oscillates between a high and a low stste and is…

Q: A) Define the following: 1. Optoelectronics. 2. LASER. 3. Optical Detector.

A: We are authorized to answer only 3 subparts at a time since you have not mentioned which part you…

Q: Q-1) هد Please write the magnetic circuit And explain the steps.

A: Given figure:Asked to explain the ircuit and write magnetic circuit?

Q: hoose the correct answer Which one of these is a DAC?   a. R-2R Ladder type b. Counter Ramp type c.…

A: DAC  is digital to analog convertor  R-2R is a DAC counter type, Flash type, Successive…

Q: R a 0 Х R ли 2 л чее L= 10m H If V₂ = ±7√ when x goes to terminal a, what would be VL when t = 25ms?

A: