at is the minimum requirement of the power supply if the transmitter requires 17.3 volts? Answer to 1 decimal place. HAZARDOUS AREA SAFE AREA PIS DVAC PUR REC 420 mA 1-SVirpu 420 mA CONT 15Virpu

Q: 6. Using superposition, find the voltage V2 for the network in Fig. 9.130 D. E O 36 V R12 kN + V2 R2...

A:

Q: Find the output X.

A: Given circuit:

Q: 3. Find the la and I, in the network using loop or mesh analysis 3V R-1k2 Ry1ka 12 3mA Ryw1k2 mA

A: We are authorized to answer only one question at a time since you have not mentioned which question ...

Q: Source Conversion

A: Source conversion is-

Q: R1 Vb Volt R2 Meter Figure 91

A: The solution is given below 

Q: A shunt generator delivers 195 A at a terminal p.d. of 250 V. The armature resistance and shunt fiel...

A: Given, Load current, IL=195 A Terminal voltage, V=250 V Armature resistance, Ra=0.02 Ω Shunt field r...

Q: Why is the circuit overdamped? Explain.

A:

Q: A 4-pole, wave-wound, 750 rpm shunt generator has field resistances of 0.4 ohm and 200 ohms, respect...

A: The solution is given below 

Q: 2. A small island community in the Northern part of our country does not have electricity. However, ...

A: Resources of energy Coal for thermal power plant Wind speed for wind energy Kinetic energy of water...

Q: What is the diameter in inches of a no. 26 AWG wire?

A: 26AWG = 0.0159 inches diameter wire .

Q: For two charges Q at (4,0,-3) and Q, at (2,0,1), find Q if Q, = 4 nC for force F at (5,0,6) has no x...

A: Since you have asked multiple questions, we will solve the first question for you . If you want any ...

Q: Vo 152 15V 10V 20Ω. 252 10Ω

A:

Q: A 22 uf capacitor has a charge of 250 uc stored on it. What is the voltage across the capacitor?

A: Here, we have given a condition, we have to calculate the voltage across the capacitor, when the cap...

Q: (iv) The electric potential varies along the x-axis as shown. The x-component of the electric field ...

A:

Q: Question 3 What are the main differences between a capacitor and an inductor? Discuss FIVE of them.

A:

Q: R

A:

Q: R jomt 2.2k2. R3

A: Given circuit shown           

Q: A 25 ohm resistor connected in series with a coil of 50 ohm resistance and 150 mH nductance. What is...

A:

Q: Question 1. A 3-phase, 3 wire load draws the following line currents: I. = 60 < 330° A I, = 78.4 < 2...

A: we have given  A 3-phase, 3 wire load draws the following line currentsIa=60∠330oAIb=78.4∠214oAIc=75...

Q: Find the value of RL in the following circuit so the load RL receives the maximum power. What is th...

A: To solve above problem one should have idea about maximum power transfer theorem : Maximum power tra...

Q: Discussed briefly the effects of the different types of compensators in control systems.

A: A compensator is a part of the control system that regulates the operation of another system. Most o...

Q: IGNORE (NOT YẾT COVERED) Find maximum power across the terminals a-b, 62 6V 603 (b)를w (d)를 W (c) 2 W

A: Here, we have given an electrical circuit having no. of resistors in series and parallel manner.  A ...

Q: Two alternators A and B delivers 100 and 150 A, respectively to a load. If these currents are out of...

A: Use pythagoras theorem to find current current drawn load.  

Q: State the frequency of the 7th harmonic of a 2KHZ sine wave? O i) 14Khz O ii) 9KHZ O ii) 5KHZ O V) 2...

A: Consider the formula for the frequency is, f=nfh

Q: 2. Apply Ohm's law to the following problems: a. A current of 0.0021 A flows to a resistor having a ...

A: By ohms law , Voltage across the resistor = current ×resistance.   

Q: A six pole , 3 phase AC generator has 72 slots, the coil span is 12. What is the pitch factor? 0.5 1...

A:

Q: An impedance coil takes 10 A and absorbs 250 Watts when connected across a 220 V, 60 Hz source. What...

A: This question belongs to circuit theory . It is based on the concept of power consumed across the re...

Q: A series RLC circuit has a Q of 75 and a pass band between half-power frequencies of 160 cycles per ...

A:

Q: A series resistance-capacitance (RC) circuit is connected to a 230 Volt, 60 cycle source. If the pow...

A:

Q: of 4 Page < Figure P6.25 P6.59. Solve for the transfer function H( f )= V out / V in Also determine ...

A: In this question we will find transfer function of given low pass filter and find out its cut off fr...

Q: 33. The equivalent resistance betw=

A:

Q: if a transformer has a primary rated voltage of 480V and requires 40V to produce the rated current i...

A:

Q: A 6.6 kV, 6 MVA, Y-connected, 3φ alternator has an effective ac resistance of 0.436Ω between termina...

A:

Q: 1. For the following truth table: A B CDG a. [2] Write the equation for G for the canonical SOP form...

A:

Q: R1 12 V 56 N 1.0 MN 3 V -12 V

A: Please refer the attached images for the complete answer..

Q: Calculate the area of the surface using the differential surface a r = 10, a/4 < o < 2a/3, 0 < ¢ < 2...

A:

Q: A series RLC circuit is excited by a 100 volts 79.6 Hz source. Resistance R is 100 ohms inductance L...

A:

Q: Jung Kook stayed at McDonald's and ordered a cup of hot coffee. When the coffee was served at around...

A: Thermometer- It is a basic device which is used to measure the temperature with the help of mercury ...

Q: The voltage obtained from several coils connected in series is 75 V. What voltage will be obtained i...

A: The emf generated in the machine is given by the expression as shown below:  E=PϕNZ60 Since the othe...

Q: 2) Simplify the following functions using ONLY Boolean Algebra a) F = Ā.B + Ā.B.Č+(A+ Č) b) F = (B(Č...

A:

Q: 11. A positively charged 9.8 nC point charge is separated from a positively charged 10.6 µC point ch...

A: 11) Given : two positively point charges 9.8 nC and 10.6 micro coulomb separated by 0.71 cm . To fin...

Q: Branch circuit that supplies outlets for lighting and appliances. General purpose Appliance Individu...

A: 1) branch circuit that supplies outlets for lighting and appliances  2) series circuit  3) current r...

Q: An alternator has a general voltage of 250 Volts. It contains 15 % 3rd harmonic and 10 % 5th harmoni...

A:

Q: What is the meaning of "system redundancy" in aircraft electrical systems? Explain why system redun...

A: We have given the following problem What is the meaning of "system redundancy" in aircraft electrica...

Q: Q1/ A piece of resistance wire, 15.6 m long and of cross-sectional area 12 mm? at temperature of 0°C...

A: (1) It is given that: L=15.6 mA=12 mm2=12×10-6 m2V=240 VI0=7.9 A  (At 0°C)        

Q: 1Ω 1.2 Q 30 A 2Ω 8Ω 12 2 ww ww ww

A:

Q: What is the time-delay, order and gain of the following discrete-time transfer function for a step i...

A:

Q: It is the ratio of the units of electricity generated per year to the capacity of the plant installe...

A: The ratio of the units of electricity generated per year to the capacity of the plant installed in t...

Q: A long Shunt Compound Generator delivers a load current of 20A at 200V and has armature, series fiel...

A: Ans:-          IL= Ia + Ish  Ish=VtRsh=200250=0.8A Ia = 20-0.8=19.2 A                              ...

Q: The value of T0 in the following circuit equals: 1kn 3 k2 8 mA 'Io a. 8 mA b. 2 mA

A:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.