= COSx[n]70The sequencewas obtained by sampling a continuous time signalx(t) = cos(@ot), -∞ < t < 00at a sampling rate of 1000 samples/s. What is the possible positive values of wo that could have resultedin the sequence x[n].4n-∞< < 00

Given, Sampling rate = 1000 samples/sec Fs = 1000 Hz so, T =1Fs=11000sec

Answered: at could have result

Engineering

Electrical Engineering

at could have result

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Hiw for the System shown determine of K for systemm is stable? loo 10 Lec. Sa

A: First we will find characteristics equation from given block diagram and than using routh horwitz…

Q: The two plants have fuel cost expressions given by: C₁ = 2P₁ +0.002P² Sh. C₂ = 2P₂ +Y₂P² $/h. Given…

A: Given Each plant rating =400 MW Loss coefficients B11 =0.4×10-3 MW -1 B22 =0.3×10-3 MW -1 Power…

Q: An aluminum transmission line is to be replaced by copper having the same total resistance. If the…

A: Resistivity of aluminum = 17Ω-CM per ft Resistivity of cooper = 10.37Ω-CM per ft

Q: 14.a. A typical 5-kV system is one with a phase-to-phase voltage of _______ volts. A. 2400 B. 12,470…

A: 14. a) For any electrical equipment, the voltage mentioned in the nameplate details is the Line-line…

Q: What is the circuit breaker,types and how it is work?

A: a circuit breaker is a mechanical device that is used to open any type of electrical contact or to…

Q: (b) Define the five of the following: Ampere's Law, Gauss's Law of electric field, Standing wave,…

Q: 1 -3 -2 -1 0. 1 4 5 time in seconds Whed signal is plotted above? a) rect(t/2) * rect(t/2) (b)…

Q: The minimum SOP: (using Karnaugh's Map)

Q: es could the Network Laws have over the simple Series and

A: The various network laws such as the KVL and the KCL is used to determine the current and voltage of…

Q: the circuit shown in the figure, a voltage with a peak value of 212.16 V is applied to the input of…

Q: What is the maximum length in km for 3 phase transmission line having conductor of 0.875 square…

Q: An over head transmission line supported from two towers. The high of the two towers are 30 m and 20…

Q: Which of the following information cannot be obtained from the wind rose? a. Wind speed b. Wind…

A: Given: Which of the following information cannot be obtained from the wind rose?

Q: Write the relationship between λ and power demand when the cost curve is given

A: The relationship between λ and power demand when the cost curve is given can be expressed using the…

Q: Q.1) By using Nodal theorem find (i,). 8i, 30

A: Let's find the value of i1 using the nodal analysis.

Q: Reply as soon as posible 1) What is the equation of node v1, node v2 and node v3? Format answer:…

A: In this question, 1) What is the equation of node v1, node v2 and node v3 ? 2) What is the…

Q: Impedance is an AC quantity is composed of both resistance and ______________. A. complexity B.…

Q: The towers of height 35 m and 95 m respectively support a transmission line conductor at water…

Q: esign a simple matching network of your choice to match a 73 ohm load to a 50 ohm transmission line…

A: A Lumped element model is used to describe the behavior model of a circuit, lumped elements that can…

Q: A long transmission line of 370 N surge impedance is connected to two cables each of surge impedance…

A: According to question we have to calculate the value of junction voltage, current wave and voltage…

Q: Quiz-1: Establish Zpus for the system shown in figure below using Direct Method? jo.1 jo.1 0.25…

Q: a) If the load on a 50-ohm transmission line were a 25-ohm resistor, what would the VSWR be? b)…

A: Hello. Since your question has multiple parts, we will solve first question for you. If you want…

Q: What is the maximum length in km for a 1-phase transmission line having copper conductor of 0-775…

A: We have been asked to find the maximum length in km for 1-phase transmission line having, Copper…

Q: 1. Compare the methods for power transmission with respect to usage, cost, connection, stability,…

A: Transmission Line: A transmission line is a specialized cable or other structure used in electrical…

Q: - Will this transmitter meet your needs? a. Yes b. No - Express the GLB transmitter power output in…

A: <a> 4 GLB transmitter has output power level of +22 dBm. i.e 10 log (1000…

Q: True

Q: The 100V source is absorbing 50w of power in the network shown what is the value of R and what power…

Q: What is the maximum length in km for 1 phase transmission line having conductor of 0.775 square…

Q: The char. impedance of the trans. line is 50-Ohm and the resistance of it is 0.1Ohm/meter. What will…

A: For the distortion less transmission line the attenuation constant is independent of the frequency.…

Q: Q. No. 03 A watershed of (50+Roll No) km² has two different soil types and land uses. 70 % of the…

A: Given Roll no. = 0586 The total area is, A=50+Roll no.=50+586=536 km2 CN1 = 81 has 70% area. A1=70%…

Q: A signal of 0.1 kW is transmitted in a cable. The attenuation of cable is -5 dB per km and cable…

A: According to the question, a signal of 0.1 kW is transmitted in a cable. the attenuation of cable is…

Q: high-voltage power line is made of aluminum conductor steel reinforced (ASCR) material. Suppose a…

Q: atts. a. I*2R(read I squared R) b. Elcosθ c. both a and b d. conjugate method 3. The product…

A: Through these questions the basic understanding of apparent power, real power and reactive power is…

Q: Example: Transmitter devive broadcasting AM-DSB, if the total power is 5 kw at 0.6 modultion index…

Q: lectrical transmission line cable is su O N/m and the maximum sag is 18m,

A: Given: Supported between tower apart length = 150m Cable weight (w)= 30N/m Maximum sag (h)= 18m

Q: Fill in the blanks: a) HW: 13Vrms = Vave = _Vpk; b) FW: 45Vpk = Vave = Vrms; c) FW 80Vpk-pk = Vave =…

A: In this question we will find value of rms , avg ...

Q: A 2 kW carrier is to be modulated to a 90% level. The total transmitted power would be

A: Modulation is process by which some properties of carrier signal is varied according to modulating…

Q: Explain the operation of LODSB,LODSW,OUTSD.

A: Assembly language- An assembly language describes the same sequence of instructions, but using…

Q: What is the swept area of a wind blade with length 5m?: O a.25.7 square meter O b. 15.7 square meter…

A: blades are in circular shape so we can use area formula of circle that is area = πr2

Question

= COS
x[n]
70
The sequence
was obtained by sampling a continuous time signal
x(t) = cos(@ot), -∞ < t < 00
at a sampling rate of 1000 samples/s. What is the possible positive values of wo that could have resulted
in the sequence x[n].
4
n
-∞< < 00

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

How does a circuit breaker work in a power system, and what is its role in protecting the system from faults?
Measuring the noise coefficient of a microwave receiver frontal section using the Y-factor method. wanted. A noise source with 23 dB extreme power ratio (ENR) and a liquid nitrogen The Y-factor ratio is measured as 14.83dB using cold load (77 * K). Of the recipient Find the noise coefficient.
i need the answer quickly
Q#5:What is the need for frequency regulation in power system network?
Determine the voltage across the 700 l resistor. v }ro0n 100V 5000 500n 2002 а. 46.7 V b. 31.2 V c. 56.3 V d. 41.9 V e. 51.2 V f. 38.6 V
RELATED TO POWER SYSTEM WRITE SHORT NOTE ON a)WHAT IS UNSYMMETRICAL LINE ? b) WHAT IS AREA FREQUENCY CHARACTERISTICS?
a) h) P. =AB (B) = PJE (3.8) b) P = P-P 100 16 = 84 watt c) P, = 2AJ} (B) = 2 x 100 x J(3.8) = 34 watt AC Н.W A carrier signal given by 10 cos 2n x 10ºt volt is FM modulated by single tone Hz message 4 cos 2n x 10°t volt if the modulation constant is 1000 vol Kf Am a) Compute max. frequency deviation and deviation ratio.A. F b) Write the equation of modulated wave. Ac c) Sketch the spectrum. d) Calculate sidebands carrier and total power. 42
55 Question 20 What is the maximum length in km for 1 phase transmission line having conductor of 0.775 square centimeter area over which 220kW at 0.8 power factor and 3500V are to be delivered? The efficiency is 80% and specific resistance is 1.825 micro cm.: a. 628.5 b. 18.91 c. 528.5 d. 22.85
3. 54.4*10=40001Log, CaSNR)