As shown in the figure below, water behind a dam enters an intake pipe at a pressure of 24 psia and velocity of 5 ft/s, flows through a hydraulic turbine-generator, and exits at a point z₁ = 300ft below the intake at 19 psia, 45 ft/s, and a specific volume of 0.01602 ft3/lb. The diameter of the exit pipe is 5 ft and the local acceleration of gravity is 32.2 ft/s². Water PI=24 psia V₁-5 ft/s Dam /day Generator HH Turbine P₂ = 19 psia 2-0.01602 fb V₂-45 ft/s ₂-5 ft Water Evaluating the electricity generated at 8.5 cents per kWh, determine the value of the power produced, in $/day, for operation at steady state and in the absence of internal irreversibilities. Value = $i

As shown in the figure below, water behind a dam enters an intake pipe at a pressure of 24 psia and velocity of 5 ft/s, flows through a hydraulic turbine-generator, and exits at a point z₁ = 300ft below the intake at 19 psia, 45 ft/s, and a specific volume of 0.01602 ft3/lb. The diameter of the exit pipe is 5 ft and the local acceleration of gravity is 32.2 ft/s². Water PI=24 psia V₁-5 ft/s Dam /day Generator HH Turbine P₂ = 19 psia 2-0.01602 fb V₂-45 ft/s ₂-5 ft Water Evaluating the electricity generated at 8.5 cents per kWh, determine the value of the power produced, in $/day, for operation at steady state and in the absence of internal irreversibilities. Value = $i

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Answer the following questions about air flowing through a nozzle as shown in the schematic below. The air enters the nozzle at 2.2 kg/m³ and 34 m/s and leaves at 0.72 kg/m³ and 130 m/s. The nozzle inlet area is 60 cm². The mass flow rate is 4.5 kg/s. The outlet cross-sectional area is 1 cm². P1 Nozzle V₂ P2
pls answer the given thanks
Liquid water is subjected to some process between an initial state of P1 = 52 psi, T1 = 43°F and a final state of P2 = 100 psi, T2 = 55°F. Determine the change in specific entropy, As12 (Btu/lbm-°R). Your Answer:
A 20 kg/s steam enters a turbine at an initial enthalpy of 2456kJ/kg and exits at 1987 kJ/kg. If the kinetic energy of the steam decreases by 10 kJ/s, how much is the turbine work? Draw a schematic diagram,andthen plot the state/s and process, whichever is applicable in a t-sdiagram
Parvinbhai
8. In a steady flow apparatus 135 KJ of work is done by each kg of fluid. The specific volume of the fluid, pressure, and speed at the inlet are 0.30 m³/kg, 600 kPa, and 16m/s. The inlet is 32m above the floor and the discharge pipe are at floor level. The discharge conditions are 0.60 m³/kg, 1 bar, and 270 m/s. The total heat loss between the inlet and discharge is 9KJ/kg of fluid. In flowing through this apparatus, does the specific internal energy increase or decrease? And by how much?
3. A fluid system undergoes a non-flow frictionless process from 5.5 ft to a final volume 2.5 ft in accordance with the defining relation P= 60/V + 23 psi, where volume is in ft. During the process the system reject 30 BTU of heat. Determine the change in enthalpy and internal energy.
Air at 200 kPa, 20 oC and 5 m/s enters a cylindrical pipe of diameter 28 cm and exits at 180 kPa and 40 oC. Assuming the air is heated as it flows through the pipe and that the diameter of the pipe is the same at both the inlet and outlet. Calculate the volumetric flowrate (in m3/h) of air out of the pipe Select one: a. 1411.2 b. None of the options c. 0.392 d. 1.09 x 10-4 e. 8.552 x 10-5 f. 0.3079 g. 1108.4
A nozzle is a system which converts some of the entering energy into kinetic energy. No shafts are turned within this system and no heat loss. Let the nozzle receive 2,400 lb/hr. of steam at p1 = 200 psia, v1 = 2.29 cu.ft./lb., u1 = 1113.7 Btu/lb., and negligible speed. At the exit, p2 = 14.7 psia, v2 = 26.77 cu.ft./lb., and u2 = 1077.5 Btu/lb. What is the exit speed in mph?
As shown in the figure below, water behind a dam enters an intake pipe at a pressure of 24 psia and velocity of 5 ft/s, flows through a hydraulic turbine-generator, and exits at a point z₁ = 140ft below the intake at 19 psia, 45 ft/s, and a specific volume of 0.01602 ft³/lb. The diameter of the exit pipe is 5 ft and the local acceleration of gravity is 32.2 ft/s². Water Value = $i P₁ = 24 psia V₁ = 5 ft/s Z1 Dam /day Generatori Turbine H P2 = 19 psia 22=0.01602 ft³/lb V₂ = 45 ft/s = 5 ft Evaluating the electricity generated at 8.5 cents per kWh, determine the value of the power produced, in $/day, for operation at steady state and in the absence of internal irreversibilities. Water
As shown in the figure below, water behind a dam enters an intake pipe at a pressure of 24 psia and velocity of 5 ft/s, flows through a hydraulic turbine-generator, and exits at a point z1 = 120ft below the intake at 19 psia, 45 ft/s, and a specific volume of 0.01602 ft/lb. The diameter of the exit pipe is 5 ft and the local acceleration of gravity is 32.2 ft/s?. Water Dam P = 24 psia V-5 f/s Generator Turbine P- 19 psia = 0.01602 nAb V,-45 t/s Dz-5ft Water Evaluating the electricity generated at 8.5 cents per kW - h, determine the value of the power produced, in $/day, for operation at steady state and in the absence of internal irreversibilities. Value = $ /day