Apply Thevenin or Norton   In the following circuit, it is sought that the resistor Rz has the load at full power Please calculate the ohmic values of Rz in such a way that it consumes the maximum power in the different time bands; indicate the value of these powers S1 S2 Time Open Open 3pm to 10pm (Focus this case please)

Q: An impedance equal to 44∠69º is connected to across a 220 volts source what should be the value of a…

A: Given,Impedance, Z1=44∠69° ΩVoltage, V=220 V

Q: Determine V₁ and X2 Show complete elimination 80A (1 or using nodal solution V₁ 102 X2 rubstitution.…

A:

Q: A signal generator having a source resistance of 50 2 is set to generate a 1 kHz sinewave. Open…

A: Solution !!

Q: Convert 287 μL to dL Write your answer on the blank below, including units

A:

Q: 2. Determine the Total Current and currents passing through each of the resistance. Also, determine…

A: The node-voltage technique is an organized procedure for generating a group of simultaneous…

Q: Q5) Determine the following: A. find the equation of the following circuit in the figure Q5A, and…

A: SOLUTION  NOTE             PART-A is INCOMPLETE question because…

Q: 17. Find the amplitude and frequency of the following waves: a. 20 sin 377t b. 12 sin 27 120t

A: a) Given: The wave is 20sin377t.

Q: Consider the circuit shown below. Calculate The voltage across R4 resistor. 12 V R1= 20 22 M R4= 80…

A:

Q: Q4 Determine the voltage Vin the circuit 2Ω 2Ω 10 V +1 1Ω + 1Ω<V ΤΩ

A: Given data, Circuit diagram is given as,

Q: 5. Write an assembly language program to convert an 8-bit binary data to BCD. The binary data is…

A: Solution !!

Q: Calculate the equivalent impedance of a circuit in which a coil of wire having a value of 5∠53.2ºohm…

A:

Q: 4.) To preset the a JK flip-flop to the binary 1 state, which of the following conditions must…

A:

Q: Simplify the following block diagram and determine the overall transfer function of the system Y(s)/…

A:

Q: Find v and i. 14 V(+ Μ 4Ω 3Ω +:ι 6V 2Ω ww 6Ω Answer: -400 mV, 2.8 A.

A:

Q: Answer in 4 sentences only. 4. What happens to current when resistance is increased? 4

A: We need to tell about the effect of resistance on current .

Q: SOLVE FOR THE UNKNOWN CURRENTS AND VOLTAGES ASKED  source: 208V balanced line to line  Line 1:…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: Explain with drawing Filtering scheme for the generation of VSB modulated wave

A: We need to be explain with diagram Filtering scheme for the generation of VSB modulated wave

Q: Q2) convert the following: 1- decimal number to binary by using the repeated division by 2 method…

A: Introduction DIGITAL NUMBER SYSTEM Many number system are used in digital technology. A number…

Q: 3. A DC generator has no-load output voltage of 200 volts. Its armature circuit resistance is 0.75…

A: In this question we need to find power delivered to load by given generator.

Q: Given the Fourier Cosine Transform F(w)= (2/Pi)a/(a^2+w^2) use integration to find the Inverse…

A: Given: F(ω)=2π×aa2+ω2 To find:  Inverse Fourier Cosine Transform, f(t)

Q: PROBLEM #3 FOR THE CIRCUIT SHOWN (a) IF Vg = 1KV AND ig = 5MA, FIND THE VALUE. OF R AND THE POWER…

A:

Q: 5 : problem Deler mine whether the following eningy or power signals? Find the energy or accurage…

A:

Q: A voltmeter with internal resistance of 50 2 and a FSD current of 200 mA. Then, the series…

A: Given a voltmeter with, Internal meter resistance, Rm=50 Ω. Meter current, Im=200 mA. So meter…

Q: (b) Consider a pulse shape p(t) = A () where the triangular function A(x) is defined as A(x) = () =…

A:

Q: 4. Unless the state of a NAND gate latch is being change, its inputs should both be a. high b. low…

A: The NAND Gate latch is as shown below,

Q: 2. Using source transformation, find ix. 50 M 105 Hix RASTA 2A BUTTE 1641 100V (+) DO NOT Report…

A: We need to find out the current for given circuit . We will do source transformation for given…

Q: For the voltmeter circuit shown in the given figure, the basic D' Arson Val meter used has…

A: Given - Full scale meter current = 1 mA , Meter resistance,Rm=100Ω ,   To find - Value of R1 and R2.…

Q: Can I please have the part a  handwritten? I can't tell which variable has the bar sign

A:

Q: D4.9 A 240/120-V 60-Hz ideal transformer is rated at 5 kVA. a. Calculate the turns ratio. b.…

A: Given: V1V2=240120, f=60 Hz and transformer is rated at 5 kVA.

Q: C1 ㅔ 10HF R1 430km Rc2 22.2k0 C2 수 10μF Q RE2 1.2ko 1SV B=100 C3 40μF Find a Q-point and draw the…

A: We need to find out the Q point , collector current and collector to emitter voltage for given…

Q: 120 V fo Ideal diodes 2.2kQ 2.2 ΚΩ 2.2 k

A:

Q: Given Using the Fourier inverse transform inverse g(t) = ? O a. O b. О с. O d. G (w) = 28 (w-50) + 8…

A: In this question,  We need to choose the correct options What is inverse Fourier transform of the…

Q: The root locus plot of a system intersecting the constant damping ratio line is shown in below…

A: Given data: The diagram is shown below,

Q: 5. Find the power delivered to an element at t=3ms if the current entering its positive terminal is…

A:

Q: The value 1.2 x 10-6 can be expressed as O 1.2 μ or micro O 1.2 M or Meg O 0.00012 O 1.6 E2

A: Given: The given value is 1.2×10-6.

Q: what will be the center of the frequency in Hz?   If the value of C = 0.2 microfarad and the…

A: The filter seperate some unwanted components from other. The low pass filter pass signal below…

Q: In the magnetic circuit of Example 4.4, an air gap of length 0.5 mm is cut in the lower leg of the…

A: Given data are: The cross-sectional area of the core, Ac=12 cm2=12×10-4m2 Length of the core,…

Q: INSTRUCTION 1. Simplify the given logic equation then draw the final circuit. X- (AB + BC) + BC (B +…

A:

Q: A 220 resistor dissipates 3 W. The voltage is 73.3 V 2.5 V 25.7 V 257 V

A: Given: Resistance of resistor, R=220 Ω. Power dissipated in resistor, P=3 W.

Q: 2. Compute the root-mean-square value of voltage in a delta-connected alternator with 200 volts per…

A: Given data, Vp=200 V per phase

Q: 9. A 110-V shunt generator has a full-load current of 100 A, shunt field resistance of 55 22 and…

A: It is given that: V=110 VIL=100 ARsh=55 ΩConstant losses=500 WFull load efficiency=0.88 The…

Q: discrete state. 3. A BCD counter can assume 4. A BCD counter can divide its input signal frequency…

A: A binary Decimal Counter(BCD) is a special counter which counts from 0 to 9.

Q: SOLVE FOR THE UNKNOWN CURRENTS AND VOLTAGES ASKED  source: 208V balanced line to line  Line 1:…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: Answer in 4 sentences only. 2. How does a multi-meter measure resistance?

A: Multi-meter: Multi-meter is a measuring instrument. It is used to measure various electrical…

Q: Calculate the Total Resistance, Total Current and Total Voltage of the circuit. I already provided a…

A: The required parameters can be calculated by using the mesh analysis and resistor reduction…

Q: Balanced 380 VLL, 30 an-bn-cn Source a Three-Line, Impedance Diagram of the Sample System 0.5 +1.50…

A: “Since you have posted a question with multiple sub-parts, we will solve minimum first three…

Q: Question # 1: Find the transfer function, G(s) = V1(s)/V(s) 0000 1H v(1) 192 elle 192 www 1 H elle +…

A:

Q: A capacitor is charged with 5 mC. If the energy stored is 625 mJ, determine the voltage across the…

A:

Q: Determine the inverse laplace trasnform for the functions below: a) F(s) = (35) /(s(s+5)(s+7)) b)…

A:

Q: 7. What is the purpose of the delta-wye transform as applied to resistor networks? Give an example…

A: Solution 7- Start-delta conversion- For star connection of resistance as Ra Rb and Rc- Now it can…

Code Conversion

The method or technique used to convert code from one format to another is termed code conversion. Code conversions are most commonly used in computers, digital electronics, microprocessors, etc.