show complete and step by step solution with ts diagram illustration. REGENERATIVE CYCLE AN ENGINE In a Regenerative cycle, the steam isextracted from the turbine at 2MPAand 250C for feedwater heating and itis mixed with condenser exit at at30kPa after pumping. Determine thefraction of vapor extracted from theturbine.0.38550.236400.193800.5644

Ans : 0.2364 Second part is correct.

Answered: and step by step solution with ts…

Engineering

Mechanical Engineering

and step by step solution with ts diagram illustration. REGENERATIVE CYCLE

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Give an Example of a problem on Actual Reheat rankine cycle with complete solution and compare it…

Q: What is the difference between Reheat Regenerative Cycle and Regenerative Cycle. Which is more…

A: Given Reheat Regenerative Cycle Regenerative Cycle To find Difference Efficent

Q: he stroke and bore of a four stroke spark ignition engine are 250 mm and 200 mm respectively .The…

Q: Problem 3. A simplified Rankine cycle and some data are given in the figure below. a. Show the…

A: Given: Boiler pressure=6MPa Condensor pressure=50kPa Mass flow rate (m)=22kg/s

Q: An Atkinson cycle has state 1 as 200 kPa, 300 K, compression ratio of 11 and expansion ratio of 15.…

Q: H.W. 3.1 Find the cycle efficiency and specific steam consumption of a reheat cycle operating…

A: ACCORDING TO COMPANY GUIDELINES, WE CAN SOLVE ONLY FIRST QUESTION. KINDLY REPOST THE SECOND QUESTION…

Q: 19. The heat added in a Carnot cycle is 1000 KW and heat rejected is 600 KW. If minimum temperature…

Q: How many reheat stages possible in Rankine Cycle and why?

Q: Q 3) An engine working on U cycle has a Compression ratio of IS and Cutt- off takes place at 5% of…

A: Given: Compression ratio: →r=15=V1V2 Because cut off takes place at 5% of the stroke. Hence cut off…

Q: May you please explain each steps. Thank you

A: Given data as per question Compression ratio =6 Maximum temperature = 11000 C Presurre at entry =…

Q: At the beginning of compression in a diesel cycle T= 300 K, P= 200 kPa an after combustion (heat…

Q: Provide the given, manual step by step solution, and diagram of below problem. The heat added to a…

Q: U. revers cycle operating a neat pump has an ev ol ondenser temperature of 50°C. Find the…

Q: 18. A Brayton cycle has an efficiency of 40%, find the pressure ratio. A. 5 C. 7 B. 6 D. 8

Q: Air in a Carnot engine in which Tc = 26.8.C and the total cycle efficiency is n = 2/3. Find TH , the…

A: Air in carnot cycle Given lower temperature = TC = 26.8 °C = 299.8 °K Therefore

Q: A gasoline 4 cylinder, 4 stroke engine having: Compression ratio = 75 Volume 1.8 liters, T1 = 50…

A: Gasoline engine /Petrol engine Given, Pressure, P1=90KPaTemperature, T1=50°C=323KVolume,…

Q: Q.5 – A simple Rankine cycle works between pressures (28 bar and 0.06 bar). The initial conditions…

A: T-S diagram of the Rankine cycle,

Q: Len figur employ ing that h air ar

A: introduction we have to find out efficiency and specific heat are same for air and gas.

Q: In a standard Brayton cycle, the heat added is 20kW while the heat rejected is 8kW. Find the…

A: Write the given data. Qin=20 kWQout=8 kW

Q: eam enters the turbine of a plant a MPa and 50OC. Steam at flow rate 7.6kg/sec is extracted from the…

A: Ans: 43.13%

Q: Enlist and Draw (only) the modifications made in Rankine cycle on T-S diagram. Also draw the flow…

A: Modification made in Rankine cycle: In the modified Rankine cycle the pump work is neglected.…

Q: Draw an actual condition of a block diagram and T-S diagram of a gas turbine power plant using inter…

Q: Explain inclusion of reheat and modern regenerative arrangement in ideal Rankine cycle to improve…

Q: Provide complete solution and detailed diagram. An Otto cycle has a heat added of 1000 Btu and…

Q: air-standard Compression Ignition cycle has a compression ratio of 18.2. Air is at 3200°R at the of…

Q: A four stroke gasoline engine runs on Otto cycle at 1500 RPM has an inlet state of 90 kPa, 25°C.…

A: We have given

Q: 1.Give the TS and PV diagrams of Regenerative Rankine Cycle

A: The main components of a Rankine power plant cycle are: Steam turbine Boiler Condenser Pump

Q: Match the state of the working fuid at the respective points showed in the TA Match the following…

A: For figure 1 (simple rankine cycle) Point 4 - saturated liquid.

Q: d and compare the efficiency of the simple ideal Rankine cycle engine operating between 20 and 100…

Q: Ql: Calculate the thermal efficiency of an engine working on the otto eycle. The bore and the stroke…

A: Given Bore, d = 17 cm Stroke, l = 30 cm

Q: 1. a. derive expression for thermal efficiency and backwork ratio for the Rankine cycle

A: Derivation of thermal efficiency Heat addition q1=h4-h2 Heat rejection…

Q: Q2/ A gas-turbine power plant operates on the simple Brayton cycle with air as the working fluid and…

A: To find: Efficiency of the Brayton cycle.

Q: Engine work on the reversible cycles as shown, work output from the engine ?

Q: An ideal diesel engine uses air as the working fluid. The state of the air at the beginning of the…

A: (a) To find: The thermal efficiency of the ideal diesel cycle. Given: The initial pressure is P1=95…

Q: What is the thermal effiviency of an air stand and Brayton cycle if the Pressure ratio 10?

Q: Using appropriate diagrams, show the differences between an open cycle and a closed cycle gas…

A: There are only three components in open cycle gas turbine i.e., Compressor, Combustion Chamber and…

Q: A gasoline engine with four stroke and total displacement of 150 in3. and a compression ratio of…

Question

show complete and step by step solution with ts diagram illustration. REGENERATIVE CYCLE AN ENGINE

In a Regenerative cycle, the steam is
extracted from the turbine at 2MPA
and 250C for feedwater heating and it
is mixed with condenser exit at at
30kPa after pumping. Determine the
fraction of vapor extracted from the
turbine.
0.3855
0.23640
0.19380
0.5644

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

1. Give atleast 5 Advantages of Reheat Cycle in Thermal Power Plant. 2. Give atleast 5 Dis-advantages of Reheat Cycle in Thermal Power Plant. 3. How many reheat stages possible in Rankine cycle and why?
pls send me in 30 min show full steps subject (thermo 2)
An air standard gas turbine engine operates on an overall pressure ratio of 4 and between the temperature limits of 70 F and 1600 F Assuming constant specific heats, evaluate the compressor work. Find: (a) For ideal cycle: (b) calculate the turbine work (c) calculate the thermal efficiency Show complete solution on a paper.
Derive the expression for efficiency of reheat cycle and compare with rankine cycle.
Hello, I need help with the following thermodynamics problem.Thank you! The compined cycle plant shown in figure uses a gas turbine engine operating with 250 kg/s of air entering at 300K and pressure ratio of 12.5.Use an idea air-starndard cycle as a model of this engine and assume the turbine inlet temperature is 1400K. The steam cycle operates in a simple rankine cycle between 10MPa and 70kPa.
Give one example problem with solution of reheat regenerative cycle
Why T-s and P-v for Brayton cycle looks different while they look similar for Rankine cycle?
A Simple Rankine cycle works befween pressures 38 bew 38 bar anod la bar, bhe instial cotkibion of the cycle eppieiency, uorks vabo and speeipic stéam eansumption. steam beang odry saburtaech, Calau tabe 38 bar 子 lo ber
Provide clear/complete solution and detailed diagram for this problem. An Otto cycle has an initial temperature of 27oC and 102 Kpa air. The compression ratio is 10and the maximum temperature of the cycle is 1500oC. Find the mean effective pressure. A. 453.34 Kpa B. 578.27 Kpa C. 960.79 kpa D. 836 kpa
What is the highest temperature attainable of an otto cycle engine that have compression ratioof 15, the energy input from fuel is 500 kilojoules per kilogram and it operates at an ambient airtemperature of 25 degrees Celsius.
Derive Detive the expression for efficiency of Reheat cycle and Compare with Rankine'cycle.
Give neat solution in text.