▪ An unlined canal under regime conditions along with a silt factor of 1 has a width o flow 71.25 m. Assuming the unlined canal as a wide channel, the corresponding averag depth of flow (in m, round off to two decimal places) in the canal will be fu 1 D=? B = 71.25 m D

▪ An unlined canal under regime conditions along with a silt factor of 1 has a width o flow 71.25 m. Assuming the unlined canal as a wide channel, the corresponding averag depth of flow (in m, round off to two decimal places) in the canal will be fu 1 D=? B = 71.25 m D

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Calculate the Mannig's roughness co-efficient for the channel?

A: Given, Open channel width= 5 m Bed slope= 0.001Uniform flow depth= 2 m Velocity,v= 2 m/sCalculate…

Q: An unlined canal under regime conditions along with a silt factor of 1 has a width of flow 71.25 m.…

A: An unlined canal under regime condition with,

Q: A stable channel is to be designed for a discharge of 40m³/s and the silt factor of unity. Calculate…

A: Discharge, Q = 40 m3/sSilt factor, f = 1

Q: An unlined canal under regime conditions along with a silt factor of 1 has a width c flow 71.25 m.…

Q: In Thakurgaon district, a man-made channel is to be constructed parallel to Shuk river 500 m away…

A: Groundwater: The water which is present under the ground surface of the earth is known as…

Q: The figure below shows two flow lines for seepage across an interface between two soil media of…

Q: Determine the time of concentration for use in the Rational Method for a drainage basin having the…

A: Average Grass Overland flow length, L = 80’ Slope, S = 2.5% Shallow Conc. L = 450’ S = 4.8%…

Q: Q- An unlined canal under regime conditions along with a silt factor of 1 has a width of flow 71.25…

A: Given Data Silt factor (f) = 1 Width of flow (B) = 71.25 m Assume unlined wide channel Find…

Q: in a border irrigation run, Q= 8 /s, n= 0.15, and S=0.45%. The water depth at the inlet can be…

A: given data: discharge at depth=Q=8 lsn=roughness coefficient=0.15slope of border strip=0.15

Q: Question- The silt factor is 1.2. If the channel is designed by Lacey's theory which has a mean…

A: Given- Silt factor f=1.2, Mean velocity V=1.5 m/s, It is needed to find the hydraulic mean radius of…

Q: A channel designed by Lacey's theory has a velocity of 0.88 m / sec. The silt factor is 1.1. Then…

A: Given data :- Velocity = 0.88 m/s silt factor = 1.1 To determine the hydraulic mean depth will be

Q: in a border irrigation run, Q= 8 l/s, n= 0.15, and %3D S=0.45%. The water depth at the inlet can be…

Q: A channel designed by Lacey's theory has a mean velocity of 1.1 m/s. The silt factor is 1.1. Then…

A: given- mean velocity v=1.1 m/ssilt factor f=1.1

Q: A rectangular open channel has a width of 5 m and a bed slope of 0.001. For a uniform flow of depth…

Q: In a homogenous earth dam, total head loss through the soil is 25m. The flownet drawn in the dam…

Q: A Trapezoidal canal is designed in alluvial soil using Lacey's theory to fulfill the irrigation…

Q: .Hydraulic jump occurs in a 4 m wide rectangular channel. Discharge in channel 7.5 m^3 /s, hydraulic…

A: Hydraulic jump : It is a sudden rise in level of water due to any shock or sudden discharge near…

Q: In a wide rectangular channel (R~yO), if the normal depth is increased by 20%, the discharge would…

A: Given-Wide rectangular channel-Normal depth is increased by 20%,It is needed to find the % increase…

Q: 8-20. The Duboys method using dso.

A: Since the question number to be solved is not stated, the solution for Question 8.20 is as follows:…

Q: Calculate the Mannig's roughness co-efficient for the channel?

A: Given. Rectangular open channel has width,b= 5 m Slope= 0.001 Uniform flow of depth= 2 m Velocity,v=…

Q: unconfined aquifer which is 33.2 m thick. The drawdown at the pumping well is 1.34 m and the…

A: According to given data A 0.34 m diameter well fully penetrates an unconfined aquifer which is 33.2…

Q: Water flows through a fully confined sand aquifer with a piezometric head gradient of 0.025. (a) If…

A: Given head gradient = hydraulic gradient i=0.025and hydraulic conductivity K=1.72 m/dayporosity…

Q: In culverts design under outlet control, if the desired Manning coefficient is 0.02. The corrected…

A: 1- If the desired manning's coefficient is 0.02 the culvert length can increase or decrease…

Q: The critical velocity ratio for a depth of flow 2.5 m in alluvial channel is 1.25. If the manning's…

Q: 5. A radial flow circular sedimentation tank 22 m diameter treating 10,000 m%d of water has an…

Q: An unlined canal is designed for a discharge of 12 m³/s. If the silt factor is 1 and the width of…

A: Given- Discharge Q=12 m3/sSilt factor f=1,width of canal b=10 m,Scour depth = ?

Q: A channel designed by Lacey's theory has a mean velocity of 1.1 m/s. The silt factor is 1.1. Then…

Q: Question 3 Consider a wide rigid-boundary canal with bed slope of 0.004, Manning's n = 0.18 and…

A: Given- Wide-rigid boundary canal- Bed slope S=0.004, n=0.18, Depth of flow y=0.88 m It is needed to…

Q: The completed flow net for the dam shown in Figure 1. The coefficient of permeability for soil is…

A: This question is related to the Seepage flow from Soil Mechanics. In this question we calculate…

Q: The critical velocity ratio for a depth of flow 2.5 m in alluvial channel is 1.25. If the manning's…

Q: Given the coefficient k =0.05 m/s and porosity p = 48%, find the transmissibility (T) in m/s per…

A: Given: The coefficient of permeability is 0.05 m/sec. The porosity is 48%. The width of the aquifer…

Q: 07. An unlined canal under regime conditions along with a silt factor of 1 has a width of flow 71.25…

A: Given an unlined canal under regime conditions along, Silt factor of 1 Width of flow, (As assuming…

Concept explainers

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.

Question

I
An unlined canal under regime conditions along with a silt factor of 1 has a width o
flow 71.25 m. Assuming the unlined canal as a wide channel, the corresponding averag
depth of flow (in m, round off to two decimal places) in the canal will be
D=?
B = 71.25 m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

The figure below shows two flow lines for seepage across an interface between two soil media of different co-efficient of permeability. If entrance angle a₁ = 30°, the exit angle a2 will be k, = 1.0 x 10-7 m/s al al a2 k, = 4.0 x 10-7 m/s a2
What will be the value of hydraulic gradient during the flow over length of 30 m and head loss of 5 m is occurred during the seepage.
A Trapezoidal canal is designed in alluvial soil using Lacey's theory to fulfill the irrigation needs. The cultural command area of the canal is 3000 hectares. The peak discharge required in Rabi season is 3 m³/s and peak discharge required in Kharif season is 5 m³/s. If the mean size of the sediment particles is 0.3 mm. Then the hydraulic radius that should be adopted for the channel is about
For a Sarda Fall, and using the data given below: • Canal full-supply flowrate, Q = 12 m³ /s U/S Full-supply level, Lu/s = 50.0 m • D/S Full-supply level, Lp/s = 48.8 m • U/S Bed level = 48.4 m %3D D/S Bed level = 47.2 m • U/S and D/S Bed width = 10.0 m %3D • Side slope = 1 (H): 1 (V) • Assume 1st trial of top width = 0.8 m %3D Determine the drop in water level, the crest length, the shape and dimensions of the fall section, and its crest level. Check the assumed value of the top width and draw the fall section.
I An unlined canal under regime conditions along with a silt factor of 1 has a width o flow 71.25 m. Assuming the unlined canal as a wide channel, the corresponding averag depth of flow (in m, round off to two decimal places) in the canal will be D=? B = 71.25 m
The depth of the flow in an alluvial channel is 1.5 m. If critical velocity ratio is 1.1, and Manning's roughness coefficient is 0.018, the critical of the channel as per Kennedy's method is?
I An unlined canal under regime conditions along with a silt factor of 1 has a width o flow 71.25 m. Assuming the unlined canal as a wide channel, the corresponding averag depth of flow (in m, round off to two decimal places) in the canal will be D=? B = 71.25 m
Consider a regime channel having a discharge of 50 m3/s and silt factor 1.10. The hydraulic radius for the given channel is
Solve this asap please
Question A channel designed by Lacey's theory has a mean velocity of 1.28 m/s. The silt factor is unity. The hydraulic mean depth will be m.
The critical velocity ratio for a depth of flow 2.5 m in alluvial channel is 1.25. If the manning's 'n' is 0.015 then, the velocity of the channel as per Kennedy's method is
Question 63 A channel designed by Lacey's theory has a mean velocity of 1.1 m/s. The silt factor is 1.1. Then hydraulic mean radius will be A 1.13 m B 2.75 m C 3.13 m D 4.75 m