An open-loop system G(s) is shown in the s-plane as ;shown in the figure below 14 13 s-plane 12 -10 -9 -8 -7 Is the system stable or unstable Write the transfer function of G(s) For a step response, what is maximum overshoot

Q: What are the economic impacts of corrosion? Give measures to prevent corrosion of metals. (Will be…

A: What are the economic impacts of corrosion? Give measures to prevent corrosion of metals.

Q: 1. A diode is in series with 2202. If the voltage across the resistor is 6 V, what is the current…

A:

Q: Problem #9). What is the value of R₂ in the circuit below if you swap the values located at R₁ to be…

A:

Q: able Q5 shows the properties ofa semiconductor bar tTor a particular circult. Table Q5 Semiconductor…

A: We need to increase the current we need to increase intrinsic concentration of diben sample .

Q: please show the solution and answers in each. Thank you

A:

Q: Example: If PMMC meter have internal resistance of 102 and full scale range of 1mA. Assume we wish…

A:

Q: Briefly explain an application of electrical circuits in your given field of study/future career.…

A:

Q: The graph below illustrates the effect of temperature on the conductivity of an extrinsic…

A: 1) semiconductor should be operated in region 2 because for a temperature range it should not vary…

Q: Part 1: Semiconductor Diodes Our objective is to be familiar with the different kinds of…

A:

Q: نقطة واحد. P.D in volts between any two points has been defined as equal to the .23 . in . in moving…

A: In this question 2 MCQ questions given..We have to answer them..

Q: Current is the flow of charges in a directed path. When we connect your mobile phone charger to the…

A: Charging up a battery is the exact opposite of discharging it: where discharging gives out energy,…

Q: An intrinsic semiconductor with an intrinsic hole concentration of 0.56 x 1010 cm-3, has been doped…

A: here we have to find the minority carrier concentration.

Q: ..) A series type ohmmeter, designed to operate with a 9-V battery, the meter movement has an…

A:

Q: A pure Ge sample is given at room temperature. Compute the increment in conductivity per degree rise…

A: The solution is given below

Q: 3. A metallic wire is stretched from original length of 3 m to 6 m. If the original cross-sectional…

A:

Q: A PMMC instrument has internal resistance of 0.59 kn and gives full scale deflection for resistance…

A:

Q: 2//Answer the following:1- Explain, what happens when we put two N- type semiconductor, and in the…

A: The majority charge carriers of N-type semiconductors are electrons , whereas the p-type…

Q: Q4\ Design a multi range D.C. ammeter by using indirect method to give the following ranges IA, 5A,…

A: Design a multi range DC ammeter.  For range of 1A, 5A, 25A, 50A and 100A. If PMMC meter have…

Q: With Neat sketch explain the construction, operation, VI characteristics, application and features…

A: Diode is a power semiconductor device which is having a single PN junction. There are two types of…

Q: 1. Are the theoretical calculations and measured values are equal? Explain? 2. Comment on your…

A: The answer as given below:

Q: How would you measure the unknown resistance (Rx) with the help of avoltage source, null detector…

A: Given components: A voltage source, a galvanometer, unknown resistors RX and resistors R1, R2, R3…

Q: Write a presentation on healthy eating

A: Basically to grow properly and be fit, need to take a range of healthy foods that contain nutrients.…

Q: What is the (Methods) to calculate the value of resistance?? and how we can using the multimeter…

A:

Q: Analyze and identify data given on the following problems and employ related equations to determine…

A: In this question we will find current from battery and efficiency ... Note:- as per our guidelines I…

Q: 3.      a) With neat diagram, State the principle of RTD sensor…

A: b) It is given that: R=100 ohm t=250C α=0.00392

Q: (i) A single diode operates as a.. (11) A vacuum diode acts as a rectifier because of its... (iii) A…

A: Q.1 A single diode operates as a switch.  Explanation :-  In forward bias diode acta as close switch…

Q: B. P-N junction is given. Please: i) Draw the cross-section of this p-n junction and show the…

A: Given : Brief description: In the above given question they have mentioned about a PN junction. PN…

Q: 1. Three batteries, A, B, and C are being recharged through a 16 V battery and individual limiting…

A:

Q: Define the term secondary effects of the user's benefits? Give an example?

A:

Q: A PMMC instrument has internal resistance of 0.9 kN and gives full scale deflection for 53 mA. The…

A: Meter to work as voltmeter with multi range we have to add series resistor . We will use ohms law to…

Q: 1.List the three steps of nuclear fuel fabrication processes. Also sketch a schematic diagram and…

A:

Q: Problem 3: A factory manufactures a specific copper part. It is found at a certain temperature the…

A:

Q: a)  Calculate and plot the current flowing through the pn junctions of device #2 on your 3311 wafer…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: Briefly discuss the 10 electrical hazards in the laboratory and give the corresponding preventive…

A: Working in an electrical laboratory is a task that need our care towards the safety. Electrical…

Q: Problem 1: Introduction to energy processing. In a short report, explain the concept of power…

A: Step-1-> Power processing is the management and conversion of electrical power in modern…

Q: In your understanding explain how energy process occur when electron –hole pair are created and then…

A: As per the guidelines, we need to solve only first question.  We need to explain how energy process…

Q: 3. The circuit shown contains batteries that are ideal, and conventional current flow is assumed.…

A:

Q: Since the advent of integrated circuit (IC), the electronic industry continues to have various…

A: Integrated Circuit (IC):- A semiconductor wafer on which thousands or millions of small resistors,…

Q: A PMMC instrument has internal resistance of 0.66 kn and gives full scale deflection for 30 mA. The…

A: To use voltmeter as a multi range voltmeter we have to add series resistor.

Q: Sketch a diagram showing the ohmmeter face for a reading of 1.2 kQ. Indicate the setting of the…

A: Ohmmeter reading = 1.2 k-ohm Ohmmeter :- The ohmmeter is an electronic device that is used to…

Q: What is the relationship of the current-voltage characteristic and the color of the Red, Yellow,…

A: Energy Band Gap :The lowest energy is required by the electron to release from the valence band to…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.