An open cylindrical tank having a radius of 0.34 m. Is filled with water at a depth of 0.84 m. If it is rotated about its vertical axis to a velocity of 110 rpm, what should be the height in meters so that no water will be spilled ou

An open cylindrical tank having a radius of 0.34 m. Is filled with water at a depth of 0.84 m. If it is rotated about its vertical axis to a velocity of 110 rpm, what should be the height in meters so that no water will be spilled ou

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A 150-m-long commercial steel pipe is to convey 30 L/s of oil (s = 0.9, p = 0.038 N-s/m?) from one…

A: Introduction : Minimum costs for medium transmission through the pipeline, as well as pipe costs,…

Q: A 550-mm-diameter, non-slender, tied column is symmetrically reinforced with 7-28 mm vertical bars.…

A: This question is Related to the Column from Design of concrete structure. In this question we…

Q: A vessel containing oil of sp gr 0.762 moves vertically upward with an acceleration of +2.5 m/sec.…

A: Data is as given below

Q: 7. At some instant in time, Piston A is moving to the right at a velocity of 0.500 m/s and Piston B…

Q: In a two dimensional incompressible, steady flow, stream lines are drawn so that they are 20 mm…

Q: An open vessel in the form of a frustum of a cone with a radius of 1.2m (bigger base), the smaller…

A: The radius of frustum at base, R=1.2 m The radius of frustum at top, r=1 m The slope of vertical…

Q: A closed cylindrical vessel of diameter 15 cm and length 100 cm contains water up to a height of 80…

A: D=15cm =0.15m Z=100cm=1m To find speed of rotation of vessel

Q: Oil (s=0.80) and viscosity (u = 0.098 Pa – sec) flow from a reservoir of surface elevation 100…

A: Please find attached images for solution

Q: PROBLEM 1 An open cylindrical container with a diameter of 1.2 m and height of 3 m contains oil at a…

A: We have to determine the value of maximum velocity in rpm such that the no liquid will be spilled…

Q: 64 A pelton wheel works under a head of 400 m. Frictional loss through the pipe flow is limited to…

A: A Pelton wheel turbine-Head of wheel = 400 mLimitation of frictional loss = 10%The coefficient of…

Q: An open trapezoidal tank having a bottom width of 3 m is 2 m high, 1.5 m wide, and has its sides…

Q: Oil (s=0.80) and viscosity (u = 0.098 Pa - sec) flow from a reservoir of surface elevation 100…

Q: 1 velocity of V₁ = 1.7 m/s. The water in the pipe then exits vertically into the air. If the head…

Q: A pipe of 0.7 m diameter has a length of 6 km and connects two reservoirs A and B. The water level…

Q: 1. A cylindrical tank, 1.5m inside diameter has an orifice at its side 0.25m above the bottom. If…

A: Reference : Water resources, Orifices.Given :Diameter of orifice, height of water.To determine :1.…

Q: a cylindrical tank is span at 300 rpm its axis vertical. the tank is 0.6 m high and 45cm diameter…

Q: An open-topped cylindrical tank contains water that is 80% of its overall height of 1.2 m. The…

A: As per guideline, first three parts are answered. Please repost the remaining parts.

Q: An inverted cone has a radius of 12ft and height of 15ft. The cone is 80% full of a fluid having a…

A: AT 80% THE HEIGHT =0.8h=0.815=12ftso radius ish80%r80%=hrr80%=0.8×hh×12r80%=9.6ftFind volume of…

Q: A cylindrical vessel with closed bottom and open top is 0.9 m in diameter. What is the rotational…

A: Given- Dia of open top=0.9 mrise=0.5 mbottom dia=0.4 mg=10 m/s2 Rotational speed needs to be find…

Q: 2. A nozzle 3 m long has a diameter of 1.3 m at the upstream end and reduces linearly to 0.45 m…

A: Figure is as shown

Q: SITUATION: An open cylindrical vessel 1.3 m in diameter and 2.1 m high is 2/3 full of water. If…

Q: Question- A pelton wheel works under a head of 400m. Friction loss through the pipe flow is limited…

A: Given- Pelton wheel- Head h=400 m, friction loss=10%, Coefficient of velocity Cv=0.98, g=10 m/s2, It…

Q: (in millimeters) of the hole. 3 cm diameter 1.20 m 9 cm diameter 1 m 0.30 m

Q: Gasoline (SG=0.7) flows down an inclined pipe whose upper and lower sections are 90 mm (section 1)…

Q: 2. An open cylindrical vessel, 800mm in diameter, 1.2 meters high, and 3/4 filled with water rotates…

Q: A nozzle of inner radius 1.06 mm is connected to a hose of inner radius 9.05 mm. The nozzle shoots…

Q: In a two dimensional incompressible, steady flow, stream lines are drawn so that they are 26 im…

Q: 2. A nozzle 3 m long has a diameter of 1.3 m at the upstream end and reduces linearly to 0.45 m…

A: As per Bartleby policy i can answer only one question at a time. Please upload other questions…

Q: EXAMPLE. An open cylindrical tank is 6 ft in diameter and is filled with water to a depth of 10 ft.…

A: There is an orifice within the fluid that passes through it. As compared to its other dimensions, an…

Q: discharge pressure at the pump exit is

A: Given data, A centrifugal pump is required to pump water to an open watersitiuated 4 km away from…

Q: A cylindrical container 1m in diameter and 3m tall is open at the top. it is initially full of water…

A: Given diameter of cylinder = 1 m Hence radius of cylinder = 0.5 m height of cylinder = 3 m

Q: The 275-kg circular craft is suspended 100 mm from the ground. For this to occur, air is drawn in at…

A: Given data 275 kg circular craft Density of air = 1.22 kg /m3 velocity = 18 m/s Fluid is…

Q: Water floes through a circular pipe with a constant radius of 8cm. The speed and pressure at point a…

Q: An open rectangular tank mounted on a truck is 5 m long, 2 m wide and 2.5 m high is filled with…

A: We will use formula of angle.

Concept explainers

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

8.14 A fluid flows through a horizontal 0.1-in.-diameter pipe. When the Reynolds number is 1500, the head loss over a 20-ft length of the pipe is 6.4 ft. Determine the fluid velocity.
(c) Liquid flows through an orifice in the bottom of a cylindrical tank at a velocity of 4m/s. If the jet diameter is 2.5cm, what is the rate of flow in lit/sec? If the tank is 25cm in diameter, at what rate is the liquid surface falling?
Please answer, hydraulics.
An oil flow rate of 0.012 m³/s is required in an industrial process. The flow system includes a pressure tank pushing the oil through 200 m of new ductile iron pipe (DIP: 15 cm diameter, square-edged entrance) to point "2" (atmospheric pressure) as shown in Figure P3.11.11. The sur face of the fluid in the tank (point "1") is at elevation 100 m and the end of the pipe (point "2") is at elevation 106 m. What air pressure will be needed over the fluid to produce the requisite flow? (S.G. (oil) = 0.84, v 2.03 x 106 m²/s, and e = 0.00012 m.)
Question Certain fluid parameters are provided The inner cylinder, with a diameter of 20 cm, remains stationary, while the outer cylinder, with a diameter of 21 cm, holds the liquid up to a height of 30 cm. There is a 1.0 cm gap between the bottom of the two cylinders. By rotating the outer cylinder at a speed of 200 revolutions per minute (r.p.m.), the torsion meter attached to the inner cylinder registers a torque of 6.0 N-m. a. Determine the toque on the bottom in terms of b. Determine the toque on the surface in terms of ..... c. Determine method the viscosity of a liquid (N-sec/m^2)(Ans up to 2 decimal) μ (Ans up to 4 decimal) ..u.(Ans up to 4 decimal) using the rotating cylinder
Civil engineering -Hydraulics
4. An open vessel 0.46-m in diameter, 0.60-m high and full of with water is rotated about its axis at such velocity that the water surface 100-mm from the axis makes an angle of 40 degrees with the horizontal. a. How many liters of water are lost? b. Compute the speed of rotation in rad/ sec.