An oil having a density of 833 kg/m3, and a viscosity of 3.3x10^-3 Pa-s is pumped from an open tank to a pressurized tank held at 345 kPa gage. The oil is pumped from an inlet at the side of the open tank though a line of commercial steel pipe having an inside diameter of 0.07792 m at a rate of 3,494x10^-3 m3/s. The length of straight pipe is 122 m, and the pipe contains two elbows (90°) and a globe valve half open. The level of the liquid in the open tank is 20 m above the liquid level in the pressurized tank. The pump efficiency is 75%. Calculate the kW power of the pump.

Q: Flee

A: we knowdensity ρ at 77° F =99 lb/ft3= 0.057291667 lb/in3& A1V1=A2V2v 52 x v1 = z2 v2v2 =6.25…

Q: Water is pumped through a horizontal, smooth circular pipe at a bulk velocity of 0.4 m/s. The pipe…

A:

Q: Q5) The average velocity of the air flowing in a pipe with a roughness of ks=D0.0015 mm with a…

A:

Q: - 1000 kg/m) flows from a large Q6: Water (p tank through a large pipe that splits into two imaller…

A:

Q: Oil is pumped from a very large tank (z1 = 150 m) to another tank (z2 = 200 m), located higher and…

A:

Q: head loss due to sudden contraction valve in a piping system is much higher than gradually…

A:

Q: Fluid A is three times denser than Fluid B through the same horizontal pipes. Which will flow…

A: The fluid is the substance that offers resistance to flow. Basic fluid properties are density…

Q: oil (0.88) ► oil (0.88) Hg (SG=13. 320mm-

A:

Q: t the gasoline transfer facility (ρᵣₑₗ=0,75) from the pond of  storage to consumption, you want to…

A: The power required to operate a pump between 2 points in the system can be obtained by using the…

Q: Water steadily flows from the basement to the second floor through a 0.75-in-diameter copper pipe.…

A:

Q: Given that h=30 mm, μ=0.002 Pa.s and ρ=1000 kgm-3 Consider a steady-state turbulent flow between…

A: 1 2

Q: A pilot tube was used to measure the velocity of water in a circular pipe 2 inches diameter. If the…

A: A Pitot tube is used to measure the local velocity of flow. it is highly accurate velocity measuring…

Q: The density of the fluid is (1.05x10^3) kg/m3 and the dynamic viscosity is 1.12 x 10 - 3 Ns/m2. The…

A:

Q: Liquid propane, at its bubble point, is to be pumped from a reflux drum to a depropanizer. The…

A:

Q: Water at 60 degrees Fahrenheit have a density of 62.36 lb/ft.^3 and dynamic viscosity of 7.536 x…

A:

Q: 1. The head loss along the pipe segment 2. Velocity of flow 3. Reynold’s number

A:

Q: Water (specific gravity, G, is 1.0 and the kinematic viscosity, ν, is 1.14 *10-6 m2 /s) flows…

A:

Q: Water flows between two reservoirs A & B. The water level in A is 400 m AOD and in B is 385m AOD.…

A:

Q: A hose pipe of 75 mm bore and length 450 m is supplied with water at 1.4 MPa. A nozzle at the outlet…

A:

Q: 5.9.5. Factory tests indicated that a cavitation parameter for a particular pump is o = 0.075. The…

A: Given: Cavitation parameter for the pump→σ=0.075  Pressure at the sea level→Patm=101.325 KPa…

Q: The air is flowing in the circular pipe with a volumetric flow rate of 11 m/h and diameter of the…

A: "Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: A Venturimeter (Cd = 0.68) and Pipe orifice (Cd = 0.64) are attached one at a time to a 200mm…

A: a VenturimeterVenturimeter Cd= .68d= 200 mmx=2.7 mh=xshgsw-1h=2.7×13.61-1=34,02…

Q: A pumping system is installed at a location where the reading of barometer is Pa=90kPa and the vapor…

A: Given: The atmospheric pressure, Pa = 90 kPa The vapour pressure, Pv = 3.5 kpa The cavitation number…

Q: A centrifugal pump was purchased to pump the water from an open tank to a water jet spray cleaner.…

A: Given Datagauge pressure=75kN/m2d=0.64mh=15m

Q: Heavy oil with density of 912 kg/m^3; kinematic viscosity of 2.05 x 10^-4, is delivered to an upper…

A:

Q: Oil (Density = 860kg/m3, Dynamic viscosity = 0.002 Pa.s) flows through a pipe of 100mm diameter with…

A:

Q: What does "viscous flow" mean, and what does "head loss through friction" mean? Describe the…

A: Viscous flow refers to the flow of fluids in which there is a resistance to motion due to the…

Q: (3) In the figure below, the pipe entrance is sharp-edged. Consider the flow rate Q to be 0.004…

A:

Q: A pitot tube is used to measure the flow rate of water at 30C. The pitot tube is positioned at the…

A:

Q: Heavy oil with a density of 912 kg/m^3; kinematic viscosity of 2.05 x 10^-4, is delivered to an…

A:

Q: Oil (Density = 860kg/m³, Dynamic viscosity = 0.002 Pa.s) flows through a pipe of 100mm diameter with…

A:

Q: A water is pumped at a rate of 87.87 in3/min through a 0.197-in radius pipe on the main floor of a…

A: Given,  Flow rate of water , Q = 87.87 in3/min =1.4645 in/s Radius of the pipe at inlet, ri =0.197…

Q: At a certain flow range, for a system with certain geometric characteristics, in a pipe whose…

A: Pressure drop (delta P ) = fL/D×V2/2g

Q: Consider the pipe system shown in the figure. Oil (μ = 0.3 Pa-s) flows at a rate of 20 L/s through…

A: As per our guidelines we are supposed to answer only one question. Kindly repost other questions as…

Q: A 2-inch diameter hose is conveying water at a flow rate of 20 gpm from point A to point B. The…

A: Given: Pressure at point A: →PA=40 psi=144×40=5760 lbf/ft2 Elevation at point A from mean sea level:…

Q: At 4C, water has a density of 1000kg/m3 and a viscosity of 1.60 cP. It is to flow through a…

A:

Q: An oil and gas company wants to measure the flow rate of the oil in a low head loss application. 1.…

A: Part 1→ For the criteria of low head loss, I will suggest a venturi meter. the head loss across…

Q: velocity in the developing region is TRUE?

A: Given; For a steady flow of a viscous incompressible fluid through a circular pipe of constant…

Properties of Fluids

The term fluid represents a type of substance that can easily change its shape under any external pressure/force and can flow. Fluids can acquire any shape in which it is stored and can resist normal stresses but cannot resist shear stress in rest condition. Whenever external shear stress is applied to fluids, it starts to flow. The fluids may be liquid or gas. Example- water, air, etc.