An irrigation line carries water from a lake down into an arid valley 810 ft below the surface of the lake. The water discharge through a nozzle with a jet velocity of 220ft/s, the diameter of the jet is 4 in. Find the power loss in friction expressed in hp. Include the diagram in your solution.

Q: You built an irrigation system for a farm lot that flows water at a rate of 0.42m3 /s. Calculate the…

A:

Q: 3.4 Find the flow rate of water through the Problem Set 3 system shown for the turbine to produce 20…

A: Given Data The power produced is: P=20 kW The diameter of the ball is: d=75 cm The height of the…

Q: 10. Water flows from a lake as shown below at a rate of 5.0 ft³/s. Is the device inside the building…

A:

Q: An axial flow turbine operates with a constant axial velocity throughout of 230. The rotation speed…

A: Given Data: V=230 m/sN=3600 rpmr=1.2 mθ=35o   To Find: (a) Velocity triangle at the inlet and exit.

Q: A pump is installed in a pipe system, where at the suction side 1.0 m below the pump, an open…

A:

Q: A hydraulic orchard pruner is driven by an engine with an output of 20 bhp . If the pump has a…

A:

Q: he air is measured at 20 deg. C and 679mm Hg. The duct diameter is 744 mm while the discharge…

A: Given, Air temperature , T =20 deg C Pressure - P1 = 679 mm hg volume flow rate , Q = 4m3/s.…

Q: 1.)  A Pelton wheel with a needle-controlled nozzle develops 1 050 kW against a gross  head of 300…

A:

Q: An air compressor takes air at 100 Kpa and discharges to 600 Kpa. If the volume flow of discharge is…

A: Given :  P1 = 100 KPa P2 = 600 KPa volume flow of discharge, V.2 = 1.2 m3/sec To find : capacity of…

Q: An irrigation line carries water from a lake down into an arid valley 810 ft below the surface of…

A:

Q: Two inward flow to

A: 437 RPM

Q: Guava juice enters a pipe with an ID of 3.05 inches at a rate of 15.6 ft3 / hr, then exits through a…

A:

Q: Water is to be supplied to the inhabitants of a college hostel through a supply main. The following…

A: We have provided data from the question are,  L=4000 m  N=Number of inhabitants=3000  Q=180…

Q: 72. A pipe is connected vertically to the discharge side of a pump. The top of the pipe is a short…

A:

Q: A 5 lbm ball starts rolling up a 30deg incline at speed of 20 ft/s. Using conservation of energy,…

A: Given   Mass, m = 5 lbm       Angle = 30o Velocity, v = 20 ft/s Find  Power, P

Q: (B) A pelton wheel has a mean bucket speed of 12 m/s moves in the direction of jet water 10 cm in…

A: Given datau=12 msd=10 cmϕ=150u1=u2=12 msvelocity of jetv1=QA=0.18π4×0.12=22.93 ms

Q: A turbine is located at an elevation 200 m. below the surface of the water intake. The friction loss…

A:

Q: the buckets. The speed factor is 0.46. Neglecting any losses, determine: 360 m. The wheel is driven…

A: Introduction: The Pelton turbine operates on a basic basis. When a high-speed water jet shot by a…

Q: Q.21 Water is being pumped at a rate of 0.5 ft/sec from a storage tank to a certain exit point of…

A: For solution refer below images.

Q: Q3: a: A centrifugal pump used to take water from reservoir to another through 800 m length and 0.15…

A:

Q: Q2/Water is being pumped from a reservoir to the hill, water discharged (0.245m'/s) as shown in Fig.…

A:

Q: A closed reservoir filled by water, is under the pressure of 49 KPa as shown in the Fig.1. find the…

A: Given:pA=49 KPa (gauge)zA=3 mVA=0pB=0 KPa (gauge)zB=0

Q: 3. For a Pelton turbine the pressure of the flow before the nozzle is 5 bar while the velocity of…

A: As given that the pressure before the nozzle(P) = 5 bar ;the velocity of the flow leaving the nozzle…

Q: 6.1 Dj and D2 are the inlet and outlet diameters of the pipe connected to the water turbine shown in…

A: A water turbine converts the kinetic and potential energy of water into useful mechanical work. It…

Q: A pump with an impeller diameter of 0.02 m, an impeller speed of 58.3 rpm, a total capacity of 12…

A:

Q: The velocity of water and pressure at the suction side of a pump is 4m/s and 90kPa respectively. If…

A:

Q: mini-hydroelectric power plant is under a head of 275 feet. The turbine efficiency is 0.85 and the…

A:

Q: A pump is installed in a pipe system, where at the suction side 1.0 m below the pump, an open…

A:

Q: total energy

A:

Q: 6. A fabricated assembly made from three different sizes of standard steel tubing is shown below.…

A:

Q: A fire starts in an apartment building in downtown Boston. When the firefighters arrive, they…

A: As per the question, the water is coming out of the hydrant at a certain velocity. When that is…

Q: An irrigation line carries water from a lake down into an arid valley 810 ft below the surface of…

A:

Q: Calculate the resultant force required in kN to hold a 90° elbow in place when attached to DN 150…

A: Flowing fluid has some mass and velocity. velocity is due to acceleration. According to these 2…

Q: The head of water at the inlet of a pipe of length 1 500 m and diameter 400 mm is 50 m. A nozzle of…

A:

Q: ..Consider a leather belt with the following given: width of 100 mm, thickness of 6.4 mm, velocity…

A:

Q: A Pelton wheel has a mean bucket speed of 15 m/s with a jet of water impinging with a velocity of 40…

A: Given data, Speed of bucket Discharge R=density=Angle of deflection ,Now, Velocity of jet And, And ,

Q: A liquid enters a diffuser at speed 10.8 feet/second.  The diffuser's inlet diameter is 4 inches…

A: A liquid enters a diffuser at speed, V1 = 10.8 feet/second. The diffuser's inlet diameter (d1 )= 4…