An inverted conical tank has a base radius of 10m and height of 20m. Water flows out from thetank at 150L per second. How fast is the water surface falling when the depth of water in thetank is 8m?a. 13.6 cm/minb. 14.5 cm/minc. 15.2 cm/mind. 17.9 cm/min

Answered: An inverted conical tank has a base…

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

4. An open vessel 0.46-m in diameter, 0.60-m high and full of with water is rotated about its axis at such velocity that the water surface 100-mm from the axis makes an angle of 40 degrees with the horizontal. a. How many liters of water are lost? b. Compute the speed of rotation in rad/ sec.
A conical funnel has radius 4 cm and height 8 cm. A liquid is draining from the funnel at a constant rate of 1.3 cm³/sec. What is the depth of the liquid where there are 100 cm³ of the liquid remaining in the funnel? ans. 7.26 cm (b) How fast is the level dropping when there are 100 cm³ of dh dt the liquid remaining in the funnel? ans. = -0.031 cm/sec (c) How long does it take for the funnel to drain? ans. 103 seconds
An underground conical tank, standing on its vertex, is being filled with water at the rate of 18pi ft3/min. If the tanks has a height of 30feet and a radius of 15feet, how fast is the water level rising when the water is 12 feet deep? a. 3/4 ft/min b. 1/4 ft/min c. 1/2 ft/min d. 1/3 ft/min
Problem 5-32 The water tank in Figure 5 - 9 is being filled through section 1 at 6 m/s and through section 3 at 15 L/s. If water level h is constant, determine the exit velocity 02. Ans: 7.97 m/s 15 L/s 40 mm 60 mm Ø Figure 5-9 0.9 m
Q3. Water flows down a dam spillway and then forms a hydraulic jump. Just before the jump, the velocity of flow is 7.5 m/s, and the water depth is 0.15 m. Determine the average velocity of the flow downstream of the channel after the jump. 7,5m/s y2 yi=0.15m V2=.... ...m/s
Water flows into a conical vessel at a constant rate of Q cm³/s. The vessel has a height of 18 cm and a diameter of 10 cm at the top. When the water is 12 cm deep, the water level is rising at the rate of 0.115 cm/s. Find the value of Q.
The water tank shown in the given figure is being filled through section 1 at V, = 2.62 m/s and through section 3 at Q3 = 0.04 m /s and the exit velocity V2 = 4.15 m/s. If the water level h varies, determine the rate change of the water height (dh/dt) (Assumed d = 1.62 m). Q 0.01 m/s D, = 5 cm D7 cm Water
An open horizontal tank 3 m high, 3.6 m wide and 5.1 m long is initially filled at 2 m of water. A. Determine the required acceleration in m/s2 so that no water will be spilled? B. Determine the required acceleration in m/s2 so that 1/3 of the initial volume of water will be spilled C. Determine the remaining volume in cu.m if it accelerated at 7 m/s^2D. Determine the minimum hydrostatic force in kN at the side of the tank if 2/3 of the initial volume will be spilled E. Determine the maximum hydrostatic force in kN at the side of the tank if it accelerates at 3 m/s^2
An open cylindrical vessel 1.3 m in diameter and 2.1 m high is 2/3 full of water. If rotated about the vertical axis at a constant angular speed of 90 rpm, 1. Determine how high is the paraboloid formed of the water surface. A. 1.26 m C. 2.46 m B. 1.91 m D. 1.35 m 2. Determine the amount of water that will be spilled out. A. 140 L C. 341 L В. 152 L D. 146 L 3. What should have been the least height of the vessel so that no water is spilled out? A. 2.87 m С. 3.15 m B. 2.55 m D. 2.36 m
An open horizontal tank 3 m high, 3.5 m wide and 6 m long is initially filled at 2 m of water. a. Determine the required acceleration in m/s² so that no water will be spilled? 3.270 Determine the required acceleration m/s? so that 1/3 of the initial volume of water will be spilled. b. [ Select ] c. Determine the remaining volume in cu.m. if it accelerated at 7 m/s^2. [ Select ] Determine the minimum hydrosatic force in kN at the side of the tank if 2/3 of the initial volume will be spilled. d. [ Select ] Determine the maximum hydrosatic force in kN at the side of the tank if it accelerates at 3 m/s^2. е. [ Select ]
Problem 6 A 34.5 ft diameter by 48.3 ft height vertical tank is receiving water (p= 62.4 lb/ft ³) at a rate of 208 gpm and is discharging through a 8 -in inside diameter with a constant speed of 7.46 fps. At a given instant, the tank is half full. Find the water level and the mass change in the tank 48 min. later. Solution 208 gpm 48.3. 34.5 7.46 fps I 24 -24.15
SITUATION 6: A 0.0075 m2 orifice is attached at the side of a tank with a head of 6.7 m. The coefficient of velocity and coefficient of discharge are 0.98 and 0.72, respectively. 26. Find the actual flow rate. a. 0.0619 m3 b. 0.0215 m3 REVIEW c. 0,0809 d. 0.0975 m³ 27. The area of water jet out the orifice is most Vikely equal to a. 0.0021m2 b. 0.0037m2 d. 0.0051m2 c. 0.0019m² 2. 28. The ideal efflux velocity of the orifice. m. a. 11.465 b. 7.732 RE c. 9.532 d. 10.237

SEE MORE QUESTIONS

Recommended textbooks for you

Structural Analysis

Civil Engineering

ISBN:

9781337630931

Author:

KASSIMALI, Aslam.

Publisher:

Cengage,

Structural Analysis (10th Edition)

Civil Engineering

ISBN:

9780134610672

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781337705028

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

Structural Analysis

Civil Engineering

ISBN:

9781337630931

Author:

KASSIMALI, Aslam.

Publisher:

Cengage,

Structural Analysis (10th Edition)

Civil Engineering

ISBN:

9780134610672

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781337705028

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

Fundamentals of Structural Analysis

Civil Engineering

ISBN:

9780073398006

Author:

Kenneth M. Leet Emeritus, Chia-Ming Uang, Joel Lanning

Publisher:

McGraw-Hill Education

Sustainable Energy

Civil Engineering

ISBN:

9781337551663

Author:

DUNLAP, Richard A.

Publisher:

Cengage,

Traffic and Highway Engineering

Civil Engineering

ISBN:

9781305156241

Author:

Garber, Nicholas J.

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

An inverted conical tank has a base radius of 10m and height of 20m. Water flows out fre tank at 150L per second. How fast is the water surface falling when the depth of water tank is 8m? a. 13.6 cm/min b. 14.5 cm/min c. 15.2 cm/min d. 17.9 cm/min