Answered: An input power of P = 3 W is fed to a…

An input power of P = 3 W is fed to a 75 km conductor. A repeater is present at 40 km from transmitter and has a gain of 70 dB. The conductor has a of 3 dB/km. The power received at receiver side is

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter13: Transmission Lines: Transient Operation

Section: Chapter Questions

Problem ECSQ

See similar textbooks

Related questions

Q: A suburb has an area of 2400 square miles and is covered by a cellular system that uses a 12-reuse…

Q: A person with a receiver is 5 km away from the transmitter. What is the distance that this person…

A: The distance between the transmitter and the person with the receiver is 5km as shown below:

Q: D layer allows purposeful communication of any given path, through? A-Attenuation of the signal with…

A: According to the question, D layer allows purposeful communication of any given path, through? A-…

Q: If the Q-factor of a coil at resonant frequency of 1.5 MHz is 150 for a series resonant circuit,…

Q: What is the bandwidth occupied by a frequency modulated sinusoidal carrier with a modulation index…

A: In the question What is the bandwidth occupied by a frequency modulated sinusoidal carrier with a…

Q: hen sam cable. - FALS . TRUE

Q: The loss in a cable is usually defined in decibles per kilometer (dB/km). If the signal at the…

A: Power of signal at 5.5 KM =10 log2mW+5.5km×-0.3dBkm=10 log2×10-3+-1.6dB=10…

Q: Q1. Derive an expression for the input impedance of the equivalent network for che passive component…

Q: find out the bandwidth if the maximum signal frequency is 50khz? 2- calculate the Viltoge goin 't…

Q: B. DSBSC modulated signal is transmitted over a noisy channel, with the power spectral density of…

Q: 21. FM can be produced using a phase modulator. Group of answer choices True False 22. In PM,…

A: As per our guidelines,we are supposed to answer only first 3 questions. Kindly repost the other…

Q: 2.3) The one side of a coaxial cable is connected to a signal generator. On the other side of the…

A: Given information, Coaxial cable output impedance is R1=46 Ω. Horn antenna resistance is R2=82 Ω. We…

Q: Audio amp: 35 dB gain (a) What is the total power gain of the receiver from antenna to speaker? (b)…

A: aTotal power gain of the receiver from antenna to speaker…

Q: 1. Assuming you are positioned at 5500 meters from the omnidirectional radio receiver you are…

A: Given, Distance, di=5500 m Distance, ds=3000 m Signal transmitter’s EIRP (Effective isotropically…

Q: A 50-ohm source has an RMS open-circuit output voltage of 1 volt at 100 MHz a. What peak voltage…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Q1. For the scheme shown in figure Q1, using the message signals spectra shown a) Draw the spectrum…

A: Given: a. We need to draw the spectrum at points A and B. b. We need to determine the total…

Q: [S)=

A: Power divider circuit

Q: A Radio Frequency (RF) receiver system consists of several components as shown in Table Q1(b). In…

A: Given: A Radio Frequency (RF) receiver system consists of several components as shown in the table…

Q: Note: Answer only five questions. f(1) S.V QI-If the baseband signal shown in the above figure is…

A: The given baseband signal is shown below: It is given that: Maximum power of envelope=12.656…

Q: 1. For an open circuit (OC) load, the value of the reflection coefficient equal to (a) 1 (b)-1 (c)…

A: Given: (1) For an open circuit load the value of the reflection co-efficient is equal to a) 1b) -1c)…

Q: 36. Phase modulation is also a type of angle modulation. Group of answer choices True False…

A: 36) Angle modulation have two types a) Phase modulation b) frequency modulation. So above statement…

Q: A 1-MHz carrier with an amplitude of 1 volt peak is modulated by a 1-kHz signal with m=0.5. Sketch…

Q: A 400-ohm resistor, a 20-uf capacitor, and a 0.505-henry inductor are connected in parallel and are…

A: The solution is given below

Q: 1. Consider a Transmission System comprising a single electrical cable with a bandwidth of 30MHz.:…

A: A transmission system is a system used to transmit data from one place to another and the receiver…

Q: signal transmission line which has a source impedance of 75Ω is to be connected to a signal strength…

Q: An FM transmitter is medu lated with asingle tone 75 Cos (2* 2210lt) and acarrier amplitude of 68…

Q: An angle modulated sign is given as u (t) = 100cos [2πfct + 4sin2000πt]. Carrier frequency is 10MHz.…

Q: P.3 For the shown indirect Armstrong FM modulator a) Calculate the missing frequencies b) what would…

A: To calculate the missing frequencies at the different stages, from the frequency multiplier the…

Q: Q2:- Find the spectrum for DSB-SC where frequency of message is 2M and Carrier wave is 6 Cos…

A: In the question, Frequency of the message signal = 2MHz Carrier signal = 6cos(4π×108 t) Spectrum of…

Q: 1- The loss in a cable usually defined in decibel per kilometer (dB/km). If the signal at the…

A: Consider the loss in the cable for the 5 km range is, 5 km-0.3 dBkm=-1.5 dB

Q: A transmitter has a power output of 10W at a carrier frequency of 250 MHz. It is connected by 10 m…

Q: A transmitter has an output carrier power of 25 W. If spurious signals must be at a level of -70 dBc…

Q: Question 2 Assuming you are positioned at 5500 meters from the omnidirectional radio receiver you…

A: We will find out received power at receiver due to both transmitter and jammer .

Q: QUESTION 12 drd P,(d) = P,(d) d or ref P,(d), dBm = P,(d), dBm +10 v logo d %3D For a base station,…

A: A base station is a fixed transceiver that is the main communication point used for the devices of…

Q: A sinusoidal signal of 1 W average power is transmitted down 10 m of coaxial cable. of 0.1 mW is…

Q: 3. The radiation resistance of an antenna 72 ohms, loss resistance is 8 ohms .What is the…

Q: 4.a. What's the typically acceptable maximum BER value in a multimode fiber? A. 10–7 B. 10–6 C. 10–9…

A: Answer 4(a), The typically acceptable maximum BER value in a multimode fiber is 10-9. This value is…

Q: Q3. An FM modulator with f-7 and modulated carrier xe(t) = 120 cos(2000zt + 0(t)) and a message m(t)…

Q: 1. You use power meter at a receiver with no signal measure a received noise power level of -110…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost other…

Q: Determine the minimum receiver sensitivity in microwatts needed to reliably detect a

A: Given: Transmitter output power=15mWCommercially available optical cable length=2kmOptical cable…

Q: A signal of 20 Watts is attenuated by 13 dB. What is the resulting power level in dBm? In Watts? 6.4…

A: A signal of 20 Watts is attenuated by 13 dB. What is the resulting power level in dBm? In Watts? The…

Q: A signal was represented using Bipolar RZ with a bandwidth of 40 kHz, then the bandwidth will be…

A: The given bandwidth is 40 Hz.

Q: 2.102. A series of microwave repeater links operating at 10 GHz are used to relay television sig-…

A: According to the question, for the given microwave system, we need to find minimum transmitting…

Q: wireless communication For a satellite with an uplink Eb/N0 of 14 dB and a downlink Eb/N0 of 18 dB,…

A: The solution is given below

Q: Q3. An FM modulator with fa 7 and modulated carmer 1.(t) = 120 cos(2000nt + 0(t)) and a message m(t)…

Q: Q1. A link is operating at f=60GHz & 500 MHz bandwidth. The Tx & Rx antennas are square-shaped with…

A: An antenna refers to an interfacing channel between the radio waves which are travelling through…

Q: A signal is to be transmitted into the line where the link has a bandwidth of 50000kHz at the same…

A: Given data is link bandwidth =50MHz sampling rate is fs=2×50M=100MHz given that 2bits can be…

Q: The message signal m(t) as shown in the figure is applied to a phase modulator (with kp as the phase…

A: Given similar carrier frequency is used in both FM and PM modulation Instantaneous phase in PM…

Concept explainers

Frequency Modulation

Frequency modulation is a method or process of encoding the data of a specific signal (analog or digital) by modulating the carrier wave frequency according to the frequency of the modulated signal. Modulated signals are nothing more than information or data that should be conveyed after being converted into electronic signals.

Question

An input power of P = 3 W is fed to a 75 km conductor. A repeater is present at 40 km from transmitter and has a gain of 70 dB. The conductor has a of 3 dB/km. The power received at receiver side is: (a) -140.23 dBm (b) -120.23 dBm (c)-110.23 dBm (d) -150.23 dBm

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

why a fundamental frequency voltage does not appear at the o.c. secondary terminals.
1. Looking at the transmitter, the signal power is 23 mW. The input signal to noise ratio is 40 dB. The channel offers 3 dB attenuation, making the output power down to 11.5 mW, power to the signal and the output noise is three times the input noise level. Determine the Signal to noise ratio at the output.
42 Modulation is dune in A. Tramamitter Radio veceiver C. Between transmitter and radio receiver D. None of the above 43. At 100 modulation, the power in each sidehands in AY 50% B. 40% C. 60% D 25% 44 In a TV tranumission, picture is modulated A. Frequency B. Phase CT Amplitade D. None of the above of that of carrier. 45. Given a sine wave modulating signal, PM moduluted wave appears to be frequency modulated by cosine modulating wave. A. True B. False
Problem 5. We are transmitting our 12/4 APSK waveform with outer ring voltage 5 Volts and inner ring voltage = 2 Volts. The constellation ring ratio in dB is? a) 6.25 b) 7.959 c) 9.875 d) 9.945 e) 19.891
We shall study the function of the PN generator in the context of the transmitter (Tx) and receiver (Rx) circuits by means of a simple example.
Calculate using a frequency an octave higher from the cut-off frequency ( or two times as much as the cutoff frequency)
Can you please determine the cut off frequency value from the graph provided
Figure (1) shows the block diagram of a wideband frequency modulator using the indirect method. This modulator is used to transmit audio signals containing frequencies in the range of 100 Hz to 15 kHz. The narrowband is supplied with a carrier of frequency fl-0.1 MHz by crystal- controlled oscillator also ß-0.2, a second crystal- controlled oscillator supplied a sinusoidal wave of frequency 9.5 MHz to the mixer. The system Carrier frequency at the transmitter output, fc-100MHz Minimum frequency deviation, Af-75, find nl and n2? f(t) NBFM Freq. Multiplier 1 Oscillator1 Fig. (1) Mixer Oscillator2 Freq. Multiplier 2 frm(t) n1=72, n2=47 O n1=73, n2-48 O n1=75, n2=50 n1=77, n2=52 O n1=76, n2=51 O
4.a. What's the typically acceptable maximum BER value in a multimode fiber?A. 10–7B. 10–6C. 10–9D. 10–84.b. What does a positive dBm value from a power meter tell you?A. The signal strength is less than 1 mW.B. The signal strength is greater than 1 mW.C. The signal strength is greater than 1 W.D. The signal strength is less than 1 W.
An input power of P = 3 W is fed to a 75 km conductor. A repeater is present at 40 km from transmitter and has a gain of 70 dB . The conductor has a of 3 dB/km. The power received at receiver side is: (а) —140.23 dBm (b) –120.23 dBm (c) -110.23 dBm (d) -150.23 dBm
Please disregard the question on the picture. Here's the right question, at what frequency will the value of the impedance be twice that at 25Hz (refer to the given in question #20).
A transmitter has a directional antenna with a gain of 4 dB. The frequency is 72 MHz. The power into the antenna is 2 W. The receiver uses a one-quarter wavelength ground plane. The distance between the transmitting and receiving antennas is 3 mi. What is the power at the receiver? What is the receiver input voltage with a 50-V input impedance?