An industrial coil is modeled as a series combination ... of an inductance L and resistance R, as shown in Fig. 9.90. Since an ac voltmeter measures only the magnitude of a sinusoid, the following measurements are taken at 60 Hz when the circuit operates in the steady state: 80 Ω Coil ww V E L Decermine Rit. E = 193 V V1 = 67 V Vo = 104 V Round your answer to 4 decimal places. all

An industrial coil is modeled as a series combination ... of an inductance L and resistance R, as shown in Fig. 9.90. Since an ac voltmeter measures only the magnitude of a sinusoid, the following measurements are taken at 60 Hz when the circuit operates in the steady state: 80 Ω Coil ww V E L Decermine Rit. E = 193 V V1 = 67 V Vo = 104 V Round your answer to 4 decimal places. all

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.27P: An industrial load consisting of a bank of induction motors consumes 50 kW at a power factor of 0.8...

See similar textbooks

Similar questions

A capacitor "C", an inductor "L" and a switch "S" are connected in series. When the switch is open, the plate to the left of the capacitor has charge "Qo". The switch is closed the load and current vary sinusoidally with time. Represent graphically the load "Qo" and the intensity of current "I" as a function of time "t", and explain why the current leads the load by a phase difference of 90°.
What impedance vector (0- j15) Ohms represents:A. A pure resistance. C. A pure capacitance.B. A pure inductance. D. An inductance combined with a capacitance.
What is the peak current in a AC circuit with a 50 ohm resistor, 3.3 mH inductor, and a480 nF capacitor in series. If the AC source has a peak emf of 5.0V, then what is the peakcurrent at 3000 Hz?At what frequency do you get the largest potential difference across the resistor? And what isthis potential difference?
An electrical circuit with a sinusoidal voltage source, a resistor, and a capacitor all connected in series. The voltage across the capacitor: Select one: a. Leads the current in the capacitor by exactly 90o b. Is in phase with the sinusoidal voltage source c. Is in phase with the voltage across the resistor d. Leads the current in the circuit by 90o e. Lags the current in the circuit by 90o
Given a capacitive load absorbing 5 kW with a power factor of 0.85. The source connected to this load is an AC voltage supply with 120V RMS at a frequency of 50 Hz. Please find; A) Peak current (m) and RMS Current (ms) Values B) Draw peak voltage and current phasors on phasor diagram with everything labelled C) Find the value of an inductor that when connected in parallel will improve the power factor to 0.95.
A chopper circuit has an inductive load of 2ohm resistance and 10mH inductance. If the source voltage is 20 V and the frequency of the chopper is set to 100Hz and the on-time to 5 ms. Determine the average voltage and current, maximum and minimum load currents.
A circuit consisting of a resistor in series with a capacitor takes 100 watts at a power factor of 0.5 form a 100 V, 60 Hz supply. Find the current, resistance, the impedance and the capacitance.
5: An inductor is one of important device in electrical circuits. To study response of it in pure form,inductor 240 mH is connected to AC source of maximum voltage 280 V, with a frequency of 120 Hz.Predict the rms current passing through the circuit. Can you predict the change in rms current if thefrequency is increased to 5 kHz? Are there any similar properties for a transformer compared withinductor? Is it possible to operate inductor with DC source? Justify your answer.
At 0-, no currrent flows through the capacitors because they are open, how did you combine the capacitors for the voltage divider since it is the capacitance value and not reactance, is it right? Can we just combine the capacitance value? Please explain. I did not understand..
A sinusoidal voltage has a peak value of 15 V, has a frequency of 125 Hz, and crosses zero with positive slope at t=1 ms. Write an expression for the voltage
Support that there. Icincuit Esithu an reasistanee on the and capacitance of /4 F. The EMF is ) 4 Cos 2t , The initial is an RC Cnerat current. The alternating cincuit is '/ 2 L Elt) the cincuit is qu(0) = 1V. Find the charge on the cincuit after t seconds. charge on
An inductive coil of resistance 15 ohms and inductance 0.2 is commented in parallel with a 100 microfarad capacitor to a variable frequency supply.Find the frequency at which the total current taken is in phase with the supply voltage. What is the value of this current if the voltage is 200V.Draw a phasor diagram