An inductor with anresistance of 8.00inductance of 2.50 H and ais connected to the terminalsof a battery with an emf of 5.00 V and negligibleinternal resistance.Part AJust after the circuit is completed, at what rate is the battery supplying electricalenergy to the circuit?Express your answer with the appropriate units.P =Part BOSubmit Request AnswerUL =μASubmitValueWhen the current has reached its final steady-state value, how much energy isstored in the inductor?Express your answer with the appropriate units.μAValueUnitsRequest Answer?UnitsConstants? inductance of 2.50 H and aAn inductor with anresistance of 8.00is connected to the terminalsof a battery with an emf of 5.00 V and negligibleinternal resistance.Part CWhat is the rate at which electrical energy is being dissipated in the resistance ofthe inductor?Express your answer with the appropriate units.PR =SubmitPart DP₂ =OSubmit■μAValueRequest AnswerWhat is the rate at which the battery is supplying electrical energy to the circuit?Express your answer with the appropriate units.μАValueUnitsRequest Answer?UnitsConstants?

Given:- The inductance of the Inductor is L = 2.50 H The Resistance of the resistor is R =8 ohm.…

Answered: An inductor with an inductance of 2.50…

An inductor with an inductance of 2.50 H and a esistance of 8.00 is connected to the terminals of a battery with an emf of 5.00 V and negligible nternal resistance.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: LRC circuit is made from a 225.57 Ohm resistor, an 17.75 mH inductor, and a 0.39 micro Farad…

Q: An RLC circuit is used in a radio to tune into an FMstation broadcasting at f = 99.7 MHz. The…

A: The condition for the resonance frequency in an LCR circuit is

Q: The terminal voltage of a 2-H inductor is v = 10(1) V. Find the current flowing through it at = 4s…

Q: A coil has 2.55-ΩΩ resistance and 121-mH inductance. If the current is 3.00 A and is increasing at…

Q: (a) What is the characteristic time constant of a 27.4 mH inductor that has a resistance of 4.00 Ω?…

Q: Calculate the resistance in an RL circuit in which L = 2.50 H and the current increases to 90.0% of…

A: We know that-Current decay through a LR circuit, I=I01-e-tτ Equation 01here, τ=LRwe can…

Q: A resistor and an inductor of values 3 ohms and 0.4 henry, respectively, are connected in series. If…

Q: It is decided to configure a series circuit with a 20 V source, a 2 kΩ resistor, and a 2.50 H…

A: V= 20v, R= 2kohm , L= 2.5H

Q: A 1-H inductor is connected in series with a 6-ohm resistor. If the connection is energized from an…

Q: A 66.0 mH inductor is connected to an AC source whose emf is represented by the equation E = Emax…

Q: An inductor with an inductance of 2.50 H and a resistance of 8.00 Ohm is connected to the terminals…

Q: An inductor of ?=8.15 H with negligible resistance is placed in series with a ℰ=14.9 V battery, a…

A: Hi please note by mistake here e i have taken equal to 15.3 , because i already solved one similar…

Q: A circuit is constructed with a 12.0-V battery, a 35.0-Ω resistor, and a 1.25-mH inductor. All the…

Q: The inductive reactance offered by a inductor at 50 Hz is 5 2.lf frequency is increased to 100 Hz,…

A: Inductive reactance is the resistance offered by inductor. XL (Inductive reactance) = ωL ω =…

Q: (a) What is the characteristic time constant of a 24.2 mH inductor that has a resistance of 4.10 ?…

Q: A 12.0-V battery is connected to a series circuit containing a 25.0 2 resistor and a 5.00 H…

A: An RL circuit is made by connecting a resistor and an inductor in series or in parallel. The…

Q: What is the maximum voltage across the resistor-inductor combination (Vab)?

A: Given that ε=100sin(2000t). On comparing with v=v0sinωt we can know that v0=100V and ω=2000

Q: An inductor with an inductance of 57.0 mH and a resistance of 15.0N is connected to the terminals of…

A: Given,Inductance L=57mHResistance R=15Ωemf=8V

Q: A solenoid of radius 3.5 cm has 580 turns and a length of 25 cm. Find its inductance. ______mH…

Q: In a series oscillating RLC circuit, R-20 2, C=5 mF, L-20 mH, and e-esin wr with e 45.0 V and w- 300…

A: Given Resistance R = 20 Ω Capacitance C = 5 mF = 5×10-3 F Inductance L = 20 mH = 2×10-2 H Voltage εm…

Q: A 5.00 Ω resistor, an 27.50 mH inductor, and a 13.80 V emf are connected in series. (a)Calculate…

Q: A solenoid having an inductance of 9.23 µH is connected in series with a 1.65 kQ resistor. (a) If a…

Q: 2. A coil having an inductance of 437.5 mH with a negligible resistance is connected in series with…

Q: A solenoid having an inductance of 7.82 uH is connected in series with a 1.68 kN resistor. (a) If a…

A: Given Inductance of the inductor is L=7.82 μH=7.82×10-6 Hz Resistance of the resistor is R=1.68…

Q: A constant voltage of 12.00 V has been observed over a certain time interval across a 2.00 H…

Q: A solenoid having an inductance of 9.26 μH is connected in series with a 1.17 kQ resistor. (a) If a…

Q: A series RL circuit with R = 23Q has a constant voltage E =185 V applied at t 0 by the closing of a…

A: Express the relation for the current in a series RL circuit at any time t if the switch is closed at…

Q: A 50H inductor and a resistance of 30 ohms is connected to a battery whose electromotive force is…

Q: Find the rate at which current must change through a solenoid to produce an emf of 75.0 mV if its…

A: When an AC current is passed through a solenoid a magnetic field is generated. This magnetic field…

Q: An inductor stores 775.79J of energy at a current of 3.19A. What is the inductance of the inductor?

A: Energy stored in an inductor with inductance L and carrying current I is given by E=12LI2 This…

Q: A solenoid having an inductance of 8.53 μH is connected in series with a 1.72 kΩ resistor. (a) If a…

A: Given Data: Inductance (L) = 8.53 μH = 8.53×10-6 H.Resistance (R) = 1.72 kΩ = 1.72×103 Ω.Potential…

Q: LRC circuit contains a parallel-plate capacitor with plates of area 23.50 m^2, separated by 1.47 mm…

A: Area of plate A = 23.50m2Distance between plates d = 1.47x10-3mDielectric constant K =3.32

Q: In the circuit the emf ɛ = 188 volts and the inductance L= 38.4 mH. What will be the magnitude of…

Q: What is the characteristic time constant of a 23.3 mH inductor that has a resistance of 4.09 Ω?…

A: Inductance of inductor: L = 23.3 mH Resistance: R = 4.09 ohm Voltage across circuit: V = 12 V

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

An inductor with an
resistance of 8.00
inductance of 2.50 H and a
is connected to the terminals
of a battery with an emf of 5.00 V and negligible
internal resistance.
Part A
Just after the circuit is completed, at what rate is the battery supplying electrical
energy to the circuit?
Express your answer with the appropriate units.
P =
Part B
O
Submit Request Answer
UL =
μA
Submit
Value
When the current has reached its final steady-state value, how much energy is
stored in the inductor?
Express your answer with the appropriate units.
μA
Value
Units
Request Answer
?
Units
Constants
?

inductance of 2.50 H and a
An inductor with an
resistance of 8.00
is connected to the terminals
of a battery with an emf of 5.00 V and negligible
internal resistance.
Part C
What is the rate at which electrical energy is being dissipated in the resistance of
the inductor?
Express your answer with the appropriate units.
PR =
Submit
Part D
P₂ =
O
Submit
■
μA
Value
Request Answer
What is the rate at which the battery is supplying electrical energy to the circuit?
Express your answer with the appropriate units.
μА
Value
Units
Request Answer
?
Units
Constants
?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Conclusion

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Find the cross-sectional area of an inductor with 20 turns and a length of .314 m. The resistance of the coil is .20 ohms and the time constant has been found to be 4.0ms.
A series RLC circuit consist of L = 1H, C = 0.05 F and an unknown resistance R. If the applied voltage lags the current by an angle of 63.43º, find the value of R. Assume w = 4 rad/s.
A constant voltage of 11.00 V has been observed over a certain time interval across a 2.30 H inductor. The current through the inductor, measured as 1.00 A at the beginning of the time interval, was observed to increase at a constant rate to a value of 8.00 A at the end of the time interval. How long was this time interval?
Three inductors of 20mH, 50mH and 75mH respectively, are connected together in a parallel combination with no mutual inductance between them. Calculate the total inductance of the parallel combination in millineries.
Calculate the resistance in an RL circuit in which L= 0.04 H and the current increases to 90% of its final value in 3.00 ms.
A solenoid with 465 turns has a length of 7.50 cm and a cross sectional area of 2.70×10^-9 m^2. Find the solenoids inductance and the average emf aroumd the solenoid if the current changes from +2.50 A to -2.50 A in 5.33×10^-3 s.
A 15.0-V battery is connected to a series circuit containing a 12.0 resistor and a 2.00-H inductor. In what time interval will the current reach 75.0%.
I need the answer as soon as possible
An unpowered RL circuit has an initial current of 3A. After how many seconds will the current equal 0.75A? The resistance is 11 Ohms and the inductance is 20 H.
(a) What is the characteristic time constant of a 25.2 mH inductor that has a resistance of 4.02 N? ms (b) If it is connected to a 12.0 V battery, what is the current after 12.5 ms? A
Suppose you wish to make a solenoid whose self-inductance is 1.8 mH. The inductor is to have a cross-sectional area of 1.6 x 10-3 m2 and a length of 0.076 m. How many turns of wire are needed?
Consider a 22.5 mH inductor that has a resistance of 4.1 Ω. Part (a) What is the time constant, τ, of the inductor, in seconds? Part (b) If the inductor is connected to a 12.0 V battery, what is the current, I, in amperes, after 10.5 ms?