An impulse generator has eight stages with each capacitance rated for 0.16 uF and 125 KV. The load capacitor available is 1000 pF. Find: (a) the front resistance needed to produce 1.2/50 (usec.) impulse wave, (b) the tail resistance needed to produce the same impulse wave in part (a), (c) the front time constant, and (d) the tail time constant? Use exact method and if: t1=3R1C1C*2/ (C1+ C*2), and t2=0.7(R1+R*2) (C1+ C*2)

An impulse generator has eight stages with each capacitance rated for 0.16 uF and 125 KV. The load capacitor available is 1000 pF. Find: (a) the front resistance needed to produce 1.2/50 (usec.) impulse wave, (b) the tail resistance needed to produce the same impulse wave in part (a), (c) the front time constant, and (d) the tail time constant? Use exact method and if: t1=3R1C1C2/ (C1+ C2), and t2=0.7(R1+R2) (C1+ C2)

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.61P

See similar textbooks

Similar questions

What impedance vector - j25 represents:A. A pure resistance. C. A pure capacitance.B. A pure inductance. D. An inductance combined with a resistance.
What is the average power in ghe single phase ac circuit with the purely resistive load? It is sinusoidal steady state excitation.
The ripple factor for pure dc is Answer:
An inductor, a capacitor, and a resistor are connected in parallel with a function generator. The inductor draws 100mA RMS, the capacitor draws 150mA RMS, and the resistor draws 200mA RMS. Find the magnitude of the total current.
In DC choppers the wave forms for input and output voltages are respectively a. both discontinuous b. discontinuous,continuous c. both continuous d. continuous,discontinuous
Draw the sinusoidal waveform of the AC voltage and current for the given loads below. Describe the characteristics of the waveform for each load. A. Pure resistor B. Pure inductor C. Pure capacitor
Two lossy capacitors with Equal capacitance values and power factors of 0.01 and 0.02 are in parallel, and the combination is supplied from a sinusoidal voltage source. The power factor of the combination is ?
Shown in the figure below is an "RC" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 11.58 Volts and is running at a frequency of f = 1.326e+04 Hz. resistor has a resistance of R = 3750 2 and the capacitor has an capacitance of C = 3.17e-09 Farads. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Write the FORMULA for the phase of the total impedance of the circuit tot = Determine the numerical value of Ztot = Determine the numerical value of Pztot= Determine the current through the circuit: • I(PEAK) = • I(RMS) = Determine the voltage across the resistor: Amps Amps S2 C degrees
If, in one (360 degrees), all of the instantaneous power falls under positive loops (no negativeloops), the load must be:a. A resistorb. An inductor or capacitorExplain:
A thyristor switched capacitor consists of: A. A fixed capacitance and a relatively small a relatively small surge limiting inductance B. A fixed capacitance and a relatively large surge limiting inducatance C. A variable capacitance and a relatively small surge limiting inductance D. A Variable capacitance and a relatively large surge limiting inducatnce
Please answer with explanation.... Constant phase shift is better than linear phase shift. Is this statement correct?
what would happen to the angular delay of Leading Power Factor if we change the capacitor to inductor? and What would happen to the angular delay of Lagging Power Factor if we change the inductor to capacitor?