An IC that contains large numbers * of gates, flip-flops, etc. that can be configured by the user to perform different functions is called a Comparator Programmable Logic Device O
Q: , The magnetic circuit in Fig.4 has following dimensions: 1,=10 cm, l=l,=18 cm, cross-sectional area…
A:
Q: The resistance cylindrical core having 3 in diameter and 10 in height saturated 100 % with formation…
A: Given Resistance 1 = 10 ohm And resistance 2 = 85 ohm We need to find the Water saturation of the…
Q: 3-ph, 3-wire balanced load with a lagging power factor is supplied at petween lines. A single-phase…
A:
Q: Le transfer function from input R(s) to output Y(s) Y(s) R(s) 1/s 1/s Y(s) %3D 3s+1 r: R(s) s(7s+2)
A:
Q: (3 decimal places final answe please!) If Iab is equal to 303.109∠97 and Ib is 175∠307, Ic should…
A:
Q: In the feedback system shown in Figure Q3, the controller and the plant have the following transfer…
A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…
Q: An IC that contains large numbers * of gates, flip-flops, etc. that can be configured by the user to…
A: Given: An "IC" that contains large number of gates, flip-flops etc
Q: A 3-ph, 3-wire balanced load with a lagging power factor is supplied at 400 V between lines. A…
A:
Q: a) Find the value of R that will cause 4 A of current to flow through the 802 resistor in the…
A:
Q: 2. Full Wave Bridge Rectifier a. Determine V, and the required PIV rating of each diode for the…
A: We need to analyse the given full wave rectifier circuit .
Q: Fill in the blanks / identification: ror the circuit in Fig. 2.77, use ĶCL to find the branch…
A:
Q: are slower than .... combinational circuit PROM Sequntional circuit O Synchronous circuit
A: Sequential circuits are slower than combinational circuits. The sequential circuit is made by…
Q: For a standard AM receiver with an RFcarrier of 1500 kHz and Q = 150, determine a. Local…
A:
Q: If Vc is equal to 275∠193 and Vab is 476.314∠103, the phase sequence is:" POSITIVE…
A:
Q: 5. The two-wattmeter method is used to measure the power consumed by a delta connected load. Each…
A:
Q: * serial adder is an example of combinational circuit O grated circuit Sequential Circuit O
A:
Q: Calculate V1 and V2 in the circuit shown in Fig. 10.6.
A:
Q: (a) A signal band-limited to 500 kHz is sampled at the rate 50% higher than the Nyquist rate and…
A: It is Given that: fn=500kHz sampled at 50% higher fnfm'=1.5 fm
Q: "If Vc is equal to 285∠97 and Vab is 493.634∠7, the phase sequence is:"
A:
Q: () What is the motor armature current? (a) 99 A (b) 102 A (c) 107 A (d) 110 A (e) 115 A (ii) What is…
A:
Q: Q5. Solve the following classification problem with the perceptron rule. Apply each input vector in…
A: Given that; p1=22, t1=0p2=1-2,t2=1p3=-22,t3=0p4=-11,t4=1
Q: Design a 2-bit priority encoder. D0 is the highest priority. Include truth table and equation.
A:
Q: (A) An antenna has far field electric field intensity E(O)= 3+2cos O for 0 <e =< n and 0 =< ¢ =< 2n.…
A: Solution
Q: For the following multi-input/multi-output system. detemine all possible transfer functions…
A:
Q: The output in Mealy model depend on only the present state True O False
A: We need to tell about whether the given statement is true or false.
Q: V V V A B C V V D E А. В. С. D. Е. %3. A.
A:
Q: What is the equivalent transfer function: u(s)+ y(s) G(s) H(s)
A:
Q: 3. In the figure shows a circuit with five elements. If P1 = -205 W, P2 = 60 W, p4 = 45 w, P5 = 30…
A:
Q: B) For the circuit shown in Fig. (6). Determine the Norton equivalent between a and b. XL YL 31.-0…
A:
Q: 1. Phase voltages = 23120°, of a star-connected alternator are E, 2312 - 120°, and E. 2312120°. What…
A:
Q: Variant 2 Determine the type of element and its main parameters. 105 台H-
A: 1. The given figure is shown below: The above illustration depicts a Mylar capacitor. In electronic…
Q: Explaining circuit for (part1)(part2)(part3) ? & What is the common between them ?
A: Given: Consider the given figure: To find: Explaining circuit for (part1)(part2)(part3)? What is…
Q: 1. Find the transfer function from input R(s) to output Y(s) Y(s) R(s) 3 1/s 1/s Y(s) R(s) 3s+1…
A:
Q: The heat absorption and rejcction tempcraturcs of a Carnot Q.2 refrigeration cycle are -8°C and 55°C…
A:
Q: Let V = 6xy?z3 + 5 In(x? + y? + 3z?)V in free space. Evaluate each of the following quantities at…
A: Brief description: In the above given question they have mentioned a scalar field of the potential.…
Q: If Vb is equal to 275∠313 and Vbc is 476.314∠343, the phase sequence is:" POSITIVE…
A: Given VB and vbc voltages.we need to determine the phase sequence. Please find the below attachment…
Q: Basic Electrical Engineering You have been sent to a new home. The homeowner reports that sometimes…
A: Given,The parameters of the circuit breaker are,V=240VI=60ATo turn on the stages,The furnace…
Q: H.W. In the network in Figure shown below, V. is known to be 8 45°V. Compute Vs: HE 2Ω + V j20
A:
Q: If Iab is equal to 303.109∠97 and Ib is 175∠307, Ic should be
A: Current: It is the time rate of the change of the charges. It flows from high voltage to low voltage…
Q: Two balanced loads are connected in parallel to a three-phase, 460-V source. Load A is 900 kVA at a…
A: In
Q: Lef V = 6xyʻz° + 5 In(x² + y +3z4)V in free space. Evaluate each of the following quantities at…
A: Given V=6xy2z3+5 ln(x2+y2+3z2) V in free space.point P( 2 , 3 , -1 )Here we have to deterrmine the…
Q: 3.53 Find V, in the network in Fig. P8.53 using nodal analysis. V 2Ω 1Ω j2 0 12/0° V 2/0° A 4/0° V…
A:
Q: (a) Calculate current i in Fig. 2.68 when the switch is in position 1. (b) Find the current when the…
A:
Q: (f) For the block diagram of a control system shown in Figure Q1b, derive the closed-loop transfer…
A:
Q: Find lo in the network using the current division rule. Choose the cori 12 mA 32 kn 6 kn 3 kn
A: Given,
Q: Determine the impulse response and frequency response of the LTI system defined by, y(n) = x(n) + b…
A:
Q: 3. Let V = 6xy?z3 +5 In(x² + y² + 3z²)V in free space. Evaluate ea following quantities at P(2,3,…
A: In this question we will find potential , electric field and electric flux density at given point…
Q: 4. Find Vo in circuit A and I in circuit B 1,=2 A 1A 28 V 6A 12V_ 1A 3 V 4A 9 V 9V 28 V 6 V 30 V V.…
A:
Q: (f) For the block diagram of a control system shown in Figure Q1b, derive the closed-loop transfer…
A:
Q: What is the input impedance of Common Emitter Collector Feedback preamplifier whose Collector…
A: The collector feedback circuit have a path from collector to base. The feedback increase the…
Step by step
Solved in 2 steps with 2 images
- Noise margin is the amount of O a. noise voltage that a logic gate can tolerate O b. signal voltage that a logic gate can tolerate O. both signal and noise voltage that a logic gate can tolerate O d. None of the choices are correctLOGIC GATE ( NEED ONLY HANDWRITTEN SOLUTION PLEASE OTHERWISE DOWNVOTE).Select a suitable example for for combinational logic circuit. O a. None of the given choices O b. De-multiplexer O c. PLA O d. Latches
- The numbers from 0-9 and a no characters is the Basic 1 digit seven segment display * .can show False True In a (CA) method of 7 segments, the anodes of all the LED segments are * "connected to the logic "O False True Some times may run out of pins on your Arduino board and need to not extend it * .with shift registers True FalseNoise margin is the amount of O a. both signal and noise voltage that a logic gate can tolerate O b. noise voltage that a logic gate can tolerate O c. None of the choices are correct O d. signal voltage that a logic gate can tolerateImagine the output of IC 7404 can feed a maximum of five LED's, then which of the following statement is correct O a. Fan In and Fan Out cannot be determined from the given data O b. Fan In of the logic gate is 5 O. Fan Out of the logic gate is 5 O d. Fan In of the logic gate is 1 and Fan Out of the logic gate is 5
- An OR gate performs an ORing operation on two or more than O zero logic variables O three logic variables. one logic variables. O two logic variables.Electrical Engineering Draw 2, 1 bit ALUS to create a basic 2 bit ALU. the carry out and carry in bits must ripple across. The ALU should subtract/add, logical NOR, logical AND, and logical OR. Draw out the adding logic circuit(c) Figure Q3(c)(i) shows a register and Figure Q3(c)(ii) shows the input waveforms (CLOCK and Data in) to the circuit. A1 A9 A10 A2 Function generator A3 A11 A12 AS A13 A6 A14 A7 A15 Data in Bop.7) ip.r 82p.7) Logic analyser U1 U2 U3 U4 UO 6. 1. 6 1 6 INVERTER 3 CLK 3 CLK oCLK CLK 5 K K 5 K K 4027 Clock Function generator Figure Q3(c)(i) (i) Determine the type of register as shown in Figure Q3(c)(i).
- The logic circuit: (From minimum SOP) Number of gates used in the circuit: 2-Input AND gate.. 2-Input OR gate. NOT gate Number of idle gates in the chip: 2-Input AND gate 2-Input OR gate... NOT gute The logic circuit: (From minimum POS) gates gates gates gates gutes Number of gates used in the circuit: 2-Input AND gate 2-Input OR gate... NOT gate Number of idle gates in the chip: 2-Input AND gate... 2-Input OR gate, NOT gate, IC name: IC name: IC name: gates IC name: gates IC name: gates IC name: gates gates gatesQ/What are the uses of logic gates?Figure below shows the symbol of which type of logic gate? D A B