An engineer is creating a solid model of a simple gear using SolidWorks. Choose the correct statement below. The only way to generate multiple gear teeth is to sketch each tooth individually and then extrude each tooth individually. The engineer can use the linear pattern tool to create an array of gear teeth in a circular pattern about the center of the gear from a sketch of a single tooth. The engineer can use the circular pattern tool to create an array of gear teeth in a circular pattern about the center of the gear from a sketch of a single tooth. It is not possible to model gear teeth in SOLIDWORKS due to the complex

The answer is one of the options below please solve carefully and circle the correct option Please write clear .

23

I need these three parts answered, if you are unable to answer all three parts please leave it for another tutor to answer, thank you.

What’s the correct answer for this please?

Generate isometric drawing from multiviews using drawing tools or free - hand. Use approximate proportionate dimensions. Use plane sheet to draw or sketch isometric drawing.

Sketch the top, front and right side views of the isometric. Scale the orthographic views so that one grid unit on the isometric is one grid unit on the rectilinear grid.

Draw the three projections of the body in Figure 1- using AutoCAD 1-Do not write the dimensions on the drawing 2- Draw with the same measurements as shown 3 -Show graphics properties At least properties are required for the circle and arc R10 R20 40 35 55 -1- JSI 9.

solve both, first one solve for total gear ratio not velocity and second one use table but please use relative velocity instead of x/y and show all setps/solution

Below is problem MV1 from the course pack. In an earlier assignment, you created a multiview drawing of this part. Model this part with SolidWorks, with each grid spacing equal to one inch. Create a SolidWorks drawing of this part, with Front, Top, and Right Views. Import dimensions from the SolidWorks part file, and place them on the drawing so that they can be easily read. Add a note that all dimensions are inches. Add your personalized title block that you created in Chapter 2 to this drawing. *Important: Save the drawing first as SolidWorks Drawing (filetype *.slddrw) and then as an eDrawing (filetype *.edrw)! You will upload the eDrawing in Blackboard, not the SolidWorks Drawing - the SolidWorks drawing is associated with the part file, I cannot open the sw drawing unless you also send the part file; however, l can open the eDrawing without the part file.