Answered: An aluminium spere is 8.75 cm in…

An aluminium spere is 8.75 cm in diameter. What will be its % change in volume if it is heated from 30 degrees C to 160 degrees C?

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter10: Thermal Physics

Section: Chapter Questions

Problem 22P: A construction worker uses a steel tape to measure the length of an aluminum support column. If the...

See similar textbooks

Related questions

Q: The filament of a 75-W light bulb is at a temperature of 3300 K. Assuming the filament has an…

A: Write the equation to calculate the power radiated by the bulb

Q: A copper telephone wire has essentially no sag between poles 34.0 m apart on a winter day when the…

A: Given data: Original Length (L0) = 34.0 m Initial temperature (T0) = -20.0°C Final temperature (T)…

Q: An aluminum flagpole is 33 m high. By how much does its length increase as the temperature increases…

A: The initial length of the aluminium flagpole is 33 m, and the change in temperature is 15 degree…

Q: How long in minutes will it take a 1-kW. 230-volt percolator to raise the temperature of 1.8 kg of…

A: Power of percolator: P = 1000 Watts Mass of water: m = 1.8 kg Initial temperature of water: Ti =…

Q: 5290 J of heat is given to 0.500 kg of water at 15 degrees celsius. What will the final temperature…

A: Given information: The mass of water (m) = 0.500 kg The initial temperature of water (Ti) = 150 C…

Q: A copper telephone wire has essentially no sag between poles 35.0 m apart on a winter day when the…

Q: How much lead can 500 J of energy heat by 20 degrees C?

A: Given: Heat energy given to lead, ∆Q = 500 J Rise in temperature of the lead, ∆T = 200C To Find:…

Q: The circles represent a phase change at constant temperature: Is the value of…

A: Heat is not given to system because the operation is done at constant temperature . Hence q is zero.…

Q: i measured the freezer temperature to be -4.05 degrees Celsius. What is this in SI units?

A: Given data: Temperature in Celsius scale TC = -4.05°C Required: Temperature in SI unit

Q: In the morning, a paintball pressure tank is at 306 atm. The weather heats up over the course of the…

Q: What will be the final length of a copper rod when it is placed in a hot water bath with 95°C…

Q: Some incandescent light bulbs are filled with argon gas. What is vrms (in m/s) for argon atoms near…

A: Given data: Temperature (T) = 2900 K

Q: The filament of a 75-W light bulb is at a temperature of 4,150 K. Assuming the filament has an…

A: Given data The power of the light bulb is: P = 75 W The temperature of the light bulb is: T = 4150 K…

Q: The volume of a given mass of a gas at 27 degree C , 1 atm is 100cm3. What will be its volume at 327…

A: In order to define how gases expand when they gets heated is by using the Charles law. This says

Q: A round bottom glass flask is filled to the mark with 250 cm³ of mercury at 20°c. If the flask and…

A: Original volume (V) = 250 cm3 Original temperature = 20 degree celsuis Final temperature = 40 degree…

Q: An electric heater carries 12A at 110V, is submerged in 22.5lbs of water for 30minutes. What will…

A: Power supplied =IV=12×110=1320 W Hence energy supplied =1320×t=1320×30×60=2376000 Joules specific…

Q: A 100-mL cylindrical lead container was completely contained with mercury at 20.0°C. If it was…

A: The equation for the volume expansion is as follows: ΔV=γVΔT, where ΔV is change in volume V the…

Q: The filament of a 75-W light bulb is at a temperature of 3 300 K. Assuming the filament has an…

A: The expression required area is,

Q: A bar of an unknown metal has a length of 0.975m at 45°C and a length of 0.972m at 23°C. What is its…

A: Answer:- We know that the equation ∆L = (alpha)L1∆T alpha = coefficient of linear expansion. alpha…

Q: Suppose a run containing 34.5 grams of water is cooled from 20 degrees C to 5 degrees C. How much…

A: Given, Mass of the water, m = 34.5 g Initial temperature Ti=20∘C Final temperature Tf=5∘C Heat…

Q: A bulb delivers 45 W of radiant energy when its filament is at 1200 °C. If the temperature increases…

Q: Compute the increase in length of 50m of copper wire when it's temperature changes from 12degrees to…

Q: The filament of a 75-W light bulb is at a temperature of 3,700 K. Assuming the filament has an…

A: (given) Power of filament (light bulb) = 75 W At Temperature (T)= 3700 K…

Q: A brass rod is 0.5 m long at 20°c. What is the final length of the rod if it is heated to 50°c?

A: We have to use some basic formula here.

Q: A car tire is under STP conditions. If the volume does not change, what is the pressure (in atm)…

A: At STP conditions: Number of moles, n = 1 mol Ideal gas constant, R = 0.08205 L·atm/mol·K The…

Q: How much steam at 250°F would be required to heat 10 lb of water from 70°F to 210°F in a direct…

A: we know that heat loss by steam = heat gain by water When phase will change = m L L= Latent…

Q: (I) How much heat (in joules) is required to raise thetemperature of 34.0 kg of water from 15°C to…

Q: A copper wire is 25.0 cm long at 39.0oC. What is the increase in length when it is heated to 86.0oC?

Q: The brass bar and the aluminum bar in the drawing are each attached to an immovabl wall. At 24.2 °C…

A: GivenTemperature, T=24.2°CThe air gap between the rods, L=1.29×10-3 m

Q: Some incandescent light bulbs are filled with argon gas. What is vrms (in m/s) for argon atoms near…

Q: A steel rod has a length of 2.5 m. It is then heated by 44C°. What is its new length?

Q: (I) To what temperature will 8200 J of heat raise 3.0 kg ofwater that is initially at 10.0°C?

A: The amount of heat required to raise the temperature is Q=mcT-Ti

Q: How much steam at 250F would be required to heat 10 lb of water from 70F to 210F in a direct…

Q: to be 26° C. What is the speciic ** 21. A metal cylinder is made of 50 g of silver and 120 g of…

Q: The filament of a 75-W light bulb is at a temperature of 2,650 K. Assuming the filament has an…

A: The expression for power radiated according to Stefan Boltzmann law is, P=AσeT4…

Q: A copper flask with a volume of 201 cm3is filled to the brim witholive oil. If the temperature of…

A: The initial volume of a copper flask is, The initial temperature of a system is, The final…

Q: How much time is needed to boil a 1kg water @ 20°C using a 1kW electric kettle? If the rate of…

Q: A copper sphere initially has a size of 2.98cm³ at 28.52°C. At what temperature (in K) will this…

A: here volume of the copper is given V=2.98 cm3 corresponding temp = 28.52 C increase in volume ∆…

Q: The room thermostatis set at 68.0oC. What is thetemperature setting for the room indegrees…

Q: The glowing filament in a lamp is radiating energy at a rate of 60 W. At the filament’s temperature…

Q: A copper wire has a cross section of 2.5 mm^2 and a length of 2 meters. What is the electrical…

Q: Typically, scuba tanks are immersed in water to cool them as they are filled with compressed air. If…

Q: How long would it take a 1-kW heater to melt 1 kg of ice at -20oC, assuming all the energy from the…

A: Given data: Power, P=1 kW=1×103W Mass of ice, m=1 kg Temperature, Ti=-200C

Q: A cook puts 9.00 g of water in a 2.00-L pressure cooker that is then warmed to 500 C. What is the…

Q: To help keep his barn warm on cold days, a farmer stores 837 kg of solar-heated water (Lf = 3.35E+5…

A: Heat energy required to cool the water and thereafter for complete freezing is,

Question

An aluminium spere is 8.75 cm in diameter. What will be its % change in volume if it is heated from 30 degrees C to 160 degrees C?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

How long does a 52 kW water heater take to raise the temperature of 170Lof water from 20°C to 37°C? The specific heat of water is 4186 J/kg-K. The density of water is 1.00 g/cm,
23.0 g of copper pellets are removed from a 300 degree celsius oven and immediately dropped i to a 80.0 mal of water at 20.0 celsius in an insulated cup. What will the new water temperature be? Please help! I can't figure this question out.
An 1800 kw electric resistance heater is immersed in 40 kg of water at 20o C. How long will it take the temperature to rise to 80∘C?
A hot, just-minted copper coin is placed in 103 g of water to cool. The water temperature changes by 8.22°C and the temperature of the coin changes by 88.1°C. What is the mnss of the coin? Disregard any energy transfer to the water's surround- ings and assume the specific heat of copper is 387 J/kg- C. The specific heat of water is 4186 J/kg- C. Answer in units of g- O1. 122871 O 2. 128.638 O 3. 129.928 4. 116.608 5. 112./99 6. 139 655 8. 111.56 110.329 HO103.949
(a) If the partial pressure of water vapor is 8.05 torr, what is the dew point? (760 torr = I atm 101, 325 Pa) (b) On a warn day when the air temperature is 35 and the dew point is 25 , what are the partial of the water in the air and the relative humidity?
An infrared heater for a sauna has a surface area of 0.050 m2 and an emissivity of 0.84. What temperature must it run at if the required power is 360 W? Neglect the temperature of the environment.
A construction worker uses a steel tape to measure the length of an aluminum support column. If the measured length is 18.700 m when the temperature is 21.2C, what is the measured length when the temperature rises to 29.4C? Note: Dont neglect the expansion of the tape.
In order not to damage the resistance in the kettles, the difference between the temperature ofthe heater and the fluid should not exceed 25 oC. If the heat transfer area between the fluid andthe heater is 78.5 cm2 and the heat transfer coefficient is 400 W/m2.K, find the maximumallowable power of the heater in order to boil water?
An object has an emissivity of 0.725. At temperature T, it radiates heat at a rate of 10.W. What is its rate of heat radiation at temperature 2T?
A walrus transfers energy by conduction through its blubber at the rate of 150 W when immersed in -1.00C water. The walrus’s internal core temperature is 37.0C, and it has a surface area of 2.00m. What is the average thickness of its blubber, which has the conductivity of fatty tissues without blood?
What is the length of a copper rod at 421 Kelvin, if the rod was 93m long at 10 degrees F.
To determine the specific heat of an oil, an electrical heating coil is placed in a calorimeter with 380g of the oil at 10°C. The coil consumes energy (and gives off heat) at the rate of 84W. After 3 minutes, the oil temperature is 40°C. If the wate equivalent of the calorimeter and coil is 20g , what is the specific heat of the oil?