An alternating voltage is given by v1 = 75 sin( 200Ttt -0.25 ) volts. What is the phase angle differencein Degrees in relative to v2 = 75 sin( 200 tt)?Phase Angle Difference in Degrees = The average value of a complete sine wave is notzero.Select one:TrueO False

Answered: An alternating voltage is given by v1 =…

An alternating voltage is given by v1 = 75 sin( 200 Ttt -0.25 ) volts. What is the phase angle difference in Degrees in relative to v2 = 75 sin( 200 t)? Phase Angle Difference in Degrees =

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 7RQ

See similar textbooks

Related questions

Q: An alternating voltage is given by v1 = 75 sin( 200 Ttt -0.25 ) volts. What is the phase angle…

A: Phase angles Difference in degree= -45°

Q: certain current lags the voltage by 36 electrical degrees. The voltage waveform is increasing…

A: We need to find out phase angle between current and voltage and time for current become zero and…

Q: AV Şekil 1 Şekil 2

A: The phase displacement between voltage and current can given us an idea about the type of load…

Q: A non-sinusoidal voltage eT=15+100sin1000t+75cos2000t- 50sin3000t volt is applied to the circuit…

A: The solution is given below.

Q: Given the following Resistances and Inductors in Series and Voltage Source: R1 = 1,251 ohms R2 =…

Q: A wire carries a current, ? = 3 cos 314? ?. What is the average current over 6 seconds?

Q: Pls show the step by step solution thank you. A certain current lags the voltage by 36 electrical…

Q: A 3-ph overhead line is being supported by 4 disc insulators. The potentials across

A: Given, n=4 V2=12kV=k+1V1V3=16kV=k2+3k+1V1Dividing V3 by V2 -1612=k2+3k+1(k+1)3k2+5k-1=0solving this…

Q: 1. a) What ao the areas of the circuit labeled "A", "B“, and" C" do? b) Explain the operation of the…

Q: Two different types of currents are encountered in the household. These are Question 9 options:…

A: There are two type of current which is encountered in household that are alternating current which…

Q: Q2 (a) Explain the generation of single phase alternating voltage. Illustrate with a diagram.

A: Introduction: Single phase AC (Alternating current) supply can be generated with single phase AC…

Q: Given the following Resistances and Inductors in Series and Voltage Source: R1 = 46 ohms R2 = 33…

Q: 5. Three alternating currents are given by i, = 141 sin(wt + 45°); iz = 30 sin (wt + 90°); iz = 20…

Q: The meter constant of a single phase 230 V induction watt hour meter is 400 rev/kWh. The speed of…

A: Given, a induction watt hour meter having Voltage, V= 230 V Current, I= 10 A Meter constant, K= 400…

Q: What is the phase difference between the following pairs of voltages and currents? 1. v = 10 sin…

A: Given: 1. v=10sinωt, i=5sinωt2. v=8sinωt, i=5sinωt-10°

Q: n the phasor space for the circuit in the figure I1 which of the voltages of the current are given…

A: First of all, before proceeding, we will first understand the dot terminology of the above circuit.…

Q: Determine the maximum instantaneous positive voltage drop across Rin the series AC/DC circuit below.…

A: Given circuit, Vrms=18.3 VVdc=17 VR=1 kΩ

Q: Draw the waveform of voltage and current under the following conditions: A current which lags the…

A: In this question, We need to Draw the waveform of voltage and current under the following…

Q: Assume you are working on sinusoidal ac supply voltage which is in the form of 150 sin 220 t. So…

A: In the theory of alternating current, a sinusoidal waveform can be generated by using a single-coil…

Q: Od. 90.35 ohms QUESTION 8 An inductor has an inductive reactance of 24 ohms, and a resistor…

Q: State Ohm's Law and explain Explain the difference between

A: In this question we will write about ohms law, ac and dc power....

Q: An alternating voltage is given by v1 = 95 sin( 200 Tit -0.3 ) volts. What is the phase angle…

A: Given: V1=95 sin200 πt-0.3Volts V2=95 sin200πt

Q: Can you help with subparts 11a-11c Consider the electric circuit in the figure below with the…

Q: A pure element is connected across an AC signal. CH1 and CH2 measures the voltage and current, r CH1…

A: Given waveform shown CH1 settingsVolts/Div :83 vTime/Div :3 msProbe Settings: X1CH2…

Q: A certain current lags the voltage by 36 electrical degrees. The voltage waveform is increasing…

Q: A non-sinusoidal voltage eT=15+100sin1000t+75cos2000t- 50sin3000t volt is applied to the circuit…

Q: (a) An electrodynamic wattmeter is used to measure the electrical power in a circuit. The diagram in…

Q: The figures below show four arrangements of charged particles, all the same distance from the…

Q: Given the following Resistances and Inductors in Series and Voltage Source: R1 = 1,664 ohms R2 =…

A: inductive reactance = 2π×frequency×inductance. if two impedances Z1 and Z2 are connected in series…

Q: an ac circuit produces a current of 1-j2 amperes. If the voltage is 10∠0 or just 10 volts. Find the…

Q: What is the value of the conductance of z = 5+ 10j ?

A: Given: Z=5+10j Z=R+jXL

Q: Determine the maximum instantaneous positive voltage drop across Rin the series AC/DC circulit belo…

A: Given AC/DC circuit, Where, AC supply voltage, Vrms=18.3 V DC supply voltage, Vdc=17 V Resistance,…

Q: No Statement True or False Electricity can be defined as the movement of electrons through a i.…

A: As per Bartleby guidelines we are allowed to solve only three subparts, please ask the rest again.

Q: The Dc value of a pure Ac voltage source is zero Select one: True False

A: In this question we need to verify the given statement is true or false

Q: In Figure 2, what is Vo in rms volts? 16 kW 0.9 pf lagging 20 kW 6/0° A rms Vo 0.8 pf lagging Figure…

Q: B- Sketch the VR waveform for the circuit shown in figure 2-b. Ao V5 12 V R6 1.4kQ2 M RA R5 SW1 D1…

A: VR across waveform for circuit b -For this SCR will only conduct for positive applied voltage at…

Q: Determine the electric current that flows into the circuit in the Figure below. a.-1.6A b. 1.6A c.…

A: Given, The circuit is,

Q: Q1- If a voltage waveform has the following expression: E = 100 sin (240 t + 30°) V Then it has the…

A: Expression of voltage is given, Standard expression of voltage is given by,

Q: Please show the complete step by step solution thank you so much. A certain current lags the…

Q: Why is it that alternating current is most advantageous for providing huge power over the direct…

Q: Across a 230V, 60Hz powers supply is a 15ohm non-inductive resistor. What is the equation of the…

Q: True or False The resistor R characterizes alternating current circuits

A: The answer is FALSE. RESISTOR R has same characteristics for both Alternating and direct current.…

Q: 1. The following questions refer to the circuit shown below. a) What do the areas of the circuit…

A: Here in the given circuit which is labeled as 'A' is an optocoupler circuit consisting of a light…

Q: The power taken by a resistive coil made of copper wire is 1200W at 120V and 15 0C. Calculate the…

Q: Q26 a). An alternating voltage is given by v-300 sin(400 Ttt +0.55) volts. Find (i) Peak to Peak…

Q: 9. For the circuit of Figure 4.8, determine voltages across R, L and C if the source is 7 volts RMS.…

A: In this question we need to find a voltage across R, C and L.

Q: Question I VI hz The circuit is at steady state. R = 1.5 k0, R2 = 3.5 kn, L= 38 H, C = 57 µF, and…

Concept explainers

Synchronous Generator

In comparison to an asynchronous generator, it is a machine where the rotor speed is equal to the rotating magnetic field produced by the stator, i.e., mechanical speed is equal to the electrical speed, thus called synchronous, and not asynchronous.

Salient Pole Rotor

Salient pole rotor includes a large number of exposed poles mounted on a magnetic wheel. The construction of a bright pole is as shown in the image on the left. The proposed poles are made of metal laminations. The rotor winding is provided on these poles and is supported by pole shoes.

Question

An alternating voltage is given by v1 = 75 sin( 200
Ttt -0.25 ) volts. What is the phase angle difference
in Degrees in relative to v2 = 75 sin( 200 tt)?
Phase Angle Difference in Degrees =

The average value of a complete sine wave is not
zero.
Select one:
True
O False

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The current through a 15kohm resistor is given below, using Ohm’s Law to find the voltage, convert to polar form, complete the math, then convert back to the waveform at i1 = 3.5sin(2500t) mA and i2 = 2.3sin(200t – 60°) mA
A 60 cycle alternating current with a maximum value of 10 amperes has an instantaneous value of 5Amperes when t=0 while di/dt is positive. What is the equation of the current wave?
7. In a pure inductive circuit, the phase angle between the voltage waveform and current waveform will havephase shift * 180 deg O deg 45 deg O 90 deg 8. Why do we say the "voltage across" or "the voltage with respect to?" Why can't we just say voltage? * Voltage is a measure of electric potential difference between two electrical points. O It's an electrical cliche. The other point could be negative or positive. None of the above.
Calculate the RMS current through R2 in the diagram IR1 = 6.06mA peak, R2 = 2.7 kohms, total current is 9.522mA RMS 3.25mA RMS 5.24mA RMS 7.41mA RMS 9.0mA RMS
A 20 V peak sinusoidal voltage is applied to the circuit in Figure 2 in place of the dc source. Draw the output waveform to make IZ = 40 mA. Assume VZ = 12 V at 30 mA and ZZ = 30 V. VIN Question 2 VMP R Figure 2 14°C Sunny
For the Photoflash unit. Vse 9V. RISKO C-1500 uf. R2= 120. The average power dissipated by the lamp is High voltage de supply 6.75W 8.3W 0.675W 10W 0.6W The mutual inductance sign for the following circuit is 352 www Negative R₂ Positive 2 mH 3 mH ell 5 mH www 10 Ω
The frequency of the sinusoidal voltage source in the circuit in (Figure 1) is adjusted until the current io is in phase with vg.
What is the complex expression for a given alternating current i = 250 sin(wt-25 deg)?
Question 5 Three alternating currents are represented by sine wave A, B and C as shown in Figure 6 below. (a) Draw the phasor diagram for waveform A, B and C. (b) Obtain the three sine wave equations to represent waveform A, B and C. (c) State the relationship between the three waveforms in terms of leading or lagging phase. V (V) 10 8 5 0. –20°/045° 90° 180° 360° Figure 6
An alternating current is given by I = 22sin222t. What is the time to generate 3 cycles of current? Group of answer choices 0.014s 0.0012s 0.2s 0.1s
A voltage wave is given by v=100 sin 314t. how long does it take this waveform to complete one fourth cycle?
An alternating voltage is given by v1 = 95 sin( 200 Tit -0.3 ) volts. What is the phase angle difference in Degrees in relative to v2 = 95 sin( 200 t)? Phase Angle Difference in Degrees =