Answered: An alternating voltage given as; V=100…

An alternating voltage given as; V=100 √2 sin100t is applied to a capacitor of 1 µF. Calculate the current reading on the ammeter.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: Find the charge q(t) on the capacitor and the current i(t) in the given LRC-series circuit. L = h, R…

Q: In the circuit in Figure Q1.38, the supply voltage is 14.2 V r.m.s. The current in the circuit is:…

A: Given, Erms= 14.2 V R, resistance = 75 Ω XL, Inductive reactance = 120 Ω We know for an LR circuit,…

Q: One wire in a high-voltage transmission line carries 1 000 A starting at 560 kV for a distance of…

A: P=I2R

Q: R1 IR3 IR1 Ir2 = 2.0A %3D R2 R3 V1 = 6.0V V2

A: I2 = 2 AR2 = 4 ohm V1 = 6 v R1 = 2 ohm R3 = 5 ohm

Q: Consider the circuit shown in the figure. A short time after closing the switch, the charge on the…

A: Let initial charge be Q and charge on the capacitor after t seconds is q.q = 80% of QTime constant,…

Q: Electrical energy is converted to heat at the rate of 7.56kJ/min in a resistor which has 270 C/min…

A: Given: The rate of heat energy across the resistor is 7.56 kJ/min. The rate of the charge is 270…

Q: 4). We have a series RC circuit. (R is 1200 ohms, C is 50 microfarads.) The capacitor is initially…

A: The charge on a capacitor in an RC circuit can be given as

Q: Two units of DC voltmeters, A and B are used to measure a voltage from a resistor R2 as in Figure Q4…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: A heart defibrillator being used on a patient has an RC time constant of 10.5 ms due to the…

Q: If v(t) = (45 + 29.2cos(wt) + 29.2sin(wt) +25cos(2wt) + 25sin(2wt) + 13.3cos(3wt) + 13.3sin(3wt)…

A: Given:

Q: For the circuit shown in Fig. Q1(a), the capacitor is initially charged to 3.5 V with polarity…

A: Given Capacitor voltage VC 0- = 3.5 V compute the voltage Vc t and the current Ic t when the switch…

Q: 1. 1000 400 0 200 0 7v

Q: Mel Lin, an engineering professor sets up the circ snown in the figure. The reading of the voltmeter…

A: According to ohms law - V=IR Reading of Voltmeter and Ammeter are - Vr=6.50 vIr=2.50 mA1 A = 1000…

Q: The circuit in Figure has been connected for a long time. Taking R 1 = 2.00 Ω, R 2 = 7.00 Ω, R 3 =…

Q: In a RC circuit with power supply with an emf of 20 V. capacitance 3 uF, and resistance 1000 Q, the…

A: Given : Emf = 20 VCapacitance = 3 μF =3×10 -6 FResistance =1000 Ω

Q: 50.0 V Consider the circuit with R = 205 kQ and C = 256 µF. If the capacitor is initially uncharged,…

Q: Te-Learning Portal Courses - Reports e-Services - Academic Departments - ETC - CIMS - Salim During…

A: a) R = 14/3.1 = 4.52 Ohm b) fractional uncertainty ∆R/R = (∆V/V+∆i/i) = (0.5/14) + (0.2/3.1) =…

Q: A current of 5te" ampere flows through a 0.1 F capacitor. Determine the voltage v(t) across the…

A: As per our policies, I can answer only first question. The detailed solution of first question is…

Q: Four resistors, R1 = 100 ohms, R2 = 250 ohms, R3 = 350 ohms, and R4 = 200 ohms are connected such…

Q: Circuit Problem: Express each labelled voltage and current (e.g., vx, ix) in terms of the…

Q: In the circuit below the value of the resistance 4.2 Ω and the value of the capacitance is 2.0 µF.…

A: Given, An RC circuit. The circuit is closed at t=0.Resistance (R) = 4.2 ΩCapacitance (C) =2 μF =…

Q: Problem 18: A battery with terminal voltage ΔV = 1.5 V contains E = 1.9 kJ of energy. It is…

A: Terminal voltage of battery ∆V=1.5 VPower of Light bulb P=7.5 WEnergy E=1.9 KJ =1900 J

Q: An unknown source has in it resistances in series, 4 Ω, 8Ω, and 20 Ω. If the voltage drop in the 8 Ω…

Q: Create an illustration of a series circuit that connects a battery and five capacitors and with a…

Q: 50 ΩΕ 100 ΩΕ 20 ΩΕ +

Q: Gloria, a lab technician for an electronics company sets up the circuit shown in the figure. The…

A: Reading of voltmeter = 7 V Reading of ammeter = 3.50 mA R1 = 3000 ohm

Q: Differential Equations: Electric Circuits When a resistance R (ohms) and a capacitance C (farads)…

Q: What are the expected readings of (a) the ideal ammeter and (b) the ideal voltmeter in Figure?

A: A voltmeter is used to measure voltage between two points and will be connected parallelly between…

Q: A heart defibrillator being used on a pation has an RC time constant of 15 ms due to the resistance…

A: a. 1.579Ω b. 0.0398 secExplanation:

Q: es of 2.0 Ω, 4.0 Ω, and 6.0 Ω and a 24-V emf device are all in p

A: GivenResistances of 2.0 Ω, 4.0 Ω, and 6.0 Ω emfV=24 V

Q: Two series capacitors 25.0 µF and 15.0 µF are connected in parallel with a 6.00 µF capacitor. What…

A: Addition of capacitor in series Cseries=1/(1/C1+1/C2) Addition in parallel…

Q: 6.0 μ 3.0 μF 6.0 μ 3.0 μF 400 V Solve for the energy for each capacitor, and the equivalent…

A: Given circuit diagram is shown:

Q: Complete the table below. Voltage SI No (V) Resistance R, Power in R, Current in R, Current in R2…

Q: The circuit shows R= 1 ohm, Emf1= 12.2 V and Emf 2= 7.1 V. What is the power delivered to the 10R…

Q: The voltage acioss the circuit element X shown in Figure will be, if it is a 100 k resistor 20k R2…

A: Given: The resistances in the circuit are. R1=18 kΩR2=20 kΩR3=45 kΩR4=20 kΩRx=100 kΩ The supply…

Q: In a simple electric circuit, Ohm's law states that V = IR, where V is the voltage in volts, I is…

Q: Consider the RC circuit shown in the figure below. If the resistance of the circuit is R=6kQ and the…

A: When pure resistance R in ohm and capacitor C in Farads combine to form a circuit it is called as RC…

Q: Problem # 08 Find the equivalent capacitance between points A and B of the given circuit B 3.5 uF…

A: The equivalent capacitance of the capacitors connected in parallel can be given as, The equivalent…

Q: In a RC circuit with power supply with an emf of 10 V, capacitance 5 µF, and resistance 10000, the…

Q: The current in a series circuit is 21.2 A. When an additional 7.38-Ω resistor is inserted in series,…

Question

100%

An alternating voltage given as; V=100 √2 sin100t is applied to a capacitor of 1µF. Calculate the current
reading on the ammeter.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

An RC (resistor + capacitor) circuit will have an exponential voltage response of the form v(t) = A + B e -t/RC where A and B are constants that express the final voltage and the difference between the initial voltage and the final voltage, respectively. Given R = 10 kΩ and C = 0.1 µF, a starting voltage of 5 Volts and an ending voltage of 0 Volts, what will the voltage be at t = 1 ms? At what time will the voltage be 0.5 Volts?
please I want an answer
A circuit with three resistors is connected in series and in parallel, with a supply DC voltage. The supply is, V = 120 V, and resistors at R1 = 10Ω, R2 = 20Ω, R3 = 30Ω, R4 = 40Ω, and R5 = 19Ω. What is the voltmeter measurement in-between VA and VB, where ΔV = VA-VB, of the circuit (in Volts)? What is the current at R1 (in Amps)?
An RC circuit takes t = 1.58 s to charge to 45% when a voltage of ΔV = 5.5 V is applied. If the circuit has a resistance of R = 1.5 Ω, what is its capacitance, in farads?
V1
Determine the output voltage Vo V₁ = 1.5 V 20 k m 100 k w
In the circuit shown in the figure, the input voltage Vị is 20 V, VBE = 0 and VCE = 0. The values of IB, Ic and ß are given by :- 20V R4 kn R ww 500k2 SO0ka B E
the voltage across a component is given by v = V0e-t/CR. Determine the time taken for voltage v to drop from an initial voltage V0 of 150 volts to 100 volts, if C = 5 x10-6 Farads and R = 40 kW.
5. An electric circuit contains a resistance R and a capacitor C in series, and a battery supplying a time-varying electromotive force (or voltage) V(t). The charge q on the capacitor therefore obeys the following differential equation: Rdq + 2 = V(t). dt Assuming that initially there is no charge on the capacitor, and given that V(t) Vosinut, where V₂ and w are some constants, find the charge on the capacitor as a function of time. = Hint: You may have to do integration by parts twice to evaluate the following inte- gral: feRc sin(wt)dt.
In the circuit diagram R1 = 5R and R2 = 15R, where R = 14 Ω. The power dissipated in resistor 2 is P = 1.6 W. Part (a) What is the voltage across the battery in volts? Part (b) How much power, Ps, is the source supplying, in watts?
In an RC series circuit, ℰ = 15.0 V, R = 2.00 MΩ, and C = 1.80 μF. (a) Calculate the time constant. _____________s(b) Find the maximum charge that will appear on the capacitor during charging. ___________μC(c) How long does it take for the charge to build up to 12.0 μC? ___________s (please show the units when working through the problem so that I can follow it easier)
An ideal battery has an emf of 14.3 V. If it is connected to a circuit and creates a current of 2.18A, what is the power delivered by the battery in units of Watts?