An air-water manometer is connected to either side of a 0.20 m orifice in a 0.30 m water pipe. If the maximum flow rate is 3.4 cu. m per minute, what is the deflection on the manometer? Water temperature is 15 deg C.

Q: The density of pottassium ,which has the BCC structure ,is 0.855 g/cm3.The atomic weight of pottassi...

A:

Q: 17. Hinshelwood and Burk [Proc. Roy. Soc., 106A (284), 1924] have studied the thermal de- compositio...

A: from use of the given table ,For T=10300Cwe have to find order of the reaction and rate constant.   ...

Q: Show your complete solution for each problem. Only the final answer in your calculation should be ro...

A: Given: mass of the automobile, m=3000 Kg Speed of the automobile, V=147 ft/s  

Q: 100 kg of pyrite mineral is burned per hour in a furnace. The composition of this pyrite mineral is ...

A: Given that, The mass of pyrite mineral fed to furnace per hour mF = 100 kg The mass fraction of FeS2...

Q: Material Balance A wet sample of a food product contains 20% moisture. It is required that this wet ...

A: following values are given in the question mass rate of wet solid(m)=1000 Kg/h initial moisture cont...

Q: Air is expanded from 200 psia and 500°F to 100 psia and 50°F. Assuming constant specific heat etermi...

A: Let us see what data are given : Initial Pressure ,P1 = 200 psia Initial temperature  , T1  = 500 oF...

Q: Consider a permanent one-dimensional heat conduction on a flat wall of length L = 0.4 m and constant...

A: Solution:

Q: Given the following reduction potentials, calculate the E°cell of an the electrochemical cell descri...

A:

Q: 3. A thermometer with time constant 7 sec and showing a steady temperature of 27 °C is suddenly imme...

A: Dear User, According to our company guidelines , we are allowed to solve only one question out of tw...

Q: 50% by mass NaOH was diluted to 10% by the addition of water. The temperature of the 50% by mass sol...

A: Given: 50% at 65.6 °C by mass NaOH was diluted to 10% at 37.8 °C Enthalpy change by using NaOH/H2O e...

Q: Air with an initially at: P,= 920 kPa, T,= 800 K and V,= 0.13 m³, expands in a reversible adiabatic ...

A: following values are given in the question initial pressure (P1)= 920 KPa temperature(T1)= 800K volu...

Q: Liquid octane (CaH18) enters the combustion chamber of a gas turbine steadily at 1 atm (0.1 MPa) and...

A: Solution:

Q: A balloon of spherical shape 6 m in diameter is filled with hydrogen gas at a pressure of 1 bar abso...

A: Solution: The ballon is of spherical shape and the initial and final dimension of the balloon remain...

Q: A distillation column with a partial reboiler and a total condenser is being used to separate a Xmix...

A: In distillation, the separation is possible only above the minimum reflux ratio .This is lowest refl...

Q: A metallic plate, whose external faces are kept at temperatures T1 and T2 by a cooling fluid, has a ...

A: Solution:   The correct answer to the given question is option "A". The explanation of the answer is...

Q: 2. Use the collision theory of gas-phase reactions to calculate the theoretical value of the second-...

A: The objective is to determine the second-order rate constant using collision theory of gases.  The r...

Q: A distillati0n c0lumn separates 10,000 kg/hr 0f a 50% benzene-50% t0luene mixture. The pr0duct D rec...

A: Given Details: Feed Flow Rate, F=10,000 kg/hr composition of feed, benzene, xAF=0.5 Toluene, xBF=0.5...

Q: 1. The reaction ½ 0zc@) + Hzc@) → H20a) is used in fuel cells to produce an electrical current. The ...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: (c) both (a) and (b) (b) moles transferred/(area) (time) (mole/vol) The empli (a) electrolytes Mass ...

A: Multiple choice questions  are given  1. The empirical correlation of Wilke  and chang is recommende...

Q: Hydrogenation of benzene to cyclohexane in aqueous solution conducted at 1 atm and 27°C. Three react...

A: Introduction Benzene undergoes catalytic hydrogenation in presence of platinum to give cyclohexane....

Q: BCC lithium has a lattice parameter of 3.5089x 10-8 cm  and contains one vacancy per 200 unit cells....

A: Given data : Lattice parameters (a) = 3.5089 ×10-8 cm No of unit cell in one vacancy per unit cell (...

Q: A reaction has the following stoichiometry, A + 2B €> C, A + C <→ D. The initial mixture consisted o...

A: The Given reactions are. A+2B↔C                                  ...... (1) A+C↔D                   ...

Q: 3. Air is compressed by an adiabatic compressor from 95 kPa and 27°C to 600 kPa and 277°C. Assuming ...

A: By using data table of Air we find specific enthalpies and reduced pressure for further calculation ...

Q: Differentiate petroleum ether and sulfuric ether in terms of composition

A: To answer the three given questions in one sentence each

Q: A metal having a cubic structure has a density of 2.6 g/cm3 ,an atomic weight of 87.62 g/mol,and lat...

A:

Q: 1. Coal gasification consists of the chemical transformation of solid coal into gas. The heating val...

A: Given Process-Solid coal to gas by coal gasification HHV=29770 kJ/kg Data- Component % C 71 H...

Q: 3. Calculate the following for 64ZN (actual mass = 63.9291amu): (a) mass deficiency in amu/atom; (b)...

A: d) The nuclear binding energy is given as follows: BE = ∆mc2 64Zn contains 30 electrons, 30 protons,...

Q: Based on the figure below: One thousand kilograms per hour of a mixture containing equal parts by ma...

A:

Q: DAB, eff is always DAB (a) >1 (b) <1 (c) 1 (d) none of High pressure and low temperature favours (a)...

A: Dear user, according to our company guidelines we are authorized to solve only 3 parts . kindly repo...

Q: |H20 300 F 10000 Ib/hr 20% KNO3 EVAPORATOR | м 50% KNO3 R 100 F 0.6 Ib KNO3 I Ib H20 CRYSTALLIZER 4%...

A: Given that 

Q: Why is extraction a useful technique in organic chemistry? When could extraction not be used to isol...

A: It is to be mentioned why extraction is a useful technique in organic chemistry along with the situa...

Q: In a simple implementation of that emission-control strategy, a gas mixture containing 45 mole% SO2 ...

A: Sulfur is removed in gases by absorption. The absorbent in this process is water. Sulfur is soluble ...

Q: 100, Сво 200, А + B > R + S, XA 3D 0.8. Given a gaseous feed, CA0 Find XB, CA, Cg.

A:

Q: How can an amorphous powder be converted into crystalline form?

A:

Q: Explain the role of the back surface field in solar cells and how to form a BSF layer in silicon sol...

A: To 1. explain the role of back surface field (BSF) layer in solar cells 2.  how to form a BSF layer ...

Q: A second-order, gas phase reaction (2A→B) is carried out isothermally in a constant-pressure and a c...

A: Solution: The correct option is "d" the constant pressure reactor will reach first to 50 % conversio...

Q: The volume of a gaseous mass that is at constant temperature and under a pressure of 740 mm Hg is 5 ...

A: Solution: The answer is 4.05 L. The solution is given below.   We are given the volume of the gas V ...

Q: At 25ºC, 754 mmHg, and 80% relative humidity, a fuel composed of 60% ethane, 20% propane, and 20% me...

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for y...

Q: The irreversible isomerization of n-pentane to i-pentane (A>B) follows an elementary rate law and th...

A: Given: τ (s) 14 25 29 30 27 24 25 12 CA0, mol/dm3 200 190 180 170 150 140 120 110 CA, mol/dm3...

Q: (a) A carburising treatment is to be carried out on a component made from a steel with initial conce...

A: Diffusion in solids are occurred with vacancy diffusion and interstitial diffusion. There is also se...

Q: Pure hydrogen gas travels across a 7 mm thick vulcanised neoprene rubber slab at a pressure of 202.6...

A: Given data: Thickness of rubber slab = 7 mm Pressure of hydrogen gas= 202.65 kPa Temperature = 300 K...

Q: Make a detailed flowchart with unknowns Make a detailed degree of freedom analysis on spray chamber ...

A: To calculate the unknowns in a system and the process to be solvable the only condition is DOF to be...

Q: moisture is removed from a food using oven drying m method. the total mass of the final dried produc...

A: Given: Moisture removed from food using oven drying method.    

Q: was producad 10 tons of concentrate a single flotation process lead (Pb) in the form of tons of ore ...

A: To find The amount of PbS discarded in the flotation process to concentrate Pb 

Q: 3. Calculate the enthalpy and entropy changes of iron in the FCC structure when it is brought, witho...

A:

Q: Which among the following statements is FALSE for crystallization processes? a. The dissolution of ...

A: (a) The dissolution of common minerals releases heat, causing the solvent to cool. So, option (a) is...

Q: The homogeneous liquid phase reaction A + B -> C is carried out in a tank series consisting of three...

A: Given that, Reaction: A + B → C Velocity expression -rA = kCA2 Velocity constant k = 4×10-3 m3kmol.s...

Q: 1. Explain the application of Controllers in Chemical Industries with an example ?   2.Discuss in ...

A: Hello Subscriber! There are multiple questions posted. As per our policy, we have solved the first o...

Q: Calculate the volume fraction and the bulk density of the suspension if 30 micron particles having a...

A: Given that :size =30 micron = 3 x10-5 m ρparticle =2500 kg /m3ρliquid =950 kg /m3

Q: Determine the pilling-bedworth ratio for the following metals and predict the behavior of the oxide ...

A: The Pilling–Bedworth ratio is calculated as follows: Rpb = Moxide ×ρmetal  n× Mmetal ×ρoxide Here, M...