An air vapor mixture has a DB temperature of 30 degrees Celsius and a humidity ratio of 0.015 kg/kg d.a. calculate for two barometric pressures 85 kPaa and 101.325 kPaa: a) The enthalpy b) The dew point temperature

An air vapor mixture has a DB temperature of 30 degrees Celsius and a humidity ratio of 0.015 kg/kg d.a. calculate for two barometric pressures 85 kPaa and 101.325 kPaa: a) The enthalpy b) The dew point temperature

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter40: Typical Operating Conditions

Section: Chapter Questions

Problem 1RQ: The standard design conditions for air-conditioning systems established by the Air-Conditioning,...

See similar textbooks

Related questions

Q: A flywheel rotating at 500 rpm decelerates uniformly at a 3 rad/sec². How many seconds will it take…

Q: Given that the weight density of water is 9810 N/m3, calculate the fluid force (in Newtons) on a…

A: Given data :- weight density = 9810N/m^3 dimension of plate = 1.4m ×1.4 m depth = 2 m find the…

Q: Q2: Can cBN be used in honing stick in single layer configuration?

Q: Q1: How is the size of the abrasive grain chosen?

A: To find :- How the size of a abrasive is choosen

Q: 1: How is the size of the abrasive grain chosen?

Q: An ideal Rankine cycle has a boiler pressure of 8 MPa, a condenser pressure of 0.05 MPa, and the…

Q: C Hot air enters a sheet metal duct located in a basement. Determine the exit temperature and the…

Q: A pinion has a 20 number of teeth. If it drives at a gear ratio of 1:3 determine the number of teeth…

Q: In the figure below, given that: a = 9 mm b= 0.05 m %3D c= 18 mm D= 0.1 m Specific gravity of the…

A: Given data as per the question the specific gravity of manometric fluid =1.27 applying benaullis…

Q: Which statement is FALSE? Laminar flow is described like honey flowing out of a container or lava…

A: INTRODUCTION: For flowing fluids going through the pipeline, the Bernoulli equation can be regarded…

Q: 1. Two short shafts having identical diameters of 35 mm and rotating at 1000 rpm are connected by a…

Q: 2) Determine the maximum torque that can be applied to a hollow circular steel shaft of 100mm…

Q: Steam enters a throttling calorimeter at a pressure of 1.03 MPa. The calorimeter downstream pressure…

Q: In cases that there is a desired flowrate, what design considerations must be specified in the…

A: Given question: In cases that there is a desired flowrate, what design considerations must be…

Q: relation between the heat capacity of a plate (q) and time (t). If the relation between the leachate…

Q: A vertical force F of magnitude 80.0 N is applied to the end of the wrench at point D as shown in…

Q: In a Brayton Cycle air enters the compressor at 101.32 kPa, 32 °C and leaves at a pressure of 808…

Q: 1) What is the minimum diameter of a solid steel shaft that will not twist through more han 3º in a…

Q: What average net thrust must a17-ton airplane have to reach an altitude of 5,000 ft and a speed of…

Q: Given that the weight density of water is 9810 N/m3, calculate the fluid force (in Newtons) on a…

A: Given data :- weight density = 9810 N/m^3 dimension of the plate = 1.1 m× 2.7 m depth = 4 m find the…

Q: 2-5. What are the shear stress and velocity distributions for an incompressible fluid contained…

Q: The refrigerant leaving the .7 compressor follows

A: This question is based on the concept of refrigeration process and refrigeration cycle.

Q: Choose the correct answer The suction pressure of a refrigerant should be as low as possible The…

Q: It is proposed to have carbon dioxide (CO2) gas pass through an uninsulated nozzle. The CO2 is to…

Q: Part A How many grams of ice at -14°C must be added to 712 grams of water that is initially at a…

Q: A reheat steam has 13,850kPa pressure at the turbine inlet and a 2800 kPa reheat pressure, the…

Q: 6 The principal stresses at a point on a plane are O2 = 40 Determine the normal and shear stresses…

Q: 1. Draw the shear and bending-moment diagrams for the beam and loading shown and determine the…

Q: A 1000mm cast iron pulley is fastened to a 112mm shaft by means a 28mm square key 160mm long. The…

A: given data :- shear stress = 200Mpa bearing stress = 660 Mpa length of key = 160 mm width and…

Q: Ex2-The two pumps (n=1800 rpm) each have the following characteristics: h= (100, 90, 80, 60, 40,…

Q: The accuracy of the pressure gauge is always high O True O False

Q: Calculate the mass of combustion products of 20kg diesel fuel oil (C16H30) with 30% excess air.

Q: downward and the ratio of belt tensions on the tight side to slack side for each pulley is 2.5:1.…

Q: State clearly the assumptions made in Lame's theory of thick cylinders. Assuming fundamental formula…

A: We must state the assumptions behind Lame's thick cylinder hypothesis. The fundamental formula for…

Q: * For the cantilever beam shown. find the value of Normal stress due to :axial load at point C 4 KN…

Q: In an experiment, a steel specimen of (15mm) diameter was found to elongate (0.3 mm) in a (250 mm)…

A: Given data:

Q: 1. A complete breakdown of airflow through a compressor is known as: Compressor surge. Compressor…

A: A complete breakdown of airflow through a compressor is known as Compressor surge.

Q: 2-2. Repeat problem 2-1 for flow between very wide or broad parallel plates separated by a distance,…

A: INTRODUCTION: The velocity and shear stress of a fluid flowing in between two parallel plate changes…

Q: For the beam below find the normal stress at sections in point (B) and (C) C D B 75 kN 35 kN 45 kN…

Q: A refrigerator is connected to a generator powered by a fuel with a calorific value of 35000 kJ/kg…

A: A Refrigerator works by pushing refrigerant inside itself which is continuously changing from a…

Q: 5. Bleed air for low pressure turbine cooling is provided by: The combustion chambers. O The turbine…

A: Option (C): The compressor

Q: ɪᴅᴇᴀʟ ɢᴀꜱ ʀᴇꜰʀɪɢᴇʀᴀᴛɪᴏɴ ᴄʏᴄʟᴇ ᴜꜱɪɴɢ ᴀɪʀ ᴀꜱ ᴛʜᴇ ᴡᴏʀᴋɪɴɢ ᴍᴇᴅɪᴜᴍ ɪꜱ ᴛᴏ ᴍᴀɪɴᴛᴀɪɴ ᴀ ʀᴇꜰʀɪɢᴇʀᴀᴛᴇᴅ ꜱᴘᴀᴄᴇ ᴀᴛ…

Q: CONSIDER A GLASS WINDOW OF 1-2m2 WIH A THICKNESS WITH AN AREA OF Bmm AND THERMAL CONDUCTIVITH OF…

A: Answer: (a) The rate of heat transfer through this glass window is 266.16 W. (b) The temperature of…

Q: Member BC rotates at a constant angulan The line of action of the normal compone The acceleration of…

A: Option second is correct. The line of action of normal component of relative acceleration of point B…

Q: 01: For the beam ABCD subjected to the loading shown in figure below (B intemal hinge): (1) draw the…

Q: For the cantilever beam shown. find the value of Flexural stress at point :E due to the 4 KN load 4…

A: Maximum bending moment,Mmax=40kNm Y for Point E =0 Flexural stress at E,=M*y/I=0

Q: 5) Compute the value of EI y at the right end of the overhanging beam shown 1000 lb 400 lb/ft 6 ft 4…

Q: A 20 degree full-depth involute tooth gear has a addendum of 5/16 inch. Determine the working depth.

Q: To make the 3d sketch for each of the frames which contain the views in the plan

Q: A cylindrical tank of radius 5 ft and height 9 ft is two-thirds filled with a liquid of weight…

A: Given Radius, R = 5 ft Height, h = 9 ft Density = 62.4 lbs/ft3 Find Work required, W

Question

An air vapor mixture has a DB temperature of 30 degrees Celsius and a humidity ratio of 0.015
kg/kg d.a. calculate for two barometric pressures 85 kPaa and 101.325 kPaa:
a) The enthalpy
b) The dew point temperature

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Concept:

VIEW

Calculation:

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 8 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Please answer in clear handwriting. a room is at 20-degree Celsius and have a relative humidity of 50 % and is heated to 50 degrees Celcius with a heater that has a flow rate of 50 m ^3 per minute we have to maintain the relative humidity of 50% DetermineA) Q dot heater in KJ/minB) mass flow rate of water in teaspoon/min.Consider 1 teaspoon as 25mlNote:Solve it properly by mass energy balance Equation
Fifty gallons per minute of water enters a cooling tower at 115°F. Atmospheric air at 60°Fand 55% relative humidity enters the tower at 6,000 cfm and leaves at 90°F saturated.Determine:A.) The volume of water that leaves the tower in gpm. B.) The exit temperature of water, °F
Plz solve all parts Air in a vegetable storage room is at 5°C dry bulb temperature and 1°C dew point temperature. a) Determine the following properties of the air and show them on a schematic drawing of the psychrometric chart: absolute humidity, relative humidity, specific volume, enthalpy, and wet bulb temperature. b) At what temperature will moisture in this air begin to condense as water droplets? c) At what temperature will frost form?
2. The absolute humidity at atmospheric pressure at 40 ° C is 0.011 kg air / kg dry air. Specify: A. Air vapor partial pressure. = AnswerkPa. b. Relative humidity = Answer% c. Dew point temperature. = Answer (° C)
2) In a simple heating process, air enters a duct at a temperature of 10°C, and a relative humidity of 80%. The volumetric flow rate of air is 145 m³/min. Air leaves the duct with a temperature of 30°C. Process takes place at a pressure of 1atm. Determine a) the rate of heat transfer in kJ /min b) the relative humidity at the outlet of the duct. Neglect the changes in kinetic and potential energies.
An air conditioning system operates at a pressure of 1 atm. Heating section and 105 in the system There is an air-conditioning section that provides saturated water vapor at oC. air heating section of 25 m3 at 15 oC and 60 percent relative humidity / min with volumetric flow enters and leaves the humidification section at 25 oC and 50 percent relative humidity. a) When leaving the heater section temperature and relative humidity of the air find out b) The heat transfer in the heating section calculate [kJ/minute] c) Water added in the humidification section calculate the flow rate [ kg/min]
The absolute humidity at atmospheric pressure at 25 ° C is 0.011 kg water / kg dry air. Specify: a. partial pressure of water vapor = Answer kPa b. relative humidity = Answer% c. Dew point temperature = Answer (° C)
v Question Completion Status: QUESTION 11 50 kg of Refrigerant R134 are in the state of Saturated mixture at a pressure of P1a180 kpa. The quality x is equal to 0.2. It undergoes an expansion process to a superheated state of Py- 140 KPa and a temperature Ta-30°C. a) What is the initial temperature of the mixture. b) use the quality x to find the specific volume vy of the mixture (so called vavg) and the total volume Vy. Find the specific enthalpy of the mixture hy and conclude the total enthalpy H. d) Find the variation of enthalpy AH-H,-H, between the two states. e) Find the variation of volume between the two states.
HELP ME ASAP PLS Consider: Relative Humidity at 1500m, in % Round to one (1) decimal place 6. Estimate the vapor pressure, air pressure, relative humidity, and air density at a height of 1800 m into the atmosphere. The total pressure is 101 kPa, air temperature is 25°C and the dew point temperature is 15°C near the ground, the lapse rate 7.5°C/km, which is constant for both air temperature and dew point temperature. The gas constant R is 287 J/kg-K and constant with respect to altitude.
1. A sample of gas A evaporates over water in a dosed system. What Is the pressure of gas A in kg/m2 if the total pressure Is 780 torr and water vapor pressure Is 1 atm?
A space at sea level has a dry bulb temperature of 70 °F and 50% RH. Find the following in that space: a) WB temperature, b) Absolute Humidity, c) vapor pressure, d) enthalpy, e) specific volume, and f) dew point.
For Cairo Egypt in January the average 40 W/m? temperature_ is 14°C. relative humidity is 65%, and wind speed is 2.0 mis measured @ a 'ncight of 2.0 m. Compute the 3. net radiation is evaporation rate by a) energy deroğynamic Combined d) Priestley-Taylor Meth od