An air-conditioning system involves the mixing of cold air and warm outdoor air before the mixture is routed to the conditioned room in steady operation. Cold air enters the mixing chamber at 7°C and 105 kPa at a rate of 0.55 m3 /s while warm air enters at 34°C and 105 kPa. The air leaves the room at 24°C. The ratio of the mass flow rates of the hot to cold airstreams is 1.6. Using variable specific heats, determine the mixture temperature at the inlet of the room.

Q: An adiabatic air compressor is to be powered by a direct-coupled adiabatic steam turbine that is…

A: Given Data:

Q: In a food processing industry, steam and water are mixed to produce a continuous supply of hot…

A: Given data: m1=13 kg/sh1=50 kJ/kgm2=2 kg/sh2=2670 kJ/kgQloss=780 W Need to determine the temperature…

Q: Air enters the compressor of a gas-turbine plant at ambient conditions of 100 kPa and 30°C with a…

A: Given Information:For air compressor

Q: Air enters the compressor of a gas-turbine plant at ambient conditions of 100 kPa and 25°C with a…

A: Given data: Here fluid being compressed is air.

Q: Q5 (a) Air enters an adiabatic compressor at 100 kPa and 17°C at a rate of 2.4 m/s, and it exits at…

A:

Q: Consider the turbocharger of an internal combustion engine. The exhaust gases enter the turbine at…

A: Given data At turbine inlet At turbine exit At compressor inlet At compressor exit

Q: In steam power plants, open feedwater heaters are frequently utilized to heat the feedwater by…

A: Pressure at which open feedwater heater operates = 1200 kPaThe temperature of feed water = 50oCThe…

Q: Steam enters an isentropic turbine at 4 MPa. X percent (by mass) of the steam exits the turbine at…

A:

Q: Steam at 100 psia and 650F is expanded adiabatically in a closed system to 10 psia. Determine the…

A: Given data as per question Steam pressure at entry= 100 psia Temperature = 650 F Steam pressure at…

Q: Water at 20 psia and 50F enters a mixing chamber at a rate of 300 lbm/min where it is mixed steadily…

A: There are two inlets and an outlet in the mixing chamber of the system. As the mass crosses the…

Q: An inventor claims to have invented an adiabatic steady-flow device with a single inlet-outlet that…

A:

Q: Q3: Steam enters an adiabatic turbine at 8 MPa, 550°C, and 15 m/s and leaves at 60 kPa, 150°C, and…

A: At state 1 P1=8MPa T1=550°C C1=13 m/s Using the superheated steam table h1=3521KJ/Kg S1=6.8778…

Q: An air-conditioning system involves the mixing of cold air and warm outdoor air before the mixture…

A: Given Chamber inlet temperature = 7 C Chamber inlet pressure = 105 kPa Mass flow rate = 0.55 m3/s…

Q: Air enters an adiabatic nozzle steadily at 300 Kpa, 200 °C and 30 m's then leaves at 100 Kpa and 180…

A:

Q: Steam enters an adiabatic turbine steadily at 5 MPa and 500 °C and leaves at 100 kPa and 200 °C. The…

A:

Q: 3. Air enters the compressor of a gas-turbine plant at ambient conditions of 100 kPa and 25°C with a…

A:

Q: Air is compressed by an adiabatic compressor from 95 kPa and 27°C to 600 kPa and 277°C. Assuming…

A:

Q: Consider that 1 kg of air has a 21.7 kJ decrease of internal energy while its temperature is reduced…

A:

Q: Air enters the compressor of a gas-turbine plant at ambient conditions of 100 kPa and 25°C with a…

A: Given data: Inlet temperature of air, T1 = 250C = 298 K Exit temperature of air, T2 = 3470C = 620 K…

Q: Air enters the compressor of a gas-turbine plant at ambient conditions of 100 kPa and 25°C with a…

A:

Q: What is the minimum internal energy that steam can achieve as it is expanded adiabatically in a…

A: Given: The initial pressure of the steam, P1 = 1500 kPa The final pressure of the steam, P2 = 100…

Q: Question attached

A: Given Data Initial pressure is: P1=20 kPa Final pressure is: P2=2 MPa Final temperature is:…

Q: In an open system, 500 kg/h of air is being compressed from 100 kPa at  280 K to 600 kPa and 400 K.…

A:

Q: Liquid water at 200 kPa and 20 degress celcius is heated in a chamber by mixing it with superheated…

A: Draw the schematic diagram of the mixing chamber as shown in Figure (1).

Q: 300 kPa and 20 ºC water is heated in a mixing room with 300kPa pressure and 300 ºC steam. If the…

A:

Q: Air enters the compressor of a gas-turbine plant at ambient conditions of 100 kPa and 25°C with a…

A: The initial conditionsP1=100KPaT1=25°C=298K°V1=0m/s since lgiun as low velocityh1=298.2 KJ/kgThe…

Q: For the special case of adiabatic mixing, show that the exit volume flow rate is the sum of the two…

A: Let us consider a two inlet stream and one outlet stream The enthalpy at the inlet section (1) is h1…

Q: Air enters the compressor of a gas turbine plant at ambient conditions of 100 kPa and 25 ⁰C with a…

A: ANSWER MASS FLOWRATE 0.808 Kg/s   Solution is given below.

Q: A water stream at 1 MPa and 160°C is mixed with another stream at 1 MPa and 300°C. If the mass flow…

A: To solve the given question, energy conservation will be applied. The change in enthalpy of the…

Q: Air is expanded isentropically from 100 psia and 500°F to 20 psia in a closed system. Determine its…

A: We have the following equationT2=T1P2P1k-1kBut here k is unknownfrom table A-2E(b) we get the value…

Q: Air enters the compressor of a gas-turbine plant at ambient conditions of 100 kPa and 25°C with a…

A: given for a compressor,       inlet conditions   h1 = 298.2 KJ/Kg…

Q: An adiabatic open feedwater heater in an electric power plant mixes 0.2 kg/s of steam at 100 kPa and…

A: Given data: The mass flow rate of steam, ms = 0.2 kg/s. The mass flow rate of feed water, mw = 10…

Q: Air enters the compressor of a gas-turbine plant at ambient conditions of 100 kPa and 25°C with a…

A:

Q: Steam at 100 psia and 650°F is expanded adiabatically in a closed system to 10 psia. Determine the…

A: At state 1 P1 = 100 psia T1 = 650°F (from steam table) u1 = 1233.7 Btu/lbm S1 = 1.7816 Btu/lbm-K…

Q: A 0.05-m3 rigid tank initially contains refrigerant134a at 0.8 MPa and 100 percent quality. The tank…

A: At state 1 (Refrigerant-134a table) 0.8Mpa  v1=0.025645 m3/Kg   At state 2 1.2Mpa v2=0.0008935 m3/Kg…

Q: Steam at 3 MPa and 400°C is expanded to 30 kPa in an adiabatic turbine with an isentropic efficiency…

A: Work done can be determined by using Steady flow energy equation Values from steam table at given…

Q: Refrigerant-134a enters an adiabatic compressor as saturated vapor at 100 kPa at a rate of 0.7 m3…

A: The pressure of the saturated vapour at the inlet of the compressor is P1=100 kPa. The volume flow…

Q: Q5 (a) Air enters an adiabatic compressor at 100 kPa and 17°C at a rate of 2.4 m³/s, and it exits at…

A:

Q: Air enters the compressor of a gas turbine plant at ambient conditions of 100 kPa and 25 ⁰C with a…

A:

Q: Air enters the compressor of a gas turbine plant at ambient conditions of 100 kPa and 25 ⁰C with a…

A:

Q: Air enters an adiabatic nozzle steadily at 300 kPa, 200°C, and 30 m/s and leaves at 100 kPa and 180…

A:

Q: Air enters an adiabatic nozzle at 250 kPa and 700 K with a very low velocity and exits at 500 m/s.…

A:

Q: One kg of steam at 1.4MPA is throttled to IMPA at which pressure it is just dry. The steam is then…

A: Solution: a) To find the original dryness fraction Let enthalpy of steam at 1.4MPa = h1 Since the…

Q: Water at 20 psia and 500F enters a mixing chamber at a rate of 7 lbm/s where it is mixed steadily…

A:

Q: A 0.1-m3 rigid tank initially contains refrigerant-134a at 1.2 MPa and 100 percent quality. The tank…

A: Specific volume is defined as the mass of the substance per unit volume. Conservation of mass law…

Q: Argon is heated at 340 K with a mass flow of 3 kg/s while passing through a pipe. Given that the…

A: