Amlyine the slop (reotechaiceut Cross suten 8-B Detyn). s 5. o'5.5, .30 m elay) -15:6-5, r36 0-5 5m

Q: For the beam shown below, will the mass of 4,530 x 10³ g. be sufficient? Why or why not? Explain…

A:

Q: 5.1 The results of a standard Proctor test are given below. Determine the may imum dry unit weight…

A: Note: As per our policy for multiple questions only one question can be solved for other question…

Q: Member AB is an A36 threaded rod, as shown in figure. The load is a service live load. Neglecting…

A: Note:- Hi! Thank you for the question, As per the honor code, we are allowed to answer three…

Q: Consider a large cubic ice block floating in seawater. The specific gravities of ice and seawater…

A:

Q: Example 4: A baker for a large supermarket has received a total of 185 bags of flour from different…

A: a) bags more than 80 pounds is 40 bags  b) i. When interval is 5 pounds, median is 15 ii. When…

Q: Problems 11.1 A rigid foundation is subjected to a vertical column load, P = 355 kN, as shown in…

A:

Q: raw S.F.D and B.M.D

A:

Q: The ground line slopes uniformly at -5.5% from station 40 + 310, which has a center height of 4.50 m…

A:

Q: If the signal phase designation shown below follows the NEMA convention, the value of “a" " and “e"…

A: Brief concept introduction- Signal phase- It is defined as the right-of-way, yellow change, and red…

Q: A cable is attached to a 1.00kg block A, is looped over a fixed peg at C, and is attached to plate…

A: Given -

Q: A circular plate of 2 m diameter is submerged in an oil (poil = 820 kg/m³) with its greatest and…

A:

Q: Standard Proctor compaction curve can be drawn based on Dry density at Moisture content or Dry unit…

A:

Q: If the travel time delay on a signalized intersection approach is 10 sec/veh, the stopped time delay…

A: Generally at any intersection we can have three types of delays which are travel time delay ,…

Q: GL Sand Water table is at ground level Water content = 20% Specific gravity of solids 2.7 Unit…

A: This question is related to the Geotechnical Engineering.

Q: At a certain section of a river the left and right water edges are 3.0 and 45.0 meters respectively…

A: given- Left and right water edges=3 m & 45 m⇒width of the river section b=45-3=42 mLocation of…

Q: 1. A centroid symbol is shown on the shape. Determine if the actual centroid location be above or…

A:

Q: Explain the usage of hazard map.

A: Usage of Hazard Map:-  A hazard map is defined as a map which  highlights the areas that are…

Q: 65 KN/m 25 EN/m 个个

A:

Q: Determine the force (kN) in rod AB caused by the increase in temperature of the system.

A: Coefficient of thermal expansion: - It is the property of material which describes the changes in…

Q: A rectangular scow 12-m long, 7.20m wide, and 2.40m 1.50m above the bottom. It carries a total load…

A:

Q: Two soil specimens with identical geometric dimensions were subjected to falling head permeability…

A:

Q: What conditions produced the best examples of overland flow? What factors may have contributed to…

A: When overland flow occurs on very low  impermeable soils like clay, this is condition produced the…

Q: he flow of a river is 150 cubic feet per second at a site where a 75 feet hydrostatic head can be…

A: step 1-

Q: Ship designers usually construct scale models before building a real ship. The formula that relates…

A:

Q: mil has a compression index of 0.25. It's void ratio at a stress of 10 kN/m2 is 0 kN/m2, then the…

A:

Q: A circle of 150 mm diameter is incribed on a steel plate before it is stressed and then the plate is…

A:

Q: Q 2/ classify the $tames below and determime ' bhe D,e.f A A cp=?

A:

Q: end of compaction, the in-place void ratio was found to be 0.70. If the moisture content of the soil…

A: We will use formula of void ratio.

Q: A .05kg bullet is moving to the right with a speed of 450 m/s when it strikes a 20 kg box that is…

A:

Q: 2. Determine the moment of area of the given structural built-up section composed of a 8"x1" top…

A: Moment of inertia The moment of inertia, also known as the angular mass or rotational inertia, is a…

Q: Stress condition in the Unconfined compression test represents Drained test   Un-drained test…

A:

Q: A square tied column 400 mm by 400 mm is reinforced with 8-20mm diameter bars with fy = 410 MPa.…

A:

Q: 1. Cracks in exterior masonry walls and plaster finishing. A. Unique to landslides  B. Unique to…

A: Answer Landslides occur due to failure of slope or downward movement of mass debris under gravity.…

Q: Compute the immediate def load and live load on the be. Problem 12.3. The uniform supported beam on…

A:

Q: if each square measures 35.04 square meters and A= 9.05m, B=5.8m, C=4.33m, D=9.92m, E=2.73m,…

A:

Q: For a case of plane stress, o. = 40 MN/m², 0, t, ху 80 MN/m2. What are the principal Oy stresses (in…

A:

Q: 30 kN 50 kN to В C D A

A:

Q: m. Assume atmospheric pressure of 101.3 kN/m2 For the siphon shown in figure below, the maximum…

A: For no vaccum PBγw=2mandPC=101.3kNm3vB=vC

Q: PROBLEM NO. 2 A 4.5m simply supported rectangular reinforced concrete beam has a width of 300 mm,…

A:

Q: A disturbed soil sample has a unit weight of 17.88 kN/m3, air content of 17.02% , void ratio of…

A:

Q: Example: The beam is subjected to the concentrated loading shown. Determine the reactions of the…

A:

Q: Explain the Bharkhausen criteria USE DIAGRAMS

A: Bharkhausen criteria- The Barkhausen stabilization process is a mathematical requirement used…

Q: A 100-m tape with a density of 7700 kg/m³ and a cross-sectional area of 2.6 mm? is used to measure a…

A:

Q: Or=150 kPa T=60 kPa D E Oy=90 kPa T=60 kPa 145° A

A:

Q: SITUATION: A liquid limit test conducted on a soil sample in the cup device gave the following…

A:

Q: Ap Wy= 2000 N Support Wc= 2900. tower -L = 30,5 m- SITUATION 02 Two gondolas on a ski lift are…

A:

Q: 3. Neglecting losses, find the discharge in gallon per minute through the venturimeter as shown…

A: from figurePressure head fall=P1γw-P2γw=0.250.25mso,v1A1=v2A2v1=v20.1520.32v1=0.25v2so,

Q: Which of the following doses presents the minimum violation to the OSHA standards? (¿Cual de los…

A: Explanation :        The OSHA ( i.e. Occupational Safety and Health Act ) includes the provisions…

Q: how many sheet of plywoodwill be needed to form the decking

A: The requirement of number of plywood sheets  is calculated by dividing the area to be decked by the…

Q: An elementary triangular concrete gravity dam, supporting 40 m height of reservoir water and full…

A: Minimum width will be maximum value of width obtained from different cases.

British Gravitational Bg System Of Units

Measuring is the comparison of a particular physical quantity with its reference value. A unit is a fixed physical quantity. The length is a physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.