All of the following are NOT included when calculating the usable area of a dwelling to compute the required lighting load, EXCEPT for ____. Select one: a. open porches b. crawl spaces c. unfinished basements d. garages

Q: 17.b. Which of the following is the best example of a building supplied by a single branch circuit?…

A: According to the question we have to discuss about the best example of a building supplied by a…

Q: . Identify and explain the safety procedures and precautions that should be followed for fire…

A: There is always a danger when installing some form of wire or wiring system. If the wires are not…

Q: What is the load for 100 15A/20A, 125v duplex receptacles in a non-dwelling occupancy after applying…

A: NEC Table 220.44 gives demand factor for Non Dwelling receptacle.

Q: What spaces are not included in floor area when calculating the load in volt amperes per square…

A: For calculating the load, first evaluated the total floor area. And according to the NEC , the total…

Q: If multiple grounding connection result in objectionable current, which of the following alteration…

A: Given: If multiple grounding connections result in objectionable current, which of the following…

Q: For installing directly in a concrete slab, (armored cable), (non metallic-sheated cable), (rigid…

A: For installing directly in a concrete slab Rigid metal conduit (RMC) can be used.  A rigid metal…

Q: All single-phase receptacles rated 150V to ground or less, 50A or less and three-phase receptacles…

A: According to NEC 210.8(B), it provides GFCI protection needs for specific receptacles other than…

Q: The frames of ranges, wall-mounted ovens, counter-mounted cooking units, and clothes dryers under…

A: Materials that allow current to flow through them are called conductors. The materials that do not…

Q: Overcurrent devices do not have to be readily accessible if ____. Select one: A. LOCATED WITHIN A…

A: Overcurrent devices do not have to be readily accessible if LOCATED ADJACENT TO THE EQUIPMENT WHERE…

Q: when calculating a dwelling lighting load on the "volt-ampere per ft2" basis, the receptacle load…

A: The dwelling lighting load on the "volt-ampere per ft2" basis is to be calculated for the receptacle…

Q: Which of the following must be notified prior to equipment shutdown for repair? a. Director of…

A: In this question we will write Which must be notified prior to equipment shutdown for repair..

Q: Identify and explain the safety procedures and precautions that should be followed for fire…

A: Safety precautions for fire  prevention - Always Get Ready with the emergency plan Training of…

Q: hat is the receptacle demand load for a 9600 square foot office building with 52 receptacles

A: As per the regulation of national electrical code, a minimum requirement of 180VA must be used for…

Q: rating of a OCPD reads 25 KA as the interrupting capacity of the unit - a short circuit beyond that…

A: In this solution we discuss about shot circuit capacity of CB's.

Q: IS it a requirement to have a light ixture outside the garage door for a vehicle? O No Yes For two…

A:

Q: The minimum working space width in front of service equipment installed in a house must be ______…

A: National Electric Code (NEC) is adoptable standard for the safe Installation of Electric wiring.

Q: 10.a. Which of the following is a condition of the exception that allows the grounded conductor of…

A: According to guidelines we need to solve only first question. According to the question we have to…

Q: The required 125v, 1 ohm, 15A or 20A receptacle on rooftos for heating, air-conditioning and…

A: These equations comes under the class of equipment that needs to be serviced or maintenance.…

Q: analyse the rating of wires/ cables and mcb used for different types of loads

A: A small circuit breaker called an MCB is used to trip when home appliances experience overcurrent…

Q: Lockout is required: During servicing and maintenance where unexpected ener- gization or start-up of…

A: Bartleby has policy to solve only first question and if it has subparts then solve only first 3…

Q: Q.12 What provides branch-circuit protection, and where is it located? Select one: A. BREAKERS…

A: 12.  A fuse is an electrical gadget used to shield the circuit from overcurrent. It comprises a…

Q: Where a building or structure is suplkied by more than one service, or a combination of branch…

A: By National Electrical Code (NEC), Article 225, there were a simple and fair way to install a…

Q: please create a venn diagram using words given in the box to contrast and compare electric motor and…

A: Comparison between electric motors and generators from the given points: Electric Motor…

Q: In selecting the service entrance size, what should be considered?

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: In both exposed and concealed locations, where a cable or raceway-type wiring method is installed…

A:

Q: Receptacles that provide power for a spa or hot tub shall be ________. Select one: a.…

A: According to ARTICLE 680  of National electricity code (NEC), any outlet that supplies a hot tub or…

Q: List the minimum service drop clearances required by the NEC in the following residential…

A: The minimum service drop clearance required by the NEC (120 V/240 V) for the following residential…

Q: 21.Which of the following wiring methods may be used inside the duct used for vapor removal and…

A: 21.  As per the NEC guidelines, no wiring system should be installed in any duct used for vapor…

Q: | True

A: Sequence Local that is we pass a value from one sequence to the next

Q: What is the minimum number of 15-ampere lighting branch circuits required if the dwelling has an…

A: This problem is solved by analysis "National Electrical Code" table data. From the table 220.12 of…

Q: Write a project management report that includes surveying, excavation, groundwater extraction,…

A: The cutoff is essentially a wall built into the foundation with impermeable material to limit the…

Q: What spaces are not included in the floor area when computing the load in volt-amperes per square…

A:

Q: List all the tools and materials for terminating, connecting and testing electrical wiring and…

A:

Q: You're evaluating the components of a multioccupancy building that won't have an on-site employee.…

A: In this question we will write about occupant compliance with NEC....

Q: When installing a surge arrester at the service of less than 1000 volts, the grounding conductor…

A: Equipment Grounding Conductor (EGC) – A conductive path that 's a component of a decent ground-fault…

Q: It is not uncommon for electrical designers to require an equipment grounding conductor to be…

A: True, Because for each and every equipment there is different grounding required according to the…

Q: 18. It's critical to ground-fault protection of equipment system functionality that the _______ be…

A: It's critical to ground-fault protection of equipment system functionality that the  ground…

Q: The house department of Government plants to undertake four housing projects and lists material…

A: Given parameters are: 6800 gallons of paint. 1420000 cubic feet of wood. 64 million bricks. 448000…

Q: The NEC is the only code reference used for electrical installations of all types of occupancies…

A:

Q: INFE242 ELECTRONICS PLEASE MAKE SURE THE ANSWER IS CORRECT i put this course 3 times and all the…

A: Vs = Vi  Vd > 0 diode will turn on    Vd <0 diode wheel turn off . Here we have two diodes…

Q: Please provide Handwritten answer Question: NEC Reference  Answer   __________ __________ _____ is…

A: Although,  Patient equipment grounding point is used ,to the eliminate  the electromagnetic…

Q: A sound level meter is placed in front of a loudspeaker of a 60W audio system reads 70dB. All else…

A: Energy travels from one point to other in the form of vibrations. Sound wave is one such form of the…

Q: When expansion fittings are installed in a run of metallic raceway, the electrical continuity and…

A: Bonding conductor or jumper is a reliable conductor that ensures the required electrical…

Q: If a grounding means does not exist in an electrical outlet, a nongrounding-type receptacle can be…

A:

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.