Air flows from a 5-mm diameter nozzle and it strikes a curved vane, which is in a vertical plane as shown in the picture below. A stagnation tube connected to a water U-tube manometer is located in the free air jet. Determine the horizontal component of the force that the air jet exerts on the vane. Neglect the weight of the air and all friction. Air Stagnation Fixed vane tube 5-mm diam. Open Free air jet 15 cm 45 Water 30⁰

Air flows from a 5-mm diameter nozzle and it strikes a curved vane, which is in a vertical plane as shown in the picture below. A stagnation tube connected to a water U-tube manometer is located in the free air jet. Determine the horizontal component of the force that the air jet exerts on the vane. Neglect the weight of the air and all friction. Air Stagnation Fixed vane tube 5-mm diam. Open Free air jet 15 cm 45 Water 30⁰

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

(3) The cart shown below is restrained from moving by a cable connected to a fixed wall. The tank has a circular cross section of diameter D and the flow exit has a circular cross section of diameter Do. Do not assume that H(t) is constant. The fluid has density p and the exit is open to the atmosphere. Wall H D- Do Cable Vo (1) Determine H(t) and the exit velocity Vo(t). (2) Determine the tension in the cable as a function of time Your answers should be in terms of given parameters (D, Do, p, g) о,
Air flows past a two-dimensional wedge-nosed body as inFig. . Determine the wedge half-angle δ for whichthe horizontal component of the total pressure force on thenose is 35 kN/m of depth into the paper.
Determine the magnitude and direction of the anchoring force needed to hold the horizontal elbow and nozzle combination in place as shown in the Figure Q3 (a) below. Atmospheric pressure is 100 kPa(abs). The gage pressure at section (1) is 100 kPa. At section (2), the water exits to the atmosphere. Q3. (a) 160 mm Section (2) 300 mm Water Section (1) P- 100 kPa V-2 m/s Figure Q3 (a)
Consider the Lockheed SR-71 Blackbird shown in flying at a standard altitude of 25 km. The pressure measured by a Pitot tube on this airplane is 3.88 × 104 N/m2.Calculate the velocity of the airplane.
A jet of water 75 mm in diameter and moving to the right with a velocity of 25 m/s impinges on a flat plate which is moving in the same direction as the jet with a velocity of 10 m/s. What force would the jet exert on the plate?
A horizontal turbulent liquid jet of diameter D and average velocity Vj deflected at the angle by a cane mounted on a cart, this exerting a force on the vane, determine the opposing force needed to keep the plate moving at a constant velocity Vv. Neglect the viscosity and gravity forces.
A sphere and a circular cylinder (with its axis perpendicular to the flow)are mounted in the same freestream. A pressure tap exists at the top of thesphere, and this is connected via a tube to one side of a manometer. Theother side of the manometer is connected to a pressure tap on the surfaceof the cylinder. This tap is located on the cylindrical surface such that nodeflection of the manometer fluid takes place. Calculate the location ofthis tap.
Water flows steadily through a pipe with ID 35 mm. This pipe expands suddenly to an inner diameter of 75 mm and then stays at that diameter. The flow speed in the 35 mm pipe is 32 m/s. The water gage pressure in the thinner pipe is 510 kPa. 1. What is the pressure at the entrance to the thicker section of the pipe? Is the pressure there larger or smaller than in the thin pipe section? 2. What force is acting on the coupling? Is it tension or compression?
3. A semi-cylindrical concrete structure having a radius of 5 m and length of 3 m is rested on ground. Wind (air having a density p=1,2 kg/m3 ) at a free-sream speed of 3 m/s with an atmospheric pressure of 100 kPa far upstream the structure blows over the structure. The air entrance to the structure is at ground level corresponding to the forward stagnation point and the magnitude of minimum pressure is acting on the top of the structure a lift force is generated. Estimate the lift coefficient CL =? with calculated magnitude of lift force from potential flow theory Lütfen birini seçin: а. 2 b. 3 С. 1 d. 12 е. 4
A nozzle that discharges a 60-mm-diameter water jet into the air is on the right end of a horizontal 120-mm- diameter pipe. In the line, the water has a velocity of 4 m/s and a gage pressure of 400 kPa. Find the magnitude and direction of the resultant axial force the water exerts on the nozzle and the head loss in the nozzle.
A jet of water 50mm in diameter with a velocity of 18 m/s strikes a flat plate inclined atan angle of 25° to the axis of the jet. Determine the resultant force exerted on theplate.
If you know that the dynamic temperature of air is 50 K. Then, its speed is