Air at 15 °C flows steadily along a streamline from point (1) to point (2) with negligible viscous effects. The following conditions are measured: at point (1) Z₁ = 3.5 m and p₁ = 0 kPa; at point (2) Z₂ = 10 m, P2 = 21 N/m², and V₂ = 0. Determine the velocity at point (1). For air at 15 °C, p = 1.225 kg/m³.

Air at 15 °C flows steadily along a streamline from point (1) to point (2) with negligible viscous effects. The following conditions are measured: at point (1) Z₁ = 3.5 m and p₁ = 0 kPa; at point (2) Z₂ = 10 m, P2 = 21 N/m², and V₂ = 0. Determine the velocity at point (1). For air at 15 °C, p = 1.225 kg/m³.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The airduct shown below has a slanted exit, the dimension of which is 2 inch by 3 inch. Air is flowing out of the duct at a velocity of 6 ft/s, 45° to the surface of the exit. Pressure is 1 bar (14.7 psia) and temperature is 60 °F. Please compute • Density of air at this pressure and temperature; • Mass rate-of-flow through the duct; • Momentum rate-of-flow through the duct along the direction of air flow. 3 in. Air flow 6 ft/s 2 in. Side view 45°
I need Correct solution with Explanation.
Air is flowing in a duct with a velocity of 8.12 m/s and static pressure of 3.16 cm of water gauge. The duct diameter is 2.01 m, the barometric pressure 86.4 kPa and the gauge fluid temperature and air temperature are 30°C. What is the total pressure against which the fan will operate in cm of water?
A pipe is horizontal and carries oil that has a viscosity of 0.14 Pa s. The volume flow rate of the oil is 5.3 × 10^-5 m3/s. The length of the pipe is 38 m, and its radius is 0.57 cm. At the output end of the pipe the pressure is atmospheric pressure. What is the absolute pressure at the input end?
solve 20-30 mins i'll give you multiple upvote( handwritten asap)How can I solve the problem below in viscous fluid flow?
The airfl ow underneath an air hockey puck is very complex,especially since the air jets from the air hockey tableimpinge on the underside of the puck at various points nonsymmetrically.A reasonable approximation is that at anygiven time, the gage pressure on the bottom of the puck ishalfway between zero (atmospheric pressure) and the stagnationpressure of the impinging jets. (Stagnation pressureis defined as p0 =1/2ρV2jet . ) ( a ) Find the jet velocity V jetrequired to support an air hockey puck of weight W anddiameter d . Give your answer in terms of W , d , and thedensity ρ of the air. ( b ) For W = 0.05 lbf and d = 2.5 in,estimate the required jet velocity in ft/s.
For a flow in the xy plane, the x component of the velocity is u=3x2y-y3is given. Determine the y component for steady state and incompressible flow. Does this result also apply to unstable, incompressible flow? Why is that? How many possible y components are there? Discuss.
Please answer both questions. These are questions from Fluid Mechanics.
A jet of air having velocity V₁ and cross-sectional area A₁ strikes an inclined plate as shown in the figure. Neglect any effects of viscosity. V₁ (a) Find V₂ and V3 in terms of V₁. Note that the pressure is patm everywhere. (b) Because viscous effects are negligible, there is no way for the air to exert a force on the plate in the tangential (z) direction. Using the coordinate system in the figure, find A₂ and A3 in terms of A₁ and 0. (c) For V₁ = 50 m/s, A₁ = 5 x 10-4 m², and 0 = 60°, find the force required to hold the plate in place. Neglect the weight of the plate. Recall that pair = 1.225 kg/m³.
Question 1. For incompressible flow, the two dimensional stream function is given, Y = 7r² sin(20) + 10 Determine the shear stress at the point r = 4 meter and 0 = T/2 rad. for air.
ASAP