A. Create a logical bus topology B. Limit the distance of a network to a few meters in length C. Are a difficult method to connect network cables D. Operate at the application layer E. Create a physical bus toppin

A. Create a logical bus topology B. Limit the distance of a network to a few meters in length C. Are a difficult method to connect network cables D. Operate at the application layer E. Create a physical bus toppin

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Related questions

Q: Data communication Suppose that the spectrum of a channel is between 8 MHz and 10 MHz, and the…

A: In the realm of data communication, the efficient utilization of available bandwidth is crucial to…

Q: Can anyone explain the OSI transport layer? The OSI model consists of seven layers, the lowest of…

A: Answer is

Q: Describe how difficult reconnection and fault isolation are drawbacks of the Bus topology.

A: Due to this: Describe how difficult reconnection and fault isolation are drawbacks of the Bus…

Q: In terms of computational and memory overhead, do you like asynchronous or synchronous buses? a bus…

A: Buses: Synchronous and asynchronous buses vary in terms of computational and memory overhead.…

Q: .Discuss the relative advantages of point-to-point interconnection compared to bus interconnection.

A: Actually, given question regarding The relative advantages of point-to-point interconnection…

Q: Why is it so important to have a well-defined protocol when working with I/O bus technology?

A: I/O (input/output) bus technology is used in computers to transfer data between the CPU and…

Q: Exactly what is "short stroking," and how does it affect the cost-per-gigabyte of SSDs?

A: Short stroking: The use of short strokes The process of formatting a hard disc drive or a partition…

Q: Describe the two differences between bus topology and star topology?

A: In a bus topology, all devices on the network are connected to a single central cable, called the…

Q: onsider a bus network with two computers connected shown below: -d m- -X m- A В Rate: R1 Mbps…

A: Given : For A : Bandwidth = R1 Mbps Speed = v1 m/s For B : Bandwidth = R2 Mbps Speed = v2 m/s…

Q: When it comes to VO bus technology, what exactly is a protocol, and why is it important?

A: Introduction: A protocol is a signal sent from a sender to a receiver. It is a set of guidelines…

Q: Is serial bus data transmission better or worse than parallel bus transmission?

A: Dear Student, The detailed answer to your question along with required explanation is given below -

Q: 4.: Describe the mechanism used in the CAN protocol to synchronize an incoming bit from a CAN bus.

A: Although the nominal bit rate of the CAN network must be the same across all nodes, actual bit rates…

Q: token bus medium access control technique is used for bus/tree? why?

Q: As a technique of transferring data between computer peripherals A wire routeing system is necessary…

A: Justification: A computer network is a telecommunications network that allows computers to exchange…

Q: What is it about buses that creates such a barrier to communication?

A: Introduction: A bus (short version of the Latin omnibus, and historically sometimes known as a data…

Q: This layer creates a virtual circuit before any data can be sent between the endpoints.

A: The virtual circuit is created by this layer before transmission between two end stations.

Q: 15. Calculate the metric for the following EIGRP network (from R1 to R4) S 0/0/1 G 0/0 S 0/0/1 R1 R2…

A: The metric for the following EIGRP network is as follows.

Q: As a technique of transferring data between computer peripherals A wire routeing system is necessary…

A: Introduction: A computer network, sometimes known as a data network, is a kind of telecommunications…

Q: السؤال 11 The bus signals that the bus has been granted to the DMA controller: الاجابات DMA DMA…

A: السؤال 11 The bus signals that the bus has been granted to the DMA controller: الاجابات DMA…

Q: "Short stroking," and how does it effect the cost per gigabyte of SSDs, is a common term.

A: Answer:

Q: What's the distinction between a point-to-point and a multipoint bus?

A: Introduction Bus: The bus is a collection of wires which is connected to one or more subsystems…

Q: ce of signals used in the Serial Peripheral Interface (SPI)

Q: Describe an I'C bus at the following OSI-compliant levels of detail: a. physical b. data link c.…

A: A synchronous, multi-master, multi-slave, packet switched, single ended, serial computer bus which…

Q: "Short stroking," and how does it effect the cost per gigabyte of SSDs, is a common term

A: Answer:

Q: With respect to computer network interface card, the term 10/100 refers to megabits per second…

A: To explain With respect to computer network interface card, the term 10/100 refers to megabits per…

Q: (i) Consider a transmitter employing sliding window protocol for flow control with a window size set…

A: Propogation delay =Tt= 500ms Transmission delay = Tp = 200*8/20*10^3 = 80 ms For sliding window…

Q: Computer Science Suppose that you had more than 4GByte of data to send and could only afford one…

A: In data transmission, network throughput is the amount of data moved successfully from one place to…

Q: Backbone is the device that connects all of the nodes in a network in a bus architecture. Can you…

A: Given: In a bus design, the backbone is the device that links all of the nodes in a network. Could…

Q: Q2: A gaming device has to transfer a high definition 1280 x 720 x 3 video frame @ 30 frames/sec.…

A: In the world of gaming, smooth and high-quality visuals are essential for an immersive experience.…

Q: Match the following to one or more layers of the OSI model: a. Physical addressing  b.…

A: Solution: a) Physical Addressing = Data Link Layer After creating the frames , the data link layer…

Q: otocol, and why is it important in the realm of th

A: Introduction: Below the describe the protocol and why is it important in real of the I/O bus

Q: For the sake of efficiency, do you favour synchronous or asynchronous buses, and why? A bus that…

A: Buses are the primary communication channels in computer architecture that transfer data between…

Q: (a) For each of the following four networks, discuss the consequences if a Connection fails. a. Six…

Q: Give the following about BUS TOPOLOGY: Advantage Disadvantage When to use?

A: According to the question the bus topology only used for in the small network area and the its cheap…

Q: 2. How many types of addressing can be possible in a computer network?

A: The problem is based on the basics of layers in OSI model.

Q: 42. In asynchronous serial communication the physical layer provides a. start and stop signalling b.…

A: In synchronous serial communication a clock signal is used for communication.

Question

7. Hubs:
A. Create a logical bus topology
B.
Limit the distance of a network to a few meters in length
C. Are a difficult method to connect network cables
D. Operate at the application layer
E. Create a physical bus topology

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

Do research on the following protocols: Can Bus protocol SPI I2C USB and draw the transmission waveform for each when sending the message "DLSU" where each of the four letters are represented by their uppercase ASCII code.
Computer Science Universal Serial Bus (USB) is most commonly used specification to perform the Inter-process Communication (IPC) to establish connection protocols in a portable storage device. (c) Draw a diagram with descriptions of stages to complete the processes involved. Describe the communication connectivity and transmission quality used.
Name three common devices functioning at the Data Link Layer of the OSI model.
Suppose a workstation has an I/O bus speed of 1 Gbps and memory bandwidth of 2 Gbps. Assuming DMA is used to move data in and out of main memory, how many interfaces to 100-Mbps Ethernet links could a switch based on this workstation handle?
2- What are the types of transfers in bus system?
When it comes to VO bus technology, what exactly is a protocol, and why is it so critical?
What kind of bus do you prefer, asynchronous or synchronous, and why?What if there was a bus that never slowed down, no matter the time of day or night? Explain.
Question 3 A backbone is usually a Star Star or Bus Bus Mesh
What is Bus Topology and also tell the drawback of it? handwritten answer please fast