Related questions
Question
A walrus transfers energy by conduction through its blubber at the rate of 150 W when immersed in −1.00ºC water. The walrus’s internal core temperature is 37.0ºC , and it has a surface area of 2.00 m2 . What is the average thickness of its blubber, which has the conductivity of fatty tissues without blood?
Expert Solution
This question has been solved!
Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.
This is a popular solution
Trending nowThis is a popular solution!
Step by stepSolved in 2 steps with 2 images
Knowledge Booster
Similar questions
- For bacteriological testing of water supplies and in medical clinics, samples must routinely be incubated for 24 h at 37°C. A standard constant-temperature bath with electric heating and thermostatic control is not suitable in developing nations without continuously operating electric power lines. Peace Corps volunteer and MIT engineer Amy Smith invented a low-cost, lowmaintenance incubator to fill the need. The device consists of a foam-insulated box containing several packets of a waxy material that melts at 37.0°C, interspersed among tubes, dishes, or bottles containing the test samples and growth medium (food for bacteria). Outside the box, the waxy material is first melted by a stove or solar energy collector. Then it is put into the box to keep the test samples warm as it solidifies. The heat of fusion of the phase-change material is 205 kJ/kg. Model the insulation as a panel with surface area 0.490 m2, thickness 9.50 cm, and conductivity 0.012 0 W/m°C. Assume the exterior…arrow_forwardAn aluminum bar has a cross-section that is 4.37 cm by 6.87 cm and is 2.3 m long. Aluminum has a thermal conductivity of 205 W/m K. If the aluminum bar is used to bridge between ice at 0 °C and boiling water at 100 °C, what is the rate of heat transfer (in W) along the bar?arrow_forwardAssume a person has lungs that can hold V = 5.5 L of air (at 1 atm), and their body temperature is currently T = 35.5° C. a. How many moles of air does the average human have in their lungs when they breath in?arrow_forward
- The active element of a certain laser is made of a glass rod 31.0 cm long and 1.60 cm in diameter. Assume the average coefficient of linear expansion of the glass is equal to 9.00 x 10° (°C). The temperature of the rod increases by 64.0°C. (a) What is the increase in its length? cm (b) What is the increase in its diameter? cm (c) What is the increase in its volume? cmarrow_forwardAn aluminum wire is wrapped in rubber insulation. Both are subject to thermal expansion, with the following coefficients of linear expansion: alphaa=24· 10−6 1/C and alphar=8· 10−5 1/C . If the wire and insulation are the same length of 1.85m at a temperature of20.00°C, what is the difference in length (in MILLIMETERS) between the copper wire and the rubber insulation when heated up to a temperature of 189.00°C? Express a magnitude only (no negatives!). ______mm (MILLIMETERS!)arrow_forwardA classroom has dimensions 8.00 m x 10.00 m x 3.00 m. A 1000 W electric space heater is being used to warm the room from 5.00°C to 20.00°C on a cold morning. If the density of air is 1.29 kg/m°, and the specific heat capacity of air is 1004 J/(kg-K), how long will it take to heat the room? Assume no loss of thermal energy to the surroundings. A) 1.30 minutes B) 241 minutes C) 45.3 minutes O D) 77.7 minutesarrow_forward
- The thermal conductivities of human tissues vary greatly. Fat and skin have conductivities of about 0.20 W/m · K and 0.020 W/m · K respectively, while other tissues inside the body have conductivities of about 0.50 W/m · K. Assume that between the core region of the body and the skin surface lies a skin layer of 1.0 mm, fat layer of 0.50 cm, and 3.2 cm of other tissues. (a) Find the R-factor for each of these layers, and the equivalent R-factor for all layers taken together, retaining two digits. Rskin m2 · K/W Rfat m2 · K/W Rtissue m2 · K/W R m2 · K/W (b) Find the rate of energy loss when the core temperature is 37°C and the exterior temperature is 0°C. Assume that both a protective layer of clothing and an insulating layer of unmoving air are absent, and a body area of 2.0 m2. Warrow_forwardA rod made of glass has a circular cross section with a diameter of 0.1200 m at a temperature of 20 degrees celsius. An aluminum ring has a diameter of 0.1196 m at a temperature of 20 degrees celsius. The coefficients of thermal expansion for glass and aluminum are 9.0 x 10-6 1/K and 24.0 x 10-6 1/K, respectively. At what temperature will the aluminum ring be able to slip over the glass rod? Between 225 and 250 degrees celsius Between 175 and 200 degrees celsius Between 100 and 125 degrees celsius Higher than 300 degrees celsius Between 250 and 275 degrees celsius Between 125 and 150 degrees celsius Between 275 and 300 degrees celsius Between 150 and 200 degrees celsius O Between 200 and 225 degrees celsiusarrow_forwardThe thermal conductivities of human tissues vary greatly. Fat and skin have conductivities of about 0.20 W/m · K and 0.020 W/m · K respectively, while other tissues inside the body have conductivities of about 0.50 W/m · K. Assume that between the core region of the body and the skin surface lies a skin layer of 1.0 mm, fat layer of 0.50 cm, and 3.2 cm of other tissues. (a) Find the R-factor for each of these layers, and the equivalent R-factor for all layers taken together, retaining two digits. Rskin m2 · K/W Rfat m2 · K/W Rtissue m2 · K/W R m2 · K/W (b) Find the rate of energy loss when the core temperature is 37°C and the exterior temperature is 0°C. Assume that both a protective layer of clothing and an insulating layer of unmoving air are absent, and a body area of 2.0 m2. Warrow_forward
arrow_back_ios
arrow_forward_ios